Frigidaire AEQ6000ES Support Question
Frigidaire AEQ6000ES Support Question
Find answers below for this question about Frigidaire AEQ6000ES - AffinityTM 5.8 cu. Ft. Dryer.Need a Frigidaire AEQ6000ES manual? We have 4 online manuals for this item!
Question posted by rogertesch on August 22nd, 2010
Lint Duct
need to remove plastic lint filter holder to remove debris trapped down in hole. how do i?
Current Answers
Related Frigidaire AEQ6000ES Manual Pages
Use and Care Manual - Page 2
... or workmanship, or for service calls to repair or replace appliance light bulbs, air filters, water filters, other consumables, or knobs, handles, or other than authorized service companies; Service calls...11. If You Need Service
Keep your appliance.
9. In the USA, your original date of purchase, Electrolux will pay all receipts. Product that have been removed, altered or cannot ...
Use and Care Manual - Page 3
...plastic bags
and pillows that may not have it will be cleaned
approximately every 18 months by the safety alert symbol and the instructions are packed in the surrounding area. An excessive amount of a gas dryer must be removed...unpacked.
A clothes dryer produces combustible lint. The dryer must be preceded by qualified service personnel. Do not stack or place laundry or throw rugs...
Use and Care Manual - Page 4
...remove items when the dryer is equipped with small and medium sized items. • For delicate or very small loads, add 2 lint-free towels for better drying, less wrinkling, and to follow fabric care labels and laundry... door. When the cycle ends, remove items immediately and hang or fold. Insert drying rack into the dryer drum.
Items need room to prevent tangling and for operating...
Use and Care Manual - Page 5
....
low heat for proper tumbling.
• Some "silk-like" fabrics should clean the dryer cabinet interior and exhaust duct. A clothes dryer produces combustible lint.
Common Drying Problems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of Fire - Rinse and rewash. PREVENTIVE MEASURES
• Add a few bath towels to...
Use and Care Manual - Page 6
....
Items left in wall outlet. Follow fabric care label instructions. Always remove foreign objects from the dryer lint screen before drying to prevent scratching and damage to a 208 volt circuit... heat.
SOLUTION
Make sure the plug fits tightly in dryer too long. Check to make sure supply valve is restored.
Exhaust duct requirements have anough air supply to baste a scrap of ...
Technical Data Sheet - Page 1
...or its Envelope in the Product for blocked lint filter, blocked exhaust, air leaks around air duct, broken blower fan blades, worn or loose drum seals, dryer installed in the display.
2.
Too many ...Timeout Fault
The drying time has exceeded program time for 6 seconds to reset control.
Remove wires from control thermistor. If reading is stuck
Fault
closed (active). If good, ...
Technical Data Sheet - Page 2
... motor runs; b. e. When the Cancel key is off . Drying and Cool Down LED's are lit and numbers appear in the display showing moisture sensor readings. d. Dryer will flash.
1 turn:
Drive motor runs; Drying LED is pressed, all the cycle status LED's should light.
After entering the test mode, the cycle selector...
Installation Instructions - Page 2
... vent hood and the ground or any concealed space of the vent system, nor use plastic flexible duct to prevent drafts and the entrance of 4" (10.2 cm) Dia. An accumulation of lint in a garage, it with clothes dryers. The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 type SRDT rated at 240 volt...
Installation Instructions - Page 3
.... cm)
CLOSET DOOR EXHAUST DUCT LOCATING DIMENSIONS
LOCATION OF YOUR DRYER
DO NOT INSTALL YOUR DRYER: 1.
Inches (cm)
SIDES...is not plastic-coated....lint. • Compression or crimping of the gas supply connection to down ) and start
the dryer...dryer needs the space around it will cause an
increase in vent restriction. • Running the exhaust system through your dryer...
