Craftsman 25cc Support Question
Craftsman 25cc Support Question
Find answers below for this question about Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr.Need a Craftsman 25cc manual? We have 1 online manual for this item!
Question posted by eugeneb966 on October 26th, 2021
Trimmer Head
Part Number for complete trimmer head
Current Answers
Answer #1: Posted by SonuKumar on October 27th, 2021 8:04 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
https://www.searspartsdirect.com/model/3apu26e1k6-000247/craftsman-cmxgtamd25sc-gas-line-trimmer-parts
https://www.ereplacementparts.com/craftsman-358791010-weedwacker-parts-c-158286_187878_272783.html
parts information and buying options as well !!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Craftsman 25cc Manual Pages
Operation Manual - Page 1
OPERATOR'S MANUAL
PROPANE POWERED LINE TRIMMER
16.4 oz Propane Bottle Not Included
TABLE OF CONTENTS
Service and Safety
2
Safe Operation Rule.s
3
Understanding Your Trimme...r
4
Assembly
5
Oil Information
6
Understanding Propan.e
7
Installing the Propane Canist.e..r
8
Installing Attachment.s
9
Starting / Stopping
10
Operation
11
Maintenance
12
...
Operation Manual - Page 2
... a
approved service dealer. Forest Land and in the states of injury to the head, hands and
w
period should be a risk to wear eye protection. At
... equipped with your trimmer prior to use . p
WARNING:
u
WHEN SERVICING, USE ONLY IDENTICAL REPLACEMENTPARTS. SERVICE AND SAFETY
S
LEHR ECO-TRIMMER
IMPORTANT SAFETY INSTRUCTIONS
DU
4-CYCLE PROPANE TRIMMER
READ ALL INSTRUCTION ...
Operation Manual - Page 3
.... The operator and unit must always be in contact with propane canister attached inside a closed room or build -
liquid. Refer...Keep unit clean of
• Do not overreach. SAVE THESE INSTRUCTIONS
LEHR | ALL RIGHTS RESERVED 2008-2009
3 The cutting attachment remains stationary ...artificial light. These are marked as a trimmer. Be in a dry area, locked up or up .
•...
Operation Manual - Page 4
...can cause severe eye injury and hearing loss. UNDERSTANDING YOUR TRIMMER
SAFETY AND INTERNATIONAL SYMBOLS
This operator's manual describes safety and... away from the operating area.
They remain hot for complete safety, assembly, operating and maintenance and repair information.... OTHER OPTIONAL ACCESSORIES MAY BE USED WITH YOUR UNIT
4
LEHR | ALL RIGHTS RESERVED 2008-2009 I
ON/OFF STOP ...
Operation Manual - Page 5
...to the type of shaft and shield that pro vides you the best grip.
4.Tighten the clamp screws evenly, until D-Handle is secure. Do not completely tighten.
3.While holding... the D-Handle (non detachable model). 2.
Shaft Mount
Lower Handle
Fig. 3
CURVED SHAFT TRIMMERS 1. LEHR | ALL RIGHTS RESERVED 2008-2009
5 FOR CURVED SHAFT TRIMMERS Place the cutting attachment shield and spacer against...
Operation Manual - Page 7
... cap to smell it. is completely empty. 5. LEHR | ALL RIGHTS RESERVED 2008-2009
7 Always remove the propane canister from any time the smell of propane is invisible, has no smell and...the naked eye. Overtightening can ignite leaking gas. Turn trimmer o and let cool. 2. Detach cylinder when not in valve area. 2. IN CASE OF FIRE 1. Propane is a combustible gas, it is colorless and thus...
Operation Manual - Page 8
... A PROPANE CANISTER THAT HAS IMPROPER OR DAMAGED THREADS. Screw it . Make sure that the connector is o .
Fig. 9A
Canister Clamp
8
LEHR | ALL RIGHTS RESERVED 2008-2009
WARNING:
PROPANE IS EXTREMELY... Propane canisters or "Bottles" that are behind the guard and latch the canister
CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. to be normal to the trimmer ...
Operation Manual - Page 9
...Unit is upright (propane tank on straight out...Fig. 12).
3. LEHR | ALL RIGHTS RESERVED...trimmer head cut ting attachment) lock the release button of the coupler (Fig. 12). NOTE: Attachments are to tighten (Fig. 11). INSTALLING ATTACHMENTS
INSTALLING CUTTING ATTACHMENTS OR ADD-ONS NOTE: Place the unit on the ground or on a work bench to loosen (Fig. 12).
2. While rmly holding the upper shaft...
Operation Manual - Page 10
... AND SECURE BEFORE STARTING UNIT. Throttle Control Fig. 13
10
LEHR | ALL RIGHTS RESERVED 2008-2009
WARNING:
ALWAYS WEAR EYE, ...trimmer rmly on OFF until the engine warms up the engine for 30 to squeeze the throttle open ame.
Make sure cutting head... sturdy
work surface. When done using the trimmer for the day, disconnect the propane canister from the throttle control. Check the oil...
Operation Manual - Page 11
...(Fig. 16).
30°
Fig. 16
LEHR | ALL RIGHTS RESERVED 2008-2009
11 Rotate the...Slowly move the trimmer into objects such as walls or fence posts HOLDING THE TRIMMER
Fig. 15... inches (200 mm) by tapping the string head on ground to advance string. Move either in...slightly-bent right arm, the operator's right hand is holding the shaft grip.
• The operator's left arm is controlled by working...
Operation Manual - Page 12
.../dipstick when checking and changing the oil
(Fig. 17).
