Craftsman 28922 Support Question
Craftsman 28922 Support Question
Find answers below for this question about Craftsman 28922 - YT 3000 21 HP 42" Yard Tractor.Need a Craftsman 28922 manual? We have 1 online manual for this item!
Question posted by cbr0053 on October 2nd, 2012
Is This Model Compatible With The Cyclone Rake?
Info on deck opening size H x W is needed. The cyclone rake is a pull-behind system for leaf and lawn debris removal.
Current Answers
Related Craftsman 28922 Manual Pages
Operation Manual - Page 1
... U.S.A. Visit our Craftsman website:www.sears.com/craftsman
*As rated by the engine manufacturer
424690 Rev. 3 Operator's Manual
1®
LAW TRACTO
21.0 HR* 42" Mower Electric Start Automatic Transmission
Model No. 917.28922
• EspaSol, p. 33
03070
This product has a low emission engine which operates differently from previously built engines.
For answers to your questions...
Operation Manual - Page 2
...and Adjustments 21
Storage
27
Troubleshooting
28
Sears Service Back Cover
Craftsman Riding Equipment Warranty: Lawn Tractors, Garden Tractors, Zero Turn... or repair caused by fuel determined to keep the deck clear of the exterior finishes, or product label replacement... a charge). Normal deterioration and wear of flammable debris, or failure to maintain the riding equipment according ...
Operation Manual - Page 3
..., and remove keys before cleaning the machine, removing the grass...mower to plow leaves or other debris which can cause
build-up to cause cancer and birth defects
or other reproductive harm.
_WARNING: Battery posts, terminals and related accessories contain lead and lead
compounds, chemicals known tothe State of your tractor...opening at the lowest possible speed when on a slope, is dangerous.
Operation Manual - Page 4
.... that may block your view of ignition. • Use only approved gasoline container. • Never remove gas cap or add fuel with safe machine operation.
SERVICE
SAFE HANDLING OF GASOLINE
To avoid personal injury... iV. ment may suddenly appear in speed or direction, which can occur if the operator is an open flame, spark, or pilot light such as on it, do not mow it.
• Mow ...
Operation Manual - Page 5
...Mower blades are sharp. Always look behind before restarting.
• Never make any fuel-soaked de- They may suddenly appear in the mowing area for small children.
• Mow up . • Remove...and use a nozzle lock-open device. • Iffuel is complete.
Check
their proper operation.... If this is clear of a responsible adult other debris build-up and down slowly.
• Do not turn...
Operation Manual - Page 6
... 10% from unexpected
hassle and expense.
CCA: 230
Case size: U1R
45-55 Ft. It has been designed, engineered ... (below 32°F '
W/Filter:
56 oz. Purchase your tractor properly. For prices and additional information call anytime day or night,... is available through your purchase of home appliances, garage door openers, water heaters, and other major home items, in maintaining,...
Operation Manual - Page 7
... handle (A) and pull up, slide seat to raised position. Standard are in Maintenance section of this manual, itmeans when you are listed below.
(1) 3/4" wrench (1) 1/2" wrench (1) Tire pressure
set will make assembly wrench sizes you assemble necessary to insure proper tightness. Remove all four panels
of your tractor must be tightened securely. Remove end panels and...
Operation Manual - Page 8
... level.
/ Fuel tank is clear of this manual). CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly inflatedfor leveling).
/ Check mower and drive belts. Be sure the area in Operation section ofthis manual). 4. Remove banding holding the deflector shield up against tractor.
CHECK BRAKE SYSTEM
After you learn how to operate your...
Operation Manual - Page 9
...PARKING
_ E21 { j.,
BRAKE
MOWER HEIGHT
MOWER LIFT
LIGHTS ON
FUEL
BATTERY
...REVERSE
FORWARD
CRUISE CONTROL
CLUTCH/BRAKE PEDAL
®@®@@
ATTACHMENT CLUTCH DISENGAGED
ATTACHMENT CLUTCH ENGAGED
DANGER, KEEP HANDS AND FEET AWAY
KEEP AREA CLEAR
SLOPE HAZARDS
(SEE SAFETY RULES SECTION)
FREE WHEEL (Automatic Models only)
Failure to the tractor...
Operation Manual - Page 10
...
starting the engine.
(C) PARKING BRAKE- ments mounted to raise and lower the mower or other attach- Allows operation
of mower or other attachments mounted to your tractor.
(F) IGNITION SWITCH - Save this manual for pushing or slowly towing
the tractor with the locations various controls and adjustments. Locks clutch/brake
pedal into the brake position...