Installation Instructions - Page 4
Dryer Installation Dimensions
23¾" (60.33)
Free-Standing & Under Counter
24" (60.96)
... (68.58)
35" (88.90) 34" (86.36)
2.25" (5.72)
inches (cm)
27" (68.58)
Stacked Dryer Installation Dimensions
27" (68.58)
T2T2T2T5i8839oooon..".275c(fccc1r55"hlllo(eee3""7en((aaa4774strr.r136.9odo..2k(703cf)oop63)mobec))nrsa...
Installation Instructions - Page 5
... its left side and remove the foam shipping base.
2. UNPACKING
1. Using a rug, blanket or a piece of the dryer exhaust outlet.
4. This provision is enclosed, the exhaust system MUST terminate outside the enclosure with American National Standard for outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion.
CAN...
Installation Instructions - Page 6
... screws that secure the hinge to the opposite side of the outer door.
2. Close the door.
6 Open the dryer door.
5. Rotate it and install it to the front panel.
3. Remove the two (2) hinge attachment screws and place the inner door assembly on a soft flat surface.
1
2
7
6
5
3
4
6. Rotate and reinstall the hinge and the...
Installation Instructions - Page 7
... be plugged into the power cord entry hole of electrical current this time.
3. or an equipment grounding conductor must be connected to the silver colored center terminal on the back of least resistance for electrical current. ELECTRICAL CONNECTIONSFOR 3-WIRE SYSTEM
NON-CANADIAN ELECTRIC Dryer
1. Remove the screws securing the terminal block access cover...
Installation Instructions - Page 8
...box.
Remove the...dryer (see pages 3 and 4). Plug the power cord into the outlet.
4. Before operating the dryer, make materials inaccessible to the dryer. NOTE: On gas dryers...dryer are needed for your dryer...duct...duct to use them for play. With the dryer in a location near the dryer for a connection. The dryer...for ease of the dryer by a qualified ... carton and plastic bags after servicing...
Operating Instructions - Page 1
...the cycle ends, remove items immediately and hang or fold.
7. Clean the lint screen after the cycle has begun, press Cancel before making another selection will light up in your dryer Owner's Guide before... for about 5 minutes.
The estimated Cool Down time will be remembered each time that lint filter is too small or almost dry, the sensing bars may not detect enough moisture to ...
Operating Instructions - Page 2
...plastic, or similarly textured, rubber-like materials; The load may seem too damp or over -drying, not every dryness level is made. Dryer... changes are available with every cycle. To protect your laundry.
Options To select an option, press Options until the...Fluff/No Heat in any time during Extended Tumble.
To remove the control lock, press Options and Select again.
Status ...
Operating Instructions - Page 3
...
*
Damp Dry
Options
Shrink Guard
Extended Tumble
Signal Volume
*
*
* Factory setting
Available settings
*
*
*
*
*
*
*
*
** Estimated cycle duration is based on normal dryness level and factory settings.
DRYER SETTINGS CHART
AVAILABLE CYCLE SETTINGS -
Similar Questions
Dryer Wont Stay Heated
dryer heats up and then you hear a click in the contro panel and the the dryer stops heating but is ...
dryer heats up and then you hear a click in the contro panel and the the dryer stops heating but is ...
(Posted by debbieloubert 9 years ago)
How Many Cubic In. Or Ft. Is This Dryer. 6.5 Or 7.0 ?
(Posted by chrispowell8 10 years ago)
Hello,i Have A Frigidaire Glgq2152esi Dryer That Spins And Does Not Heat
I have a Frigidaire GLGQ2152ESI gas dryer that spins and doesn't heat. According to the online docs,...
I have a Frigidaire GLGQ2152ESI gas dryer that spins and doesn't heat. According to the online docs,...
(Posted by dkhogan 10 years ago)
How To Remove Air Duct Cover (lint Filter Holder) From Frqe 7000lw0
(Posted by goomaster4 11 years ago)
Affinity Gas Dryer Venting
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
(Posted by schielej 12 years ago)