Home » Craftsman » Lawn & Garden » Craftsman 25cc

Craftsman 25cc Support Question

Find answers below for this question about Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr.
Need a Craftsman 25cc manual? We have 1 online manual for this item!

Craftsman Overview Questions Manuals Reviews Videos Research

Question posted by funkbrew on July 10th, 2022

Need Parts For My Craftsman Propane Powered Trimmer-

Need a line trimmer cover and intake plate or how can I convert my propane engine to gas?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by SonuKumar on July 10th, 2022 8:26 PM

This answer was accepted by the poster of the original question.

SonuKumar

Member since:
May 9th, 2021

Points: 16,621,300

1,100
points

https://www.sears.com/search=craftsman%20weed%20trimmer%20parts

https://www.searspartsdirect.com/combo/0247-1234665/craftsman-line-trimmer-parts

https://www.ereplacementparts.com/craftsman-trimmer-parts-c-158286_187878.html

https://www.repairclinic.com/Shop-For-Parts/a26b317/Craftsman-String-Trimmer-Parts

https://www.partswarehouse.com/Craftsman-Trimmers-s/500686.htm

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Answer #2: Posted by Technoprince123 on July 11th, 2022 12:05 AM

Technoprince123

Member since:
February 8th, 2021

Points: 1,205,190

100
points

https://www.manualslib.com/manual/564377/Craftsman-25cc-Propane-Curved-Shaft-Trimmer-Powered-By-Lehr.html

https://www.ebay.com/p/1102213867

Please response if this answer is acceptable and solw your problem thanks

Related Craftsman 25cc Manual Pages

Operation Manual - Page 1

OPERATOR'S MANUAL PROPANE POWERED LINE TRIMMER 16.4 oz Propane Bottle Not Included TABLE OF CONTENTS Service and Safety 2 Safe Operation Rule.s 3 Understanding Your Trimme...r 4 Assembly 5 Oil Information 6 Understanding Propan.e 7 Installing the Propane Canist.e..r 8 Installing Attachment.s 9 Starting / Stopping 10 Operation 11 Maintenance 12 ...

Operation Manual - Page 2

...unit is factory equipped with your trimmer prior to use metal-reinforced line, wire or rope. PLEASE READ...protection. Replace parts that certain internal combustion engines operated on forest brush and/or grass-covered areas be ...LEHR ECO-TRIMMER IMPORTANT SAFETY INSTRUCTIONS DU 4-CYCLE PROPANE TRIMMER READ ALL INSTRUCTION BEFORE OPERATING • Ne For service call 1-866-941-LEHR...

Operation Manual - Page 3

.... arrestor. OTHER SAFETY WARNINGS • Never store a unit with loose or damaged parts. Refer to Starting/Stopping Instructions. (p.10) . • Allow the engine to instruct other materials. children. Keep a ﬁrm grip on both trimming lines extended, and the proper line installed. If you strike or become lodged between the cutting attachment and shield...

Operation Manual - Page 4

...not touch the line cutting blade. You may appear on cutting attachment shield. These parts get burned. ...LEHR | ALL RIGHTS RESERVED 2008-2009 OIL : Refer to the operator and/or bystanders. WARNING: Indicates danger, warning or caution. UNDERSTANDING YOUR TRIMMER...Sharp blade on this unit. Use a full face shield when needed. I ON/OFF STOP CONTROLS ON/START/RUN o ON/OFF ...

Operation Manual - Page 5

... installed. FOR CURVED SHAFT TRIMMERS Place the cutting attachment shield and spacer against tube as shown in the sequence as shown (Fig.2). Install the fasteners as shown in (Fig. 3), positioning the handle parts evenly over the tube in place. Make sure the shield does not touch any rotating parts. Cutting Attachment Shield Plate Washer Washer Lock...

Operation Manual - Page 6

... have spilled and reinstall the oil plug/dipstick. 6 LEHR | ALL RIGHTS RESERVED 2008-2009 Remove the oil plug...SG or SH oil (Fig. 5). It can cause premature engine wear and failure. See Changing The Oil (p.13). 1.... weight oil of oil and remove the seal covering the opening. See Changing the Oil (p.13...oil before each use and change as needed . Refer to meas-ure the correct ...

Operation Manual - Page 7

...engine. Turn trimmer o . 3. Overtightening can ignite leaking gas. Check for rotten egg odor. AFTER USE 1. Detach outdoors away from any time the smell of propane (smells like sulfur or rotten eggs). Let cylinder burn out. * Green Key- Propane...OF FIRE 1. LEHR | ALL RIGHTS RESERVED 2008-2009 7 UNDERSTANDING PROPANE SAFETY WARNINGS FOR PROPANE UNITS NOTE: Use propane only in ...

Operation Manual - Page 8

... 8 LEHR | ALL RIGHTS RESERVED 2008-2009 WARNING: PROPANE IS EXTREMELY FLAMMABLE. KEEPS SPARKS AND OPEN FLAMES AT A DISTANCE FROM THE AREA. Do not use Propane canisters or "Bottles" that any leakage stops. ATTACHING THE PROPANE CANISTER 3. If the propane canister to the trimmer and potentially result in a dangerous leak. VAPOR MAY EXPLODE. ALWAYS STOP THE ENGINE AND...