Operation Manual - Page 11
...attachment
clutch clutch lever to "STOP" position and remove key. NOTE: Failure to discharge and go dead... CAUTION:
Always stop engine when stopping tractor on grass areas.
To stop mower blades, move throttle control between half and...HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is standing idle with an operator presence sensing switch. Pull parking brake lever (C)...
Operation Manual - Page 12
... lawns, mow often and after moderate growth. • For best cutting performance, grass over 3 inches during hot months.
Start mower blades by the operator to the blade tip with tractor on mowers ... brake. 3. TO ADJUST MOWER CUTTING HEIGHT The position of grass being mowed. • The average lawn should be cut relatively high; Gauge wheels then keep the deck in proper position to ap...
Operation Manual - Page 13
... no longer needed,
turn ignition key
counterclockwise
to
reposition the machine with a Reverse Operation System (ROS).
NOTE: To protect hood from damage when transporting your tractor, be sure...engaged.
USING THE REVERSE SYSTEM -
Raise attachment lift lever to start movement. 5. Pull freewheel control out and into the slot
and release so it is depressed. •...
Operation Manual - Page 14
...need to be used within 30 days to the engine. 1. Be sure freewheel control is on level
ground. 2. Check engine oil with gasoline. Remove...Wipe off any spilled oil or fuel. Be sure the tractor is in cold temperatures (below . 6.
mission engaged position...Never use gasoline near an open flame. Sit on dipstick is reached. NOTE: If at a high altitude (above 3000 feet) or in the ...
Operation Manual - Page 15
... of your transmission require removal for five (5) seconds. with the motion control lever three (3) times. Regulate ground speed by selecting a low enough speed to dry before operating the tractor. 1. Repeat this section of cut . Sitting in the tractor seat, start engine.
Allow grass to give best performance of objects and open - Move lever to...
Operation Manual - Page 16
...Mower Levelness
Check V-Belts Check Engine Oil Level
v'
v'
Change Engine Oil (with maintenance-free battery. Service more often when mowing in this tractor does not cover items that will need...the life of this manual.
• At least once a year you feel they must maintain tractor as instructed in sandy soil. 4 -
Check tire pressure.
4. Replace blades more often when ...
Operation Manual - Page 17
... "GRASS
SIDE" facing the ground. TRACTOR
Always observe safety rules when performing any attempt by turning counterclockwise.
3. gaged position.
Raise mower to highest position to allow access to... cloth.
2.
NOTE: To seal tire punctures and prevent flat tires due to blades. BLADE REMOVAL
1.
Lbs.
CHECK REVERSE SYSTEM
OPERATION
(ROS)
• When the engine is heat
CENTER...
Operation Manual - Page 18
...SL • Be sure tractor is on level surface.
• Oil will result in a suitable container.
1. Be careful not to allow dirt to be kept clean to open or remove caps or covers. Closed and... battery and terminals clean. • Keep battery bolts tight. • Keep small vent holes open , pull out on the battery and terminals can cause the battery to dean fan or transmission
while engine ...
Operation Manual - Page 19
... remove grass, leaves and trash from falling into carburetor. Use compressed air or a leaf blower to prevent engine damage from base.
4. Do not use pressurized air to prevent overheating and
engine damage. Replace pre-cleaner after every 100 hours of your tractor unless the engine and transmission are not to prevent debris from tractor and mower...
Operation Manual - Page 21
... rear lift liks (C) from under tractor.
%
03042tex
21
Have a tight grip on lift lever, lower it slowly and engage in "DISENGAGED" position. 4. Place attachment clutch in lowest position. GAGED" position. 2. Lower attachment lift lever to "STOP" and remove key. 5. Remove clutch cable spring (Q) from rear mower bracket (D) -
Slide mower out from tractor and hook the clutch spring...
Similar Questions
Yt 3000 21 Hp Yard Tractor By Craftsman How To Clean The Carburetor
(Posted by jobyproo 9 years ago)
Yt 3000 Emergency Brake
My tires on my craftsman yt 3000 are stuck and won't turn. Is there an "emergency brake" ?
My tires on my craftsman yt 3000 are stuck and won't turn. Is there an "emergency brake" ?
(Posted by popoweelie 9 years ago)
Craftsman Tractor Yts 3000 Wont Start Backfires
(Posted by consbilla 10 years ago)
Craftsman Riding Lawn Mower Yt 3000 21 Hp 46 Deck Blades Will Not Engage
(Posted by viKgbv 10 years ago)
How To Tighten Belt On A Yt 3000 Riding Mower Mower Deck
(Posted by daHoff 10 years ago)