Dish Remote Volume Wont Work

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on February 13th, 2014 3:12 PM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there Akstuart! My name is Kimberly and I form part of the Social Media Department with DISH. I have listed the steps below to assist with programming the remote to your TV. If you have any other questions, let me know at [email protected]!

Access this link to obtain the code needed to address the remote to the Tv: http://www.mydish.com/support/apps/remotecodes.aspx?WT.svl=leftnav

1.) Press and hold the clear TV button until all mode lights light up.
2.) Release and TV light will be blinking.
3.) Enter code and press #. The TV button should flash 3 times.
4.) Try functions (Volume, Power, etc..) and see if it is working.
5.) If no function, repeat steps 1-4 with another code.

Kimberly Escobar

Social Media Representative

DISH L.L.C

Answer #2: Posted by BusterDoogen on February 4th, 2014 9:15 AM

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,407

100
points

Pull the remotes batteries & replace or re-insert the old ones if you know they are good. Aim the remote directly at the tv screen. if it still won't adjuct the volume, please Call DISH Customer Service: 1-855-318-0572 or 1-888-615-3725 for assistance..

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
... maximum of PAGE UP on the remote control. Press a button on . Release the button. For TV1, the recover feature will only allow the power, mute, and volume buttons to control the TV using... process will not teach the learning remote. 3.0 IR, 3.1 IR, ot 3.2 IR With the desired equipment on the DISH remote that mode. Some codes may not work in the recover process is entered...
Tech Portal : 3750 : Errors & Troubleshooting
... cable between the receiver and VCR, or operator error as being ordered from a low volume or mute setting in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO...receiver was a power surge. Verify a phone line is set up . Trace the phone cord from a working outlet. To test a particular phone jack, take a hard line (non-cordless) phone and plug it ...
Tech Portal : (choose receiver model) : Remotes : 1.5 NDB : Troubleshooting
...The current DTVPal remote control will work. Do you start over ...again. Monday October 06 2008 © If you ONLY have the follow these steps. The DISH Network receiver will also no longer operate the DISH Network receiver. Changing Other Receivers’ Channels To program the DISH Network remote to a new 3.2 remote control. When the DTVPal remote...