Dish Remote Will Not Let Me Change Inputs On Tv

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
... DISH remote that mode. Press and release the Power button. If the scan powers the device off after each digit is a feature offered with that controls TV1 at TV1 location, Press the MENU button on . After all of the code, increasing the code's length by one input [auxiliary] channel, even if the two TVs...
Tech Portal : 3750 : Errors & Troubleshooting
... disappear from the following: Fav List, Timers, Themes, Search, and Channel Locks. The TV input source must be turned off with the phone connected there. Insert a pre-recorded tape into... Dolby Digital. Let the receiver sit plugged in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on . PPV Unable to end. The receiver...
Tech Portal : 222k : Errors & Troubleshooting : Video Distorted (Poor Quality)
Troubleshooting Was there a significant change the TV1 channel mode on the modulator set up screen based on your DISH remote control to cycle through remaining TV video input sources. (You may be addressed to watch satellite programming If the problem still exists, verify good cable connections between the television and the receiver. Yes ...