My Dish Control Sat Light Wont Go Off

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : Other Remotes : EZ Remote
... the TV Antenna/Cable In on (it is connected with a DVR receiver. Press and hold the button until SAT & Satellite Channel Control button turns on your TV. TV lights turn on . The TV light will flash three times. Volume to change channels on the receiver and tunes the TV to "0-3" Press...
Tech Portal : (choose receiver model) : Remotes : (choose remote)
...digit is not applicable for the 7100/7200 or the 721) SAT button (about three seconds. If the remote still does not operate.... Write down button is valid for the remote, the mode light flashes three times. Use the number buttons to enter the four...TV button down arrow System info will use a single non-DISH Network remote control for all mode button backlights come on , then release. Record...
Tech Portal : Remotes : How To : SAT TV Autotune
... for viewing satellite TV. Program the remote control to change the channel used to operate the TV. Tuesday August 04 2009 © Removing SAT Auto–Tune Press STAR (*), then enter 00. SAT TV Autotune The SAT Auto-Tune feature on newer DISH Network remote controls lets the user program into the remote using...