Manual For Remote 6.4 Pro

is it a universal remote ....if so how do i get it to run a vcr ?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MaryBDish on April 2nd, 2013 3:14 PM

This answer was accepted by the poster of the original question.

MaryBDish

Member since:
December 30th, 2010

Points: 627,730

1,100
points

Hi, the 6.4 IR/UHF Pro remote is not a universal remote but it can be programmed to work your VCR. Across the top of the are 4 clear mode buttons. There is one on the right hand side that is marked, VCR/DVD. This is the button you will use to program the remote to your VCR. You will need to find the code for the VCR by manufacturer here:

http://www.mydish.com/support/apps/remotecodes.aspx?WT.svl=gsearch_results

Here are the steps to address the remote to the VCR:

1. Turn the VCR On.
2. Press and hold the clear VCR/DVD Mode button for three seconds until the buttons on top light up. Release the VCR Mode button and it will be flashing.
3. Enter the three-digit code using the buttons on the number pad.
4. Press the pound (#) button under the number 9.

Note: The VCR mode light will flash three times.

Please test the functionality of the remote with the VCR.

Return to Step 2 if the remote is not able to fast forward, rewind, or pause the VCR and try the next 3 digit code on the list.

If you have any issues or additional questions, please feel free to e-mail me directly. Thank you!

Mary Catherine Brady
DISH Internet Response Team
[email protected]
Tuesday-Saturday 2:45pm-11:15pm(MST)

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Equipment : IR-to-UHF Upgrade Kit
.... Look for : 2000, 4000, 5000, 7100/7200, 381, 811, 921, 322, 522, 622, 625, 722 TV2 Parts: (1) IR/UHF universal remote control (1.5) OR (1) IR/UHF Pro universal remote control (8.1) (1) IR/UHF signal converter OR (1) IR/UHF Pro signal converter (1) IR extender cable (1) Batteries and instructions Installation IR-to-UHF Converter: Place converter next to help insure...
Tech Portal : DISH Player-DVR 921 : Receiver Information : Receiver Images
...manually enter a digital over-the-air channel up a timer on DVI-enabled high-definition television monitors. A blinking clock will appear 5 minutes before the timer fires. 120 channels distributed among 4 user defined lists allows you to display programming on the receiver to tell the VCR to a 16:9 HDTV screen. 8.0 UHF Pro Universal Remote...SD). (1) 8.0 UHF Pro Universal Remote (1) Y/Pb/Pr 3-...
Tech Portal : Dish381 : Receiver Information : Receiver Images
...screen Partial Zoom - While channeling up a timer on the receiver to tell the VCR to start recording, automatically tune onto a pre-programmed channel when it and type ...type audio/video outputs (1) Set Y/Pb/Pr Component output (1) TV antenna/cable input, black F-connector (1) 8.0 UHF Pro Universal Remote (1) SVHS Cable (8 ft) (1) Y/Pb/Pr 3-Wire Cable (red, blue, green) (6.5 ft) Monday August 03...