I Have No Signal What Can I Do

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by DanBwithDishNetwork on December 24th, 2010 8:44 PM

This answer was accepted by the poster of the original question.

DanBwithDishNetwork

Member since:
December 23rd, 2010

Points: 72,970

1,080
points

Hello, Daniel Busa here with Dish Network. Try unplugging the reciever for ten seconds and make sure your cabling from the wall to the reciever is tight.

Daniel Busa
DISH Internet Response Team
[email protected]
3:00PM-11:00PM (MST) Tues-Sat

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : 6.2 : Features
... shows the correct band information: Switch position A - You can use switch position A, otherwise the remote control will send out IR and UHF (not UHF Pro) signals to open the System Information screen. The AUX button blinks three times. Press RECORD on the front panel to the receiver. Write down the address...
Tech Portal : 811
...; Off PPV Downloading PPV Ordering Receiver Locked Up Retrieving Information Service Mode Signal Loss, Intermittent Signal Loss, Low Sluggish / Intermittent Response Software Initial Download Software Upgrading System Info...Channel Issue QAM Local Channel Mapdown Missing Missing Channels Missing Channels QAM No Signal/Unusable Signal (TV) Off-Air Analog Off-Air Color Bars Off-Air Digital Password...
Tech Portal : (choose receiver model) : Remotes : 6.3 : Features
... A position. Press RECORD on the receiver. You can use switch position A, otherwise the remote control will send out IR and UHF (not UHF Pro) signals to open the System Information screen. Use the NUMBER PAD to enter the address you to program the AUX mode button to be in most...