Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by kabandul on December 9th, 2013
How To Replace Frigidaire Fex831fso Washer Drive Belt
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on December 12th, 2013 12:30 PM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Hello kabandul, thank you for your post!
When replacing the belt of your Frigidaire laundry center, FEX831FS0 it truly requires the experienced hands of a certified technician. Therefore very limited instructions are available. If your appliance is still in warranty, you may want to check with the manufacturer to determine if there are any professionals in your area who will not only be able to ensure this is the appropriate fix, but may actually save you some cost.
Online Outreach Specialist
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 3
..., hot vs. Individual 15 amp minimum branch circuit fused with clothes dryers. ELECTRICAL REQUIREMENTS
ELECTRIC Laundry Center
NOTE: Do not under any circumstances remove grounding prong from an authorized parts ...connectors with upturned ends or closed loop connectors and marked for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
WATER SUPPLY REQUIREMENTS
Hot and ...
Installation Instructions (All Languages) - Page 4
.... Lint can become caught in a fire hazard. All male duct pipe fittings MUST be expelled into the laundry area.
Do not exhaust dryer into the duct and catch lint to collapse, be exhausted into a chimney,... safe operation of your present system is made up of plastic duct or metal foil duct, replace it must be connected to prevent drafts and the entrance of 90° Turns
EXHAUST DUCT ...
Installation Instructions (All Languages) - Page 5
...
1.Installation MUST conform with local codes, or in the same closet as the Gas laundry center.
3.Your laundry center needs the spacearound it will be exhausted four (4) ways with a maximum slope of ... An exhaust hood positioned to line up , add an 11 inch (27.94 cm) length of 1/2 inch (1.27 cm) pipe.
3.If codes allow, flexible metal tubing may be used... a 90° elbow. C M)
WASHER
60 SQ.
Installation Instructions (All Languages) - Page 6
6
ROUGH-IN DIMENSIONS
16 ¼ IN. (41.27 CM)
12 ½ IN.
(31.75 CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR...¼ IN (104.77 CM) 29 7/16 IN (74.77 CM)
3 ¾ IN. (9.52 CM)
36 1/16IN. (91.60 CM)
27 IN. (68.58CM)
25 ¼ IN. (64.13 CM)
47"
2 ½ IN. (6.35 CM)
1 7/8 IN. (4.76 CM)
4...
Installation Instructions (All Languages) - Page 7
... drain hose and power cord (if equipped). MOBILE HOME INSTALLATION
1.Dryer MUST be retained.
3. Return laundry center to prevent water syphoning.
These clamps form a standpipe to an upright position.
4.
From the back of the washer backsheet.
Carefully move Laundry Center.
2. Rigid metal duct is preferred.
2.If dryer is exhausted through the floor and area beneath...
Installation Instructions (All Languages) - Page 8
...MUST be grounded. The laundry center MUST be properly grounded.
WARNING A U.L. For a grounded cord connected laundry center: 1. ELECTRICAL INSTALLATION
ALL ELECTRIC Laundry Centers
GROUNDING REQUIREMENTS
Non-Canadian ELECTRIC Laundry Center
WARNING The following are specific requirements for electrical current. Electrical shock can result if the laundry center is not attached, the...
Installation Instructions (All Languages) - Page 9
...the green ground screw located above the termial block. Tighten the screws securing the cord restraint firmly against the 4. ELECTRICAL CONNECTIONS FOR A 3-WIRE SYSTEM
ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM
NON-CANADIAN ELECTRIC Laundry Center
1.
Insert a NEMA 10-30 Type SRDT, U.L. GREEN GROUND SCREW
SILVER TERMINAL
NEUTRAL GROUND WIRE
NEUTRAL GROUND WIRE
5.
Tighten the...
Installation Instructions (All Languages) - Page 10
...THREAD OR OVERTIGHTEN THESE CONNECTIONS. NOTE: DO NOT connect the laundry center to ensure the rubber washers are off the ground. gas service without converting the gas ...27 cm) I.D. Run some water from the cabinet. Carefully connect the top inlet hose to ensure the laundry center is resistant to the 3/8 inch (0.96 cm) pipe located on all four legs (no rocking of the washer...
Installation Instructions (All Languages) - Page 11
... does not operate, please review the "Avoid Service Checklist" located in a location near the laundry center for your laundry center, contact the source where you purchased your laundry center.
11. Reinstall the dryer front access panel. REPLACEMENT PARTS
If replacement parts are achieved when all other flammable vapors. Label all joints.
Maximum benefits and enjoyment are...
Complete Owner's Guide (English) - Page 2
...damage to the rubber or plastic parts of fire, electrical shock, or injury to persons when using this laundry center.
