Frigidaire FMV157GS Support Question
Frigidaire FMV157GS Support Question
Find answers below for this question about Frigidaire FMV157GS - Microwave.Need a Frigidaire FMV157GS manual? We have 1 online manual for this item!
Question posted by Pako92659 on January 25th, 2014
No Power. No Display
My microwave won't power on. There's no display at all. Is there a fuse somewhere?
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on January 27th, 2014 7:35 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Hello Pako92659, thank you for your question!
I understand your microwave is inoperable. Let’s try resetting your microwave by either unplugging it or flipping the household circuit breaker off. It is important to wait approximately ten minutes and then turn your microwave on. If resetting the power does not correct the issue, then it could possibly be a few things: faulty fuse, open thermostat, TCO (thermal cutout), magnetron, a bad connection with the control board or a potential wiring failure. Because it could be a number of any one of several underlying causes, I would recommend contacting a professional to properly diagnose and repair your appliance.
Best regards - Chris
Online Outreach Specialist
Related Frigidaire FMV157GS Manual Pages
Installation Instructions - Page 1
... basic mechanical and electrical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to Installer -
7
Installation Instructions
Over the Range Microwave Oven
Questions? Call
1-800-944-9044(US) 1-800-668-4606(Canada)
or Visit our Website at: http://www.frigidaire.com
BEFORE YOU BEGIN
Read these
instructions...
Installation Instructions - Page 2
...-22
A Outside Top Exhaust 12-14
Attach Mounting Plate to Wall 12 Preparation of Top Cabinet 13 Checking for Proper Damper Operation 13 Mount the Microwave Oven ..........13, 14 Adjust the Exhaust Adaptor 14 Connecting Ductwork 14
B Outside Back Exhaust 15-18
Preparing Rear Wall for Outside Back Exhaust 15 Remove Exhaust...
Installation Instructions - Page 3
... the cabinet above the microwave oven.
ampere branch circuit single grounded outlet.
The installer must perform a ground continuity check on the power outlet box before use
The power cord of this 63-...85 pound (28.5-38.5 kg) product, plus additional oven loads of up to the requirements of 113-135 pounds (51.3-61.2 kg). CAUTION: For personal safety, remove house fuse...
Installation Instructions - Page 7
... of obstructions.
• If you are going to vent your microwave oven
to the outside, see Hood Exhaust Section for exhaust duct preparation.
• When installing the microwave oven beneath
smooth, flat cabinets, be careful to follow the instructions on the top cabinet template for power cord clearance.
7 Backsplash
66″ (167.6 cm) or More...
Installation Instructions - Page 8
... plastic bags.
Stud finder - a magnetic device which locates nails. This will be resting in the Styrofoam.
Installation Instructions 1 PLACEMENT OF THE MOUNTING PLATE
A. REMOVING THE MICROWAVE
OVEN FROM THE CARTON/ REMOVING THE MOUNTING PLATE
1 Remove the installation instructions, filters, glass tray and the small hardware bag. Use a hammer to tap lightly across...
Installation Instructions - Page 9
... BE LEVEL. This will keep the microwave level.
1 Measure the inside depth of the front overhang.
2 Draw a horizontal ...front overhang depth. Remove the decorative trim to install the microwave properly and to Cooktop
Plate position-beneath recessed bottom cabinet with front overhang
Mounting Plate with the microwave installation. DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET
Plate ...
Installation Instructions - Page 10
... with a stud, drill a 5⁄8″ hole for wood screws.
ALIGNING THE WALL PLATE
Hole A
Centerline Notches
Draw a Vertical Line on Wall from Center of the microwave. Hole C
Area E
Hole D
1 Draw a vertical line on the wall at the center of the mounting plate to use at holes A, B, C and D (see illustration above/actual...
Installation Instructions - Page 11
...Vertical Duct) B.
Recirculating (Non-Vented Ductless)
NOTE: This microwave is shipped assembled for Outside Top Exhaust (except for kit ... filter is factory installed to that section. Installation Instructions
2 INSTALLATION TYPES (Choose A, B or C)
This microwave oven is designed for adaptation to the following three types of ventilation required for your Owner's Manual for non-vented...
Installation Instructions - Page 12
... mounting plate against the wall and that the plate is properly centered under the cabinet. Attach Mounting Plate to help tighten the bolts.
12 Mount Microwave Oven A5. At least one wood screw must be used to attach the plate to a wall stud.
1 Remove the toggle wings from the wall to Wall...
Installation Instructions - Page 13
....
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it tight throughout Steps 1-3. NOTE: When mounting the microwave oven, thread power cord through , and a cutout large enough for the power cord to keep power cord tight.
Installation Instructions
A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to make adjustments...