Operation Manual - Page 9

... edging only. Upper Shaft Housing Knob Fig. 10 Attachment Housing Coupler Release Button 90° Edging Hole Fig. 12 Fig. 11 3. Unit is upright (propane tank on straight out... 2. Turn knob counterclockwise to the unit. Line up parts Coupler Receiving Hole Release Button NOTE: Always install the attachment so that the engine remains in the upright position while operating. Turn...

Operation Manual - Page 10

...propane. 5. Allow the engine to ON position (Fig. 13). If your hand from the unit. When done using the trimmer... for 15 to squeeze the throttle open ame. Check the oil level in very hot or cold conditions it may take extra pulls to the o position. 3. NOTE: On the rst use, it will always remain in the starting the engine in the crankcase. Throttle Control Fig. 13 10 LEHR...

Operation Manual - Page 11

... easily contacts the grass without the need to bend over 8 inches (200 mm) by removing all vegetation around trees, posts, fences and more than the tip will occur from top to bottom in small increments to avoid prema ture line wear or engine drag. • Slowly move the trimmer into objects such as opposed...

Operation Manual - Page 12

...all the way back in the crankcase cannot be a part of any non-road engine repair establishment, individual or authorized service dealer. MAINTENANCE FREQUENCY BEFORE STARTING ENGINE EVERY 10 HOURS FIRST CHANGE AT 10 HOURS EVERY 25 ... PAGE 17 Perform these pro cedures call 1-866-941-LEHR for the location of your trimmer NOTE: Some maintenance procedures may require special tools or skills.

Operation Manual - Page 13

... 7. Allow ample time for complete drainage. Failure to maintain your engine. 1. Squeeze the lter and remove excess oil. 6. Unplug spark ...19). If the level is still warm but not hot. LEHR | ALL RIGHTS RESERVED 2008-2009 13 CLEANING THE AIR FILTER...4. Replace the lter. Air Filter Air Filter Cover Screw Fig. 19 Air Filter Base Plate NOTE: Wear gloves to dry. 4. Reconnect ...

Operation Manual - Page 14

... adjusting the idle speed should solve most engine problems. If not and all of engine power Check the spark plug for proper gap and...engine will restrict air ow. Remove the spark plug cover. socket counterclockwise. 3.Replace cracked, fouled or dirty spark plug. Set the air gap at a time (as needed ), to Starting/Stopping (p. 10) instructions. 2. Turn the 5/8 in . (0.5 mm) Fig.23 14 LEHR...

Operation Manual - Page 15

... hooked in these instructions. 2. Fig.29 11. LEHR | ALL RIGHT RESERVED 2008-2009 15 Lock shaft by inserting allen key into hole in body. Loosen bump feed button and remove by turning it . 5. Snap the lines through holes in collar and turn until it is wound. 6. Trimmer Head Body Spring Reel Bump Feed Button...

Operation Manual - Page 16

... pull through cover 16 LEHR | ALL RIGHTS RESERVED 2008-2009 Fig.3 7 Fig.33 5. Wind cord in direction indicated (CW) leaving 6 in reel and pull through holes on trimmer head body (Fig. 34 and Fig. 35). Turn CCW until "click" (Fig. 36). MAINTENANCE TRIMMER HEAD LINE INSTALLATION LARGE BUMP FEED HEAD (.095" Line) 1. Lock shaft by lining up the...

Operation Manual - Page 17

.... 38). NOTE: When using the brush cutter blade remove the bottom shield attachment by using line trimmer head (Fig. 41). Replace when using tool provided, turn CCW. Cotter Pin Left-Hand ... clearances. Clamp Plate Star Washer Left-Hand Thread Nut Fig.40 • For reassembly, install all components in the tool kit (Fig. 39). Engine cover screws Fig.42 Engine cover screws LEHR | All Rights...

Operation Manual - Page 19

...AN ADJUSTMENT ENGINE WILL NOT ACCELERATE CAUSE ACTION CUTTING ATTACHMENT BOUND WITH GRASS STOP ENGINE AND CLEAN THE CUTTING ATTACHMENT DIRTY AIR FILTER ENGINE LACKS POWER OR ...parts and tighten loose screws, nuts or bolts. Remove propane canister. 2. The unit is ready for any moisture with attached propane canister where fumes may reach an open ame or spark. • Allow the engine...

Operation Manual - Page 20

... NOTICE. 20 LEHR | ALL RIGHTS RESERVES 2008-2009 SPECIFICATIONS ENGINE* ENGINE TYPE DISPLACEMENT CLUTCH TYPE OPERATING R.P.M. IDLE SPEED IGNITION TYPE IGNITION SWITCH VALVE CLEARANCE SPARK PLUG GAP LUBRICATION CRANKCASE OIL CAPACITY FUEL CARBURETOR STARTER MUFFLER THROTTLE DRIVE SHAFT AND HOUSING DRIVE SHAFT HOUSING THROTTLE CONTROL APPROXIMATE UNIT WEIGHT CUTTING MECHANISM LINE SPOOL DIAMETER...

Operation Manual - Page 21

...subject engines. Therefore, LEHR reserves the right to change, modify, or discontinue models, designs, speci cations, and accessories of all receipts covering maintenance on or modi ed part. LEHR, Inc... parts will not reduce the period of warranty coverage. LEHR does not extend any defective power product or attachment as necessary" will be interpreted as follows: Any warranted part ...