Dell PowerEdge 2600 Support Question
Dell PowerEdge 2600 Support Question
Find answers below for this question about Dell PowerEdge 2600.Need a Dell PowerEdge 2600 manual? We have 12 online manuals for this item!
Question posted by Juvis on October 5th, 2014
Poweredge 2600 Won't Boot Into Cd
The person who posted this question about this Dell product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by MWatDell on October 6th, 2014 12:52 AM
MWatDell
Member since:
November 17th, 2011 Points: 306,490
Member since:
November 17th, 2011 Points: 306,490
Hi Juvis
Have you tried with other known good CD?
If you confirmed that the CD drive is faulty, please go ahead to replace it.
Here's the PE2600 manual for your reference:
ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_poweredge/poweredge-xeo2600_Service%20Manual_en-us.pdf
Hope this helps.
MW@Dell
Related Dell PowerEdge 2600 Manual Pages
Information
Update - Page 4
... used in this document to refer to either potential damage to hardware or loss of Novell Corporation; Reproduction in this text: Dell, the DELL logo, PowerEdge, and Dell OpenManage are registered trademarks of data and tells you make better use of Intel Corporation; is subject to change without the written permission...
Information
Update - Page 5
... SCSI option ROM allows you can include channels from within the SCSI Configuration Utility, which you to set as a boot option in the boot sequence. Select the four channels from the embedded LSI Ultra 320 SCSI controller. Ensure that causes Intel embedded NIC LEDs...Guide for SCSI tape drives; The identification feature works for any Intel add-in NICs installed in the boot order.
Information
Update - Page 6
...mistake can lock up when the reset server command is enabled and one slot on the boot drive by mistake.
NOTE: "Overload"... support.dell.com
RAID Controllers
Installing RAID Controllers
Install Dell™ PowerEdge™ Expandable RAID Controller (PERC) 3/DC and PERC 3/QC ...or a later version) on the Dell OpenManage Server Assistant CD to a shorter bus and only one or more PERC 3/DC or...
Information
Update - Page 8
... internal cache of 1-3-2. www.dell.com | support.dell.com
Compatibility Considerations
Processors
A system board that uses up to the processors so that they will not boot and no error message is now available. The 533-MHz front-side bus processors have 603 pins.
If both processor speeds are installed, the system...
Information
Update - Page 10
A04 2003-2004 Dell Inc
未经 Dell Inc
Dell、 DELL 徽标、 PowerEdge 和 Dell OpenManage 是 Dell Inc Red Hat 是 Red Hat, Inc Intel 和 Xeon 分别是 Intel Corporation Novell 和 NetWare 是 Novell ...
Information
Update - Page 32
A04 2003-2004 Dell Inc
Dell Inc
Dell、DELL ロゴ、PowerEdge Dell OpenManage は Dell Inc Red Hat は Red Hat, Inc Intel は Intel Corporation Xeon は Intel Corporation Novell および NetWare は ...
Information
Update - Page 40
All rights reserved. Dell Inc
Dell, DELL 로고, PowerEdge 및 Dell OpenManage는 Dell Inc Red Hat는 Red Hat, Inc Intel 및 Xeon는 각각 Intel Corporation Novell 및 NetWare는 Novell ...
Microprocessor
Upgrade Installation - Page 9
....
19 Run the system diagnostics to verify that the new microprocessor is stored in the System Setup program. Microprocessor Upgrade Installation Guide
1-5 As the system boots, it detects the presence of the system, the chassis intrusion detector will cause an alert message to their electrical outlets, and turn them on. NOTE...
Installing or Replacing an ERA/O Card - Page 3
... system configuration screens in your User's Guide for complete information about using an ERA/O card, see the remote access controller documentation provided on the documentation CD that came with your System Information Guide for instructions about safety precautions, working inside the system.
Installing or Replacing an ERA/O Card - Page 9
... the bezel.
15 Update the ERA/O card with the latest version of the connector.
12 Connect a network cable to the 10-Mbps server management Ethernet connector on the documentation CD for the location of the ERA/O firmware, available at the Dell Support website at support.dell.com. Installing or Replacing an ERA...
Installing or Replacing an ERA/O Card - Page 47
Embedded Remote Access Option（ERA/O
はじめに
メモ：ERA/O CD ERA/O Web サイト support.jp.dell.com
ERA/O
ERA/O
1 Installation and Troubleshooting Guide Removing the Bezel
2
3 Installation and Troubleshooting Guide Removing the Cover
ERA/O
5-1
Installing or Replacing an ERA/O Card - Page 53
10
a
b SCSI
11 Installation and Troubleshooting Guide Replacing the Cover Ethernet
5-6
12 10 Mbps Ethernet 5-6
図 5-6 Ethernet
Ethernet
13
14
15 Web サイト support.dell.com から ERA/O ERA/O
CD RAC
ERA/O
5-7
Installing
the 1 x 2 SCSI Backplane - Page 42
1 x 2
1
:
2 1x2 3
&
4 &
1 Assembly
2
3
4
& CD-ROM /
CD-ROM /
&
Removing the Bezel Removing the Cover Removing the Front Fan
Installing Drives 5-1
5-2
1 x 2 SCSI
Installing Novell NetWare 5.1 and
Support Pack 5 - Page 1
... operating system and Support Pack 5 using the NetWare 5.1
Network Software CD or the NetWare 5.1 Overlay CD
Preinstallation Requirements
Verify that includes the following drivers. See "Making Driver ... psm4b.exe patch. SCSI driver - This information is included in the Dell OpenManage Server Administrator Compatibility Guide.
www.dell.com | support.dell.com
Installing Novell® NetWare...
Installing Novell NetWare 5.1 and
Support Pack 5 - Page 2
...the NetWare 5.1 Network Software CD or the NetWare 5.1 Overlay CD. NOTE: The NetWare 5.1 Overlay CD contains the latest support packs, but the CD is not supported by Dell OpenManage™ Server Assistant. www.dell.com...Agreement.
3 Create a new boot partition of the system for which you are using either the NetWare 5.1 Network Software CD or the NetWare 5.1 Overlay CD. b To obtain the drivers ...
Installing Novell NetWare 5.1 and
Support Pack 5 - Page 3
...settings where required.
If you are installing the operating system using the NetWare 5.1 Network Software CD, proceed to the next section, "Installing Support Pack 5," after the operating system installation is... to select product options, select Install a product not listed.
5 Type the path to the CD.
9 Continue with this part of the installation is complete.
11 When the GUI part of the...
Similar Questions
