Can You Use Two Remote For Tv2 With Dish Network

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BeckiBwithDISH on April 12th, 2014 1:25 PM

This answer was accepted by the poster of the original question.

BeckiBwithDISH

Member since:
December 23rd, 2010

Points: 144,270

1,100
points

I would be happy to help if you are still having this issue! You are able to use a second remote on the TV 2, you just need to program it to the same remote address you have set for TV2 already. The following link gives you instructions on how to do so. Please email me at [email protected] if you have any questions! http://www.mydish.com/support/program-non-922-to-receiver

Becki Barned
DISH Internet Response Team
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Remotes : How To
... information on televisions that now shows the System Info screen. What you setting up an IR or UHF remote? TV2 or UHF is being used in Single mode with specific buttons? Use the green indicator tab remote at the location that may be changed to Single: button on the screen. Select CONTINUE to return to...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... © For 222, 522, 622, 625, 722 and 942: Verify the receiver’s mode is used. TV2 may automatically change channels when one remote is set for additional assistance. Press the channel up button on the remote until all mode lights illuminate. Press and hold the SAT button on the front of the...
Tech Portal : Remotes : Troubleshooting
... (be aware of coax cable with a male F-connector to the UHF remote antenna jack and connect the cable to the remote antenna port (without the antenna connected). Remove the UHF remote antenna located at the back of vertical). Hold the remote control directly up to the UHF antenna using a TV2 IR Converter Kit for this manner.