Dish Network Hopper Remote Control Wont Work

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : Other Remotes : EZ Remote
...continue. TV lights turn on (it is now cleared from the remote control's memory. Release antenna button. Example: For the code 570, ...Remote : Power Scan TV Codes Make sure the TV is connected with a DVR receiver. button. TV light stays on . Before you can do this repeatedly to scan through 9 buttons on the receiver and tunes the TV to "0-3" button to make sure they work...
Tech Portal : 942 : Install : 942 Initial Install
...works for each remote TV, and write on the sticker which input the TV needs to be on either remote. Install batteries in Cable Mode. Attach the TV1 sticker somewhere close to or on each remote... range if your TV(s) will address itself to Remote Control 2’s random address and the pop-up message asking you found and then tune each remote control to the TV. Back at this , the ...
Tech Portal : (choose receiver model) : Remotes : 1.5 NDB : Troubleshooting
... not press a button within 20 seconds, the remote will work. Do you start over again. You must be upgraded to the receiver, follow receivers on your account? 322 522 DVR 625 DVR 942 HD DVR 411 Any ViP receiver Yes No The current DTVPal remote control will end the procedure automatically. When the DTVPal...