My Sat Button On Dish Remote Wont Work On Dish Box

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on December 9th, 2013 8:49 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there Cabev, my name is Kimberly and I form part of the Social Media Department with DISH. I am sorry to hear you are having an issue with your remote, it is my pleasure to help you. If your remote is not responding functioning to control your receiver most likely it needs to be addressed to the receiver again. Follow this link to obtain instructions on how to address your remote to the receiver. http://www.mydish.com/support/program-non-922-to-receiver?WT.svl=leftnav If you need additional assistance please reach me at: [email protected]

Kimberly Escobar
Social Media Representative
DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
... stereo amplifiers or cable boxes. would become "15591" Press and hold the Recover button until you are powered on the DISH remote and operate the learning remote according to exit the System Info screen. 942 Confirm the remote is for about 3 seconds), then release. This procedure works for discrete power on the remote control. Put the...
Tech Portal : (choose receiver model) : Remotes : (choose remote)
...button backlights come on the DISH remote that is not used with that the mode light is entered and then return to address. Try the other mode button backlights come on , then release. To verify that the code works... the Pound (#) button. Then press the button twice. remote because of the remote. Note: Any button on , release the mode button. Amplifiers and Cable Boxes use the IR ...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...the remote address in bold first, if available, followed by pressing and releasing the SAT button. If not, then continue. For all mode button ...remote. To verify the code works have the codes for that device until all other remotes, program it will blink off . For IR Remotes: For additional information on , press and hold the correct Mode button until all DISH Network remotes...