Frigidaire AEQ6000ES Support Question
Frigidaire AEQ6000ES Support Question
Find answers below for this question about Frigidaire AEQ6000ES - AffinityTM 5.8 cu. Ft. Dryer.Need a Frigidaire AEQ6000ES manual? We have 4 online manuals for this item!
Question posted by dkhogan on May 27th, 2013
Hello,i Have A Frigidaire Glgq2152esi Dryer That Spins And Does Not Heat
I have a Frigidaire GLGQ2152ESI gas dryer that spins and doesn't heat. According to the online docs, there are two in house fuses, where area they and how do I check and change them?
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on May 30th, 2013 10:50 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Good Afternoon dkhogan – That is correct! One thermal fuse is located on the heater housing and the other near the blower housing. Typically, both thermal fuses are closed circuits. One will prevent the dryer from coming on and the other will prevent the motor from turning. However, regrettably, this is not a simple DIY job. Generally, qualified technicians often perform these complicated parts replacements. Usually this type of information is not released to a consumer and very rare to find enough information to do it yourself. If I was in your positioned, I would personally suggest reaching out to a professional to accurately assist with the repair of the part(s).
Online Outreach Specialist
Related Frigidaire AEQ6000ES Manual Pages
Use and Care Manual - Page 2
...is installed, used and maintained in accordance with the provided instructions. Surcharges including...or illustrated are subject to change or add to remote areas, including the state of ...Alaska.
12. Obligations for service calls to any refrigerator or freezer failures.
6. Product that have been removed, altered or cannot be required. Box 212378 Augusta, GA...
Use and Care Manual - Page 3
...with controls.
• Do not install or store the dryer where it checked and reinstalled by the manufacturer of the dryer, lint screen housing and exhaust duct should be connected to a new location, ..., service agency or the gas supplier. Prevent Fire
Do not dry items that could result in accordance with rugs, bedspreads or plastic sheets can result in your dryer has a drying rack, ...
Use and Care Manual - Page 4
...or down. 5. Dryer heat may occur. Check that may permanently set some models) Use the drying rack to illuminate the dryer drum during loading and unloading. Load the dryer. • The...ELECTRIC DRYERS:
DRYER
FUSED 30 AMP 120/240 V OR 120/208 V WALL
CORRECT
DRYER SERVICE
Grounding type wall receptacle
GAS DRYERS:
Do not under any appliance. Drying Rack (some stains. Open the dryer door...
Use and Care Manual - Page 5
... not use any time. Remove the lint and replace the screen. Do not operate the dryer without heat.
• Remove items when they are slightly damp to
cycle began.
• Use... laundry products on collars and cuffs. • Turn items inside out to reduce abrasion.
• Irreversible condition.
• Follow fabric care label directions.
• If shrinking is a concern, check load...
Use and Care Manual - Page 6
... near the dryer. Excessive wrinkling. Dryer is clogged with lint.
Remove items as soon as coins, pins, clips
drum finish. Insufficient sorting of the dryer feels too hot or smells hot.
Follow fabric care label instructions. Scratching or chipping of natural gas (gas models).
or buttons are 2 house fuses in wall outlet.
It may turn but won't heat.
Technical Data Sheet - Page 1
... has not changed in the digit display.
Control NTC Open Control thermistor or its wiring is exited. Heater Fault (no heat, restricted vent, blower fan blade broken or loose, dryer installed in ...Measure voltage across terminals on relay RL2 (heater relay) on gas models, replace electronic control. Check for Qualified Technicians Only. dryer is open . Error Code
E10 E11 E12 E24 E25 E4A
...
Technical Data Sheet - Page 2
...When the Cancel key is pressed, all the cycle status LED's should light. Dryer will be rotated to select the following tests:
Rotate the cycle selector knob clockwise... can now be reset for 6 seconds or disconnect power from dryer. heat source is off . heat source is off . e. c. FUNCTION TEST SEQUENCE
1. heat source is displayed.
6 turns:
Drive motor runs; Control thermistor...
Installation Instructions - Page 2
... laundry area.
Do not screen the exhaust ends of insects and rodents. Explosion hazard. NEMA 10-30R NEMA 14-30R
GAS Dryer
CIRCUIT - Rigid Metal Duct
VENT HOOD TYPE (Preferred)
Louvered
4" (10.2 cm)
60 ft. (18.28 m)
2½" (6.35 cm) 48 ft.(14.63 m)
52 ft. (15.84 m)
40 ft.(12.19 m)
44 ft. (13.41 m)
32 ft. (9.75 m)
32 ft...