Oil Fill Hole Fig. 18
12
LEHR | ALL RIGHTS RESERVED 2008-2009 If you are unsure about these required maintenance procedures at the ... THE PROPER OIL LEVEL IN THE CRANKCASE. CHECKING THE OIL LEVEL The importance of your trimmer
NOTE: Some maintenance procedures may be overemphasized. Add
Fig. 17
WARNING:
WHEN SERVICING, ...
Operation Manual - Page 13
...the air lter, you will ow freely and carry away more impurities. 1. Allow ample time for complete drainage.
Fig. 21
3. Rinse the lter thoroughly and allow it to lightly coat the lter....operation. It is low, add a small amount of the lter cover.
8. LEHR | ALL RIGHTS RESERVED 2008-2009
13
Remove phillips head screw in air lter cover. Check the level with 1.7 uid oz. (50...
Operation Manual - Page 14
...
2.
REPLACING THE SPARK PLUGS Use a replacement part number NGK CMR6A. Remove the plug after checking the fuel...the air lter is a loss of engine power
Check the spark plug for proper gap ...in . This is 0.02 in the cylinder head. NOTE: The cutting attachment should make carburetor adjustments...Turn the 5/8 in . (0.5 mm)
Fig.23
14
LEHR | ALL RIGHTS RESERVED 2008-2009
ute to Cleaning Air...
Operation Manual - Page 15
When shaft can no longer rotate, loosen head by turning CW (Fig. 29). Hook
Wrap Top CCW
Hook
Hole
Fig.24
Bump Feed Button
Wrap Bottom CCW
Fig. 27
9. Trimmer Head Body
Spring
Reel
Bump Feed Button
Nut
Fig.25
4. Fig.28
10.
LEHR | ALL RIGHT ... it is wound.
6. Un-wind and remove the remnants of line 7.5 ft (2.28 m) long. MAINTENANCE
TRIMMER HEAD LINE INSTALLATION SMALL BUMP FEED...
Operation Manual - Page 16
...rotation of the head (Fig. 33).
Close assembly in sequence as shown for curved shaft and opposite for straight shaft. Top view
Tab "click"
Trimmer Head Body
Fig....trimmer head
body and bottom.
Lock shaft by turning opposite the direction shown in (Fig. 35). Depress tab and twist trimmer head body CW to pull through cover
16
LEHR | ALL RIGHTS RESERVED 2008-2009
Fig.3 7 Trimmer Head...
Operation Manual - Page 17
... nut until snug and install a new cotter pin. NOTE: Inspect the valve to lock the shaft. Engine cover screws
Fig.42
Engine cover screws
LEHR | All Rights Reserved 2008-2009
17
Fig.39
3. Brush Cutter Blade
4.
MAINTENANCE
ll
BRUSH CUTTER...When using the brush cutter blade remove
the bottom shield attachment by using line trimmer head (Fig. 41). Remove in the tool kit (Fig. 39).
Operation Manual - Page 18
Remove the three screws holding the rocker arm cover with a phillips head screwdriver.
7. If this step.
9. Adjusting Screws
Rocker Arm
IF THE CLEARANCE IS ...not true, repeat this statement is set. 3. Jam Nuts
Feeler Gauge Exhaust Valve Intake Valve
Fig.44
18
LEHR | ALL RIGHTS RESERVED 2008-2009 Tighten cover screws evenly until snug.
• The recommended clearance for both...
Operation Manual - Page 19
...transporting. • Secure the unit while transporting. • Remove propane canister.
LEHR | ALL RIGHTS RESERVED 2008-2009
19 LONG TERM STORAGE 1. Remove...CLEAN THE CUTTING ATTACHMENT
DIRTY AIR FILTER ENGINE LACKS POWER OR STALLS WHEN CUTTING CAUSE BAD SPARK PLUG
CLEAN... of the oil from the cylinder before attempting to start the trimmer after storage. 3. Do not use or damage. • ...
Operation Manual - Page 20
... IN)
0.020 INCH (0.5 MM) SAE 10W-30 OIL
1.7 FLUIDOZ. (50mL) PROPANE 16.4OZ CANISTER CHOKE-LESS, ALL-POSITION
AUTO REWIND BAFFLED WITH GUARD SAFETY LOCK WITH MANUAL SPRING RETURN
ALUMINUM TUBE FINGER -TIP TRIGGER
13.1-14.9 LBS BUMP FEED CUTTING HEAD
2.4/3.4 INCHES 0.080 /0.095 INCHES 17 INCHES(431.8 MM)
ALL SPECIFICATIONS ARE...
Operation Manual - Page 21
... LEHR may deny you warranty coverage if your small o -road engine at no cost to you should be completed ... part fails during the warranty period.
If any defective power product or attachment as follows from defects in materials and..., bump knobs, outer spools, inner reels, starter pulley, or rotating head parts that is liable for disallowing a warranty claim. You are responsible...
Similar Questions
Need Parts For My Craftsman Propane Powered Trimmer-
Need a line trimmer cover and intake plate or how can I convert my propane engine to gas?
Need a line trimmer cover and intake plate or how can I convert my propane engine to gas?
(Posted by funkbrew 1 year ago)
How To Remove The Trimmer Head On A Craftsman 4cycle 29cc Curved Shaft Trimmer
(Posted by jcamaar 10 years ago)
How Can I Purchase A Pack Of Fails For My Craftsman Battery Operated Trimmer?
Flails sell for $5.99 for pack of 10 but are not available. Repair stores sell them for $2.10 each...
Flails sell for $5.99 for pack of 10 but are not available. Repair stores sell them for $2.10 each...
(Posted by teeda727 11 years ago)
How Do You Remove Trimmer Head From Craftsman 74545
I need to remove trimmer head to put aftermarket head on. I removed nut cover, but I cannot get nut ...
I need to remove trimmer head to put aftermarket head on. I removed nut cover, but I cannot get nut ...
(Posted by dwbitting 12 years ago)