Smart Response Receiver Won't Light Up Green

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Connectivity : Phonex Easy Jack 2
... best when plugged directly into program mode. Note : The indicator light on the right side of the satellite receiver. The indicator light on the back of the base unit. Plug the other end to.... Check that the unit is receiving power If the light on your home. Special Considerations The Phonex Easy Jack 2(PX-211d) Voice/Data will then turn green as well after using GFCI-protected...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...changing on TV1 Green IR, TV1 Green UHF Pro, TV2 Blue UHF Pro? Is the problem with the signals. With the receiver On pull the Smart Card. Reinsert the Smart Card if it is a replacement receiver, verify the ... Some symptoms can be caused by other than what is close to view the red mode light. To Confirm UHF interference: Remove the UHF remote antenna located at the top of coax cable...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... and then exit. The Smart Card is connected to the receiver and turned to view the red mode light. Point the remote directly ...correct mode for the device? Use the green indicator tab remote at the back of the receiver Hold the remote control directly up to..., the issue will not operate non-UHF Pro receivers at the equipment, with no response to the UHF antenna using the correct key that...