Emerson LF501EM6F Support Question
Emerson LF501EM6F Support Question
Find answers below for this question about Emerson LF501EM6F.Need a Emerson LF501EM6F manual? We have 2 online manuals for this item!
Question posted by Anonymous-170704 on February 26th, 2022
How Do I Reset The Tv
my tv turns on but shows nothing and the buttons
Current Answers
Answer #1: Posted by Mybookie on February 26th, 2022 10:32 PM
Mybookie
Member since:
February 16th, 2022 Points: 122,510
Member since:
February 16th, 2022 Points: 122,510
- Restart the TV with the remote control.
Press and hold the power button on the remote control for about 5 seconds until the "Power off" message is displayed.
The TV will turn off and then restart automatically after about one minute. - Unplug the AC power cord (mains lead).
If the problem persists after step 1, unplug the TV power cord (mains lead) from the electrical outlet. Then press the power button on the TV and wait for 2 minutes, and plug the power cord (mains lead) back into the electrical outlet.
Your personal settings and data will not be lost after the TV restarts.
Answer #2: Posted by SonuKumar on February 27th, 2022 7:54 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,633,680
Member since:
May 9th, 2021 Points: 16,633,680
Emerson TV factory reset
To run a factory reset, locate the reset button on the connector panel. It's a small, recessed button that requires a pen to hold down. Hold it for 15 to 30 seconds to reset the television. Alternatively, reset from your remote by locating the "Settings," "Advanced Settings" and "Factory Reset" option.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Emerson LF501EM6F Manual Pages
Owner s Manual - Page 4
... the TV onto the Bracket on the wall, allow this apparatus near any way, such as practical.
Funai is not responsible for proper grounding and, in or Turned On....ELECTRIC SERVICE EQUIPMENT POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H)
Wall Mount Bracket Kit Brand
LF501EM6F
SANUS
Model # PLA50B
Screw dimension
M6 x 0.787" (20mm)
• The recommended Wall Mount ...
Owner s Manual - Page 5
...can be done by turning the
equipment off and ...Standard Television Receiving Apparatus, Canada BETS-7 / NTMR-7. Consumer Notice:
This TV has... been set to do so shall void any revision hereto is believed adequate for the intended use radio frequency energy. Portions of Conformity
Trade Name Responsible Party Model Address
Telephone Number
: Emerson : FUNAI CORPORATION, Inc. : LF501EM6F...
Owner s Manual - Page 6
... top or bottom of the Unit. • Depending on your household waste. A falling Unit can be exposed to excessive heat such as the TV screen. To completely turn the Unit on this Unit may be generated if the Unit is placed too close to them.
At the end of its life, specialized...
Owner s Manual - Page 7
...; Closed Caption decoder
Built-in this Owner's Manual. Description refers to:
Digital TV Operation
Cable / NTSC (Analog) TV Operation
● If neither symbol appears, the operation is set to our brand... illustrations
and call our toll free customer support line found on next page.
Model
Quantity
Size
LF501EM6F
8 M4 x 0.472"(12mm)
* Batteries not included, AAA 1.5V x 2 Required. Refer...
Owner s Manual - Page 9
... / Program number. • (DOT) : Use with 0-9 to the previously viewed Channel. Continued on the TV screen.
For example, to enter 2.1, press
PREV.CH : Returns to select Digital channels.
f VOL + /... the current program. g D (MUTE)
Turns the Sound On and Off. Remote Control
j
a
k
b
c
l
d
e f
g
h
m
n
i
9 .English
a B (POWER) Turns the TV On from Standby or Off to Standby. ...
Owner s Manual - Page 10
.... Continued on next page. Control Panel
hgf
* Keys on Rear.Control Keys are located on the Rear side of the TV screen Automatically by detecting your room lighting level.
e B (POWER) Turns the TV On and Off (Standby mode).
g Power On / Standby Indicator (On : no light, Standby : red light)
h Ambient Light Sensor Alters the...
Owner s Manual - Page 11
... on these Devices is connected to a Cable / Satellite Set-top Box via a Coaxial Connection, set the TV to a Cable / Satellite Set-top Box via an HDMI cable, make sure you select the correct Source ...a Set-top Box or inside Antenna.
● To Turn On your area can be susceptible to this Unit, please unplug the RF Coaxial Cable from the TV.
RF cable
IN
IN
OUT
HDMI cable
Set-top Box...
Owner s Manual - Page 15
... selecting a Language for the first time.
● Initial setup menu appears Automatically after you Turn On the Unit, Helpful hints appears.
Location L p. 30
Initial setup
Make sure the antenna...After making All the Necessary Connections, press B to Turn On the Unit.
● It may possibly exceed the limited requirement limit of TV channels will begin :
Make sure the Unit is...
Owner s Manual - Page 16
.... ● Audio only program message will appear on the TV screen after the subchannel broadcast is plugged in, your TV and putting it in Standby mode
TV
* Key on Rear Remote Control
Switching Channels
TV
* Key on Rear Remote Control
16 .English
To Turn the TV On from Standby or Off to mute the sound. ●...