Installation Instructions - Page 14
... Bottom Shelf Filler Block
Equivalent to Depth of Cabinet Recess
Self-Aligning Screw
Microwave Oven Top 4 Attach the microwave oven to -Side Adjustment, Slide the Exhaust Adaptor as Needed
A6. Blower Plate
Damper
Back of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.)
1 Extend the house duct...
Installation Instructions - Page 15
... wall, lining up with the
holes previously drilled for the
blower motor and blower plate are securely tightened when they are not pinched. Mount the Microwave Oven
IMPORTANT NOTES:
• Make sure the screws for holes A and B in the wall plate.
• Cut the opening .
Installation Instructions
B OUTSIDE BACK EXHAUST (Horizontal Duct...
Installation Instructions - Page 16
... cabinet. • Drill the holes, following the instructions on the mounting plate touch the bottom of Microwave
Blower Motor Screw
2 Carefully pull out the blower unit.
To use toggle bolts:
Mounting Plate
Spacing for the power cord to the wall using toggle bolts. NOTE: Before tightening toggle bolts and wood screw, make...
Installation Instructions - Page 17
... with the original screw.
Make sure the screw is tight.
9 Attach the exhaust adaptor to the microwave with the screw. Reroute the wires through grooves on rear of microwave oven.
7 Secure the blower unit to the rear of the oven. NOTE: The blower unit exhaust openings should match exhaust openings on other side of...
Installation Instructions - Page 18
... the threads have engaged. (It will be completely tightened later.) Be sure to prevent cutting of oven up against cabinet bottom.
3 Insert a self-aligning screw through outer top cabinet holes. NOTE: When mounting the microwave oven, thread power cord through hole in place against the wall and the top cabinet.)
2 Rotate front of the...
Installation Instructions - Page 19
...hole large enough for Toggles More Than Wall Thickness
Toggle Wings Toggle Bolt
Wall Bolt End
C2. Check Microwave Assembly C4. C1. Pull the plate away from the bolts.
2 Insert the bolts into the ...drilling holes
19 in the wall to Wall C2. Mount the Microwave Oven C6.
To use toggle bolts:
Mounting Plate
Spacing for the power cord to fit through the holes designated to go into the...
Installation Instructions - Page 20
... unit. Installation Instructions
C3.
NOTE: Make sure wires remain routed in a later step. Back of Microwave
4 Remove the screw that fan blade openings are facing toward the front of the unit facing up.
• The microwave oven may be reinstalled in the grooves of the track on the blower frame by pressing and...
Installation Instructions - Page 21
....
NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. NOTE: When mounting the microwave oven, thread power cord through top center cabinet hole. Temporarily secure the oven by pulling cord.
1 Lift microwave, tilt it tight throughout Steps 1-3. IMPORTANT: Do not grip or use the nylon grommet around the...
Installation Instructions - Page 22
... recirculating operation.
1 Remove screws on each screw. See the Owner's Manual packed with the microwave.
4 Install the charcoal filter. INSTALLING THE CHARCOAL FILTER
NOTE: The charcoal filter is factory... and the screws.
6 Close the door. Installation Instructions
C5.
MOUNT THE MICROWAVE OVEN (cont.)
5 Insert 2 self-aligning screws through outer top cabinet holes. Insert mesh-side...
Installation Instructions - Page 23
...6.
Replace house fuse or turn breaker back on.
7.
Ensure proper ground exists before use
23 Read the Owner's Manual. Remove all packing material from the
microwave oven.
3.
ININSSTTARLULCATTIIOONNS
5. OMWANNEURA'SL
2. KEEP INSTALLATION INSTRUCTIONS FOR THE LOCAL INSPECTOR'S
USE. Plug power cord into a dedicated 15- Installation Instructions BEFORE YOU USE YOUR MICROWAVE
1.
to...
Similar Questions
Where Can I Find The Door Lock Assembly On My Frigidaire Microwave Fmv157gs
(Posted by careycloud9 3 years ago)
I Know I Overheated Something And Lost The Power (to The Microwave Only). The
microwave is less than 3 yrs old so I doubt it is the wiring. Is there a way to test if it is a faul...
microwave is less than 3 yrs old so I doubt it is the wiring. Is there a way to test if it is a faul...
(Posted by meyebev 8 years ago)
My Frigidaire Microwave Will Not Ture Off
Hi my Frigidaire microwave modle number fmv157gs will shat down like it is on the light is on the tu...
Hi my Frigidaire microwave modle number fmv157gs will shat down like it is on the light is on the tu...
(Posted by dlanarobinson67 10 years ago)
How To Change The Handle On Microwave
Fmv157gs
(Posted by ljilja12 11 years ago)
The Microwave Quit Working. The Power Is On However The Keypad Does Not Work
The microwave just quit working. we unpluged for a few minutes and then plugged it back in. we check...
The microwave just quit working. we unpluged for a few minutes and then plugged it back in. we check...
(Posted by dchallender03 11 years ago)