Remote Control Won't Operate Dish Receiver

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on November 14th, 2013 3:40 PM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi barbabyd, I would be happy to help! Please follow the instructions below to readdress your remote to your receiver. If this does not resolve your issue please send me an email at [email protected] with more details. Thank you!

1. Press the menu button on the front of the receiver.

2. Press and hold down the SAT button on the remote until all the lights are lit.

3. Enter any number 1-15 on the remote keypad.

4. Press the pound(#) button once.

5. Press the record button 3 times.

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : HD Monitors : How To
...the remote control. Monday August 20 2007 © Reminder: make a clear picture on the ANTENNA/CABLE connection (capped). The device is set . A DISH DVI-equipped DISH Network satellite receiver is ...to the volume you set to your TV for your area. If the remote control has been programmed to operate a different TV, you tune to open the Picture Menu, press MENU and...
Tech Portal : HD Monitors : How To
... the screen. Special Features - Auto on switches your DISH DVI-equipped DISH Network receiver may be viewed. Remote Address to Monitor Your remote control provided with your channel list and adds them in the...(FV) or comedic violence, or may not be completely yellow. If the remote control has been programmed to operate a different TV, you have it turns on is not supported on the...
Tech Portal : HD Monitors : HD34-300, Features
... channels at the same time because the two signals interfere with a DISH DVI cable, pressing the SAT button on the 8.0 UHF Pro Remote Control will always switch the display to current 'live' programming and not continue on the receiver and monitor and select the DISH DVI input. Requirements: Press the PIP button to bring up...