Owner s Manual - Page 17
...the Connected Device and wait a few seconds between TV (DTV or Analog TV) and External Devices when they are connected to the Unit.
1 Turn On the Set-top Box or the Connected ...powerful sound settings for a cinematic experience
Optimized for low Power Consumption
-
Cable / NTSC (Analog) TV Operation
1 Press SAP to display the currently selected Audio mode.
2 While receiving an MTS broadcast,...
Owner s Manual - Page 23
...PIN in order to Complete the Installation. (Default PIN code is 0, 0, 0, 0.) You need to reset or set a PIN code in your PIN. Antenna
Back Antenna Cable
Cable
Or
ANTENNA IN
23 .English
... be able to select the channel again using CH + / -
Otherwise the channel is selected, the TV detects signals supplied by pressing B. ● The PIN Code will rescan all channels. It searches for...
Owner s Manual - Page 25
... are usually noted in order to L p. 24
● If the Unit receives poor quality television signals (mainly when the Analog (NTSC) is received), the captions may contain Errors or there...Unit receives special effects Playback signal (e.g.
Data dropout and Pixelation (for the TV channels and times of Closed Caption shows. I'm pleased to your setting choice made above by Scrolling (max. 4 ...
Owner s Manual - Page 26
...on next page. Picture Sound Setup Features Language USB
Channel lock US movie ratings lock US TV ratings lock Canadian English rating Canadian French rating Region ratings lock Clear region ratings lock Change ...● When you set the highest rating to E, All ratings turn to E Automatically. ● To Block any inappropriate programs, set it to Select Child lock, then press OK.
Owner s Manual - Page 29
... want to select the desired fun-Link devices listed on
This Unit stays in Standby mode. Your connected fun-Link device
On
Turns Off Automatically when the
Unit goes into
Standby mode. Auto TV on the TV screen, then press OK.
fun-Link (HDMI CEC)
This function allows you to Off. This Unit...
Owner s Manual - Page 30
...press OK. Continued on bottom of the Spanish or French menu's, press MENU. Retail
The Unit will be Turned Off using procedure below.
1 Use H I to select E-sticker, then press OK.
2 Use H....
Otherwise, personalized Picture and Sound Settings will not be adjusted through a choice of the TV screen. Bottom
E-sticker is ENERGY STARN qualified. Note(s)
● You must set up with...
Owner s Manual - Page 31
..., "Pause", "Forward" and "Reverse" Do Not Work on , the following 2 settings will turn the picture clockwise by 90 degrees. Video
Go to root folder MOVIE1.avi MOVIE2.avi MOVIE3.avi ...2
3
4
Supported format: motion jpeg, 320 x 240, 30FPS
● To stop the Slide show . to play them back on this TV.
● Progressive JPEG files are Not Supported.
● Only a Motion JPEG file with 19 ...
Owner s Manual - Page 32
... is supported. ● Use only Software Upgrades that supports the ZIP-format (e.g.
Checking your TV.
Picture Sound Setup Features Language USB
Back
Release Version: XXXXXXX_XX_XX_XXXX_XX
Upgrading the Software
You can be... PC, open a web browser and go to Turn the Unit back On.
● The TV starts up with the Installation. Picture Sound Setup Features Language USB
Would you Upgrade...
Owner s Manual - Page 33
... Batteries on the Remote Control. ● Re-insert the Batteries with the current TV screen dialog.
● There is No clock function on this Unit.
●... What should I not watch some kind of the Device's infrared sensor or Turn Off the infrared communication function.
● Connect the RF Coaxial Cable directly ...reset to the ones signifying
the Broadcasting Station's channel number.
Owner s Manual - Page 34
... ● View other TV channels.
The problem might be limited to Reset Itself.
No Color ● View other TV channels. The problem might be limited to see Pixelation on the TV screen.
● Make ...is On but this Owner's Manual for about 1 minute, then Plug the AC Power Cord and turn On the Unit again.
● Check whether the Connection of the Antenna or Cable / Satellite ...
Owner s Manual - Page 35
... discoloration to operate the linked functions between our brand devices with other words, the TV screen is showing set that allows access to locate an Authorized Service Center.
There are several signal ...display.
HDMI (High-Definition Multimedia Interface)
Interface that stands for National Television Systems Committee and the name of the Digital broadcasting standards.
Note: ...
Similar Questions
How To Fix My Tv
When I turn my tv on using the power button it turns on to a blue screen and stays that way no matte...
When I turn my tv on using the power button it turns on to a blue screen and stays that way no matte...
(Posted by Tamiwood420 1 year ago)
My Tv Turns On, Shows The Emerson Logo, Then Another Message For A Second Then T
(Posted by cin29m 2 years ago)
How Do I Connect My Samsung Sound Bar To My Tv Using Hdmi
How do I connect my Samsung sound bar to my tv using hdmi
How do I connect my Samsung sound bar to my tv using hdmi
(Posted by brandonrhine84 2 years ago)
How To Change Clock Time?
How to change the time on the clock on the tv.
How to change the time on the clock on the tv.
(Posted by Kckirkendoll 7 years ago)