Installation Instructions - Page 3
...side of the cabinet or the bottom of the dryer:
• Only the rigid metal duct work should check the exhaust system and vent hood for the full...3/4" (9.5 cm)
GAS SUPPLY REQUIREMENTS
Replace copper connecting pipe that will cause an
increase in the absence of
water column.
The dryer MUST be of 1/2 psig (3.45 kPa).
3
60 sq.
In an area exposed to the dryer. 2. The tubing...
Installation Instructions - Page 4
Dryer Installation Dimensions
23¾" (60.33)
Free-Standing & Under Counter
24" (60.96)
....91)
15/8" (4.13)
Electrical supply on rear of unit
13½" (34.29)
To rear and base exhausts
23/8" (6.03)
Gas supply pipe on rear of unit
27" (68.58)
35" (88.90) 34" (86.36)
2.25" (5.72)
inches (cm)
27" ...
Installation Instructions - Page 5
... ducting that will not support combustion. This dryer MUST be made for Mobile Homes.
The dryer is to the floor. MOBILE HOME INSTALLATION
1. When installing a gas dryer into a mobile home, a provision must be not less than twice the area of cardboard packing to the mobile home structure.
3. Dryer MUST be exhausted outside make up air. Refer...
Installation Instructions - Page 6
DRYER DOOR REVERSAL INSTRUCTIONS
Be sure to the outer door assembly. Rotate it and install it to the front panel.
3. Remove the five screws, 1 thru 5 and .... Reattach the door assemblies in the opposite side of where they were removed.
9. Lift the outer door assembly out of the inner door.
8. Open the dryer door.
5. Remove the hinge cutout plug.
Installation Instructions - Page 7
....
3. NOTE: Dryers operating on 240 volt power supply. Follow the instructions in the cord. Locate the dryer within reach of the receptacle for electrical current. For a grounded, cord-connected dryer: 1. Do not modify plug provided with a licensed electrician if you are in accordance with all local codes and ordinances. For a permanently connected dryer: 1. Check with the...
Installation Instructions - Page 8
... screw securely.
7. Install a U.L.
Thread a U.L. Do not make sure the
dryer area is unpacked. gas service without converting the gas valve. NOTE: Check to 0.96 cm) reducer for proper operation. Before operating the dryer, make a sharp bend or crimp wiring/conductor at the rear of the dryer. Run the dryer through the strain relief.
Destroy the carton and plastic...
Operating Instructions - Page 1
..." in detail. 1. Check that cycle is selected. Select the appropriate cycle and settings for a cycle, it tumbles through heated air. then, while ... when the Signal option is selected in your dryer Owner's Guide. To change the cycle. The signal will beep and the... of installation and electrical voltage or gas pressure can also affect drying time. The dryer uses sensing bars to sense the ...
Operating Instructions - Page 2
....
To protect your laundry. Maximim heat is recommended for each time that may be able to select a dryness level. Low heat is selected.
Note: Using Air Fluff/No Heat in any Auto Dry.... Please check fabric care labels to start or stop the cycle. To change cycles, press Cancel. See the "Dryer Settings Chart" for the desired option flashes, then press Select. Medium heat is required...
Operating Instructions - Page 3
DRYER SETTINGS CHART
AVAILABLE CYCLE SETTINGS - PN 134609300B (0712)
These temperatures,...50 minutes 40 minutes 20 minutes
*
*
*
High Medium
Low
* *
Touch Up 30 minutes
*
Timed Dry 15 to 90 minutes
*
Air Fluff/No Heat
Dryness Level
More Dry
*
Normal Dry
*
*
*
Less Dry
*
Damp Dry
Options
Shrink Guard
Extended Tumble
Signal Volume
*
*
* Factory setting
Available settings...
Similar Questions
Dryer Wont Stay Heated
dryer heats up and then you hear a click in the contro panel and the the dryer stops heating but is ...
dryer heats up and then you hear a click in the contro panel and the the dryer stops heating but is ...
(Posted by debbieloubert 9 years ago)
Frigidaire Affinity
The washer want final spin . And the dryer want get hot.
The washer want final spin . And the dryer want get hot.
(Posted by rileyerik 10 years ago)
Changing House Fuses On Frigidaire Dryer
how do you change the house fuse on the frigidaire fgq332es dryer that controls the heat? the dryer ...
how do you change the house fuse on the frigidaire fgq332es dryer that controls the heat? the dryer ...
(Posted by graham173 11 years ago)
Where Are The 'house Fuses' In The Dryer That I Might Need To Replace?
(Posted by Ginaballina 11 years ago)
Affinity Gas Dryer Venting
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
for the right vent option for gas dryer, is this to right when facing the dryer or from back of drye...
(Posted by schielej 12 years ago)