I Must Have Pushed Wrong Button On Remote And Now Have Only Snow-how Do I Resolv

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MikeHDISHNetwork on March 12th, 2012 12:26 PM

This answer was accepted by the poster of the original question.

MikeHDISHNetwork

Member since:
December 23rd, 2010

Points: 51,920

1,130
points

Hi my name is Mike Houston a Social Media Representative at DISH. Depending if it is TV1 or TV2 (if it is TV1 it will have a green tab, TV2 will have a blue tab), will determine the channel the TV should be on. Is it an HDTV connected that has the snowy screen? Have you tried putting the TV on channel; 3, or 4, or 60, or 73? Would you send me an e-mail me at; [email protected]. I will provide our link to better assist with Snowy Screen: http://www.mydish.com/support/bbs-screen

Mike Houston DISH Network

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... the code list. Detailed instructions may help you already knows the correct code, readdress the remote using a gray button remote, program it to 000. Press the appropriate Mode button at the top of remote. The light will start with your remote for the equipment comes up the appropriate device on the information page, an IR-to...
Tech Portal : Remotes : How To
.... Check the line of their old receiver. Remote Is Not Recognized Adjust Remote Configuration Resolve Address Conflict Your Remote is not listed on the remote. Power the receiver off of sight to the...contact us or a local independent retailer for this remote. Remote Changes Both TV1 and TV2 Both TV1 and TV2 change to Single: button on the screen. Verify the receivers mode is ...
Tech Portal : Remotes : Troubleshooting
...Remote Is Not Recognized Adjust Remote Configuration Resolve Address Conflict Your Remote is Enabled on TV1 Select RECONFIGURE on the screen. Power the receiver off from the front panel. Use the green indicator tab remote...the Up arrow button on the screen to initiate data transfer. Verify the correct remote for the TV1 or TV2 remote. This will set the remote's address to ...