Use the laundry center only as toilet cleaners, rust removers, acid or... your dryer. instructed in the laundry center for your laundry center.
If your dryer has a drying rack, always replace the lint screen when finished using the washer, turn on or near children....
Complete Owner's Guide (English) - Page 3
...'t
• To prevent personal injury or damage to the laundry center, the electrical power cord of detergent to the wash tub before operating this washer.
1. Incorrect usage can be damaged. Do not mix chlorine bleach with ammonia or acids such as bras, shoulder pads, hosiery, and belts in a mesh
bag to prevent tangling during washing...
Complete Owner's Guide (English) - Page 4
...firmly together. Pull out the knob to release. For your specific model controls.
9. Replace dispenser in the cycle selector knob and wait about
2-3 minutes for 23 minutes after...
7. Remove the dispenser from cup, put items on some models)
Washing Procedures (continued)
6. Add laundry load to washer.
• Dry load level should not be higher than half the total wash load. • When...
Complete Owner's Guide (English) - Page 5
...water using cold water and bleach safe for fabric. Dye transfer on can label.
Replace towels under stain frequently. Mildew, scorch
Wash with prewash stain remover.
Mustard, tomato...Washing may be impossible to remove solvent. Pretreat or soak with bar soap. Repeat, replacing paper towels frequently. Paint, varnish
WATER BASED: Rinse fabric in their original labeled ...
Complete Owner's Guide (English) - Page 6
... zippers, hooks,
buckles. •Rips, tears and broken threads. •Overloading the washer. •Degradation of detergent,
•Undissolved detergent has left in hot water using water...Incorrect use rust remover safe for fabric. amount of detergent.
•Do not overload washer.
•Not enough detergent.
•Add nonprecipitating water conditioner •Use correct cycle...
Complete Owner's Guide (English) - Page 8
... 5-10 minutes.
•Remove items immediately.
Lint
• Overloading.
• Overdrying causes static
electricity.
•Lint screen not clean when
cycle began.
•Lint is attached to complete drying..... •Use fabric softener in washer or dryer to reduce
static electricity. •Remove items when they are dry, remove the rack and replace the lint screen. When items are...
Complete Owner's Guide (English) - Page 9
... tub.
Dry thoroughly and replace. Turn water faucets off to prevent pressure build-up in place.
• If the dryer drum becomes stained from the washer as soon as the cycle... ml) in the washer.
• Dry the washer top, the area around the lid opening . Excess wrinkling, color transfer, and odors may form on the laundry center. Hazardous fumes or electrical shock could result in...
Complete Owner's Guide (English) - Page 10
...washer through a
complete cycle using detergent.
Do not overload washer. Stop washer and reduce load.
Move laundry center so it corrected by a qualified electrician. Additional floor bracing may not be plugged Make sure plug fits tightly in knob, unplug electrical... washer in a heavy-duty washer. OCCURRENCE
POSSIBLE CAUSE
SOLUTION
WASHER - Call your authorized servicer. Belt buckles...
Complete Owner's Guide (English) - Page 12
... time will not operate. When in wall outlet.
Excessive wrinkling.
Thermal limiter tripped. Replace fuse. Dryer does not have no more than drying on a separate circuit. Exhaust... outside of items.
See Drying Procedures . Exhaust duct must be clogged or restricted. Electric dryer is clogged with lint. circuit.
See Drying Procedures . Insufficient sorting of the ...
Operating Instructions (Operating Instructions) - Page 3
...to wash tub. Cycle Selection
Push in your Laundry Center Owner's Guide. To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT... onto the wash load.
7. LAUNDRY CENTER WASHER OPERATING INSTRUCTIONS
HOT COLD
COLD COLD
WARM COLD
Before Operating Your Washer
Read your Laundry Center Owner's Guide before adding the laundry load. LOAD SIZE
MEDIUM SMALL ...
Operating Instructions (Operating Instructions) - Page 4
... on the fabric care labels.
Warm and cold wash and rinse water temperatures are low.
• Follow proper laundry procedures to move freely.
• Select the appropriate cycle and time for the fiber content and soil level of...remove more water from heavy items such as towels and jeans.
• Operate the washer in the tub for items to avoid rewashing. P/N 134808700 (0610)
Similar Questions
How To Install A Lid Switch On A Frigidaire Washer Fex831fs
(Posted by adamwar 9 years ago)
Manual How To Replace Dryer Belt On Laundry Center Fex831fs2
(Posted by ottorOTISM 10 years ago)
How Do You Replace The Washer Drive Belt On A Whirlpool Model Glet1031cso .
(Posted by grandasusa 11 years ago)
How Do I Replace The Drive Belt On My Frigidare Wasing Machine Model Fws933fs0
(Posted by Anonymous-22291 13 years ago)