Get support for Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr

Craftsman 25cc Support Question

Craftsman 25cc Support Question

Find answers below for this question about Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr.
Need a Craftsman 25cc manual? We have 1 online manual for this item!
Question posted by jollemj on July 21st, 2012

Ez Edge In Store. Motor Doe Not Turn On It Does Nothing. Is There A Fuse, Wher

the motor does not turn on   is there a fuse if so where.

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Craftsman 25cc Manual Pages

Operation Manual - Page 1

LEHR | ALL RIGHTS RESERVED 2008-2009 OPERATOR'S MANUAL PROPANE POWERED LINE TRIMMER 16.4 oz Propane Bottle Not Included TABLE OF CONTENTS Service and Safety 2 Safe Operation Rule.s 3 Understanding Your Trimme...r 4 Assembly 5 Oil Information 6 Understanding Propan.e 7 Installing the Propane Canist.e..r 8 Installing Attachment.s 9 Starting / Stopping 10 ...
Operation Manual - Page 2

...cations in any time without notice. • Al • Familiarize yourself with your trimmer prior to these requirements. PLEASE KEEP THESE INSTRUCTIONS FOR LATER USE. Forest Land and ...SERVICE AND SAFETY S LEHR ECO-TRIMMER IMPORTANT SAFETY INSTRUCTIONS DU 4-CYCLE PROPANE TRIMMER READ ALL INSTRUCTION BEFORE OPERATING • Ne For service call 1-866-941-LEHR in the United States...
Operation Manual - Page 3

... SAFETY WARNINGS • Never store a unit with propane canister attached inside a closed ...edge. Clean after the unit is delayed or when walking from one cutting location to cool before storing...damaged parts. SAVE THESE INSTRUCTIONS LEHR | ALL RIGHTS RESERVED 2008-...turned o . Breathing exhaust fumes can be in daylight or good artificial light. These are marked as a trimmer...
Operation Manual - Page 4

...injury to operator's manual for a short time after the unit turned o . Keep away from the rotating cutting attachment. WARNING: ... OTHER OPTIONAL ACCESSORIES MAY BE USED WITH YOUR UNIT 4 LEHR | ALL RIGHTS RESERVED 2008-2009 Use a full face ...cause severe eye injury and hearing loss. UNDERSTANDING YOUR TRIMMER SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety...
Operation Manual - Page 5

...Tighten until the D-Handle is equipped with. LEHR | ALL RIGHTS RESERVED 2008-2009 5 Use only the instructions that apply to the type of shaft and shield that pro vides you the best...the D-handle to clamp the cap and shield onto the tube. Shaft Mount Lower Handle Fig. 3 CURVED SHAFT TRIMMERS 1. FOR CURVED SHAFT TRIMMERS Place the cutting attachment shield and spacer against tube as shown in ...
Operation Manual - Page 6

... oil, can be overemphasized. Fig. 6 3. Pour the entire bottle of oil into the oil ll hole (Fig. 7). 4-Cycle Motor Oil Fig. 5 WARNING: Overfilling crankcase may have spilled and reinstall the oil plug/dipstick. 6 LEHR | ALL RIGHTS RESERVED 2008-2009 See Changing The Oil (p.13). 1. See Changing the Oil (p.13). It can cause...
Operation Manual - Page 7

..., turn unit o and get fresh air quickly. 2. To reduce chance of propane (smells like sulfur or rotten eggs). Turn trimmer o...store at any unit that has a suspected leak. Never store in an enclosed area can kill you experience headache, drowsiness, or nausea, turn...LEHR | ALL RIGHTS RESERVED 2008-2009 7 Propane has a harmless odorant added so that it is a trademark of propane...
Operation Manual - Page 8

.../ 465 GRAM CANISTER REMOVING THE PROPANE CANISTER 1. Remove the propane connector by turning it until snug. to be normal to hear or smell a slight momentary leak of empty propane canisters in accordance 2. It may cause damage to the trimmer and potentially result in the un-latched position. Fig. 9A Canister Clamp 8 LEHR | ALL RIGHTS RESERVED 2008...
Operation Manual - Page 9

.... 12). Upper Shaft Housing Knob Fig. 10 Attachment Housing Coupler Release Button 90° Edging Hole Fig. 12 Fig. 11 3. LEHR | ALL RIGHTS RESERVED 2008-2009 9 A secondary receiving hole is ready to use of the cut ting attachment) lock the release button of a trimmer being used in the upright position while operating. Turn the knob...
Operation Manual - Page 10

...INSTRUCTIONS 1. Allow the engine to ON position (Fig. 13). Turn switch to cool down by idling. 2. In cold weather, ... Level ( p. 12). 2. When done using the trimmer for the day, disconnect the propane canister from the throttle control. Make sure cutting head ...hand from the unit. Throttle Control Fig. 13 10 LEHR | ALL RIGHTS RESERVED 2008-2009 WARNING: ALWAYS WEAR EYE, HEARING...
Operation Manual - Page 11

...proper clothing. • With a slightly-bent right arm, the operator's right hand is holding the shaft grip. • The operator's left arm is straight, the left hand hold the knob on ground... to advance string. OPERATION OPERATING YOUR TRIMMER Before operating the unit, stand in a forwardbackward or side-to the ground (Fig. 16). 30° Fig. 16 LEHR | ALL RIGHTS RESERVED 2008-2009 11...
Operation Manual - Page 12

...13 PAGE 13 PAGE 13 PAGE 14 PAGE 17 Perform these pro cedures call 1-866-941-LEHR for the location of any non-road engine repair establishment, individual or authorized service dealer. ...WARNING: WHEN SERVICING, USE ONLY IDENTICAL REPLACEMENT PARTS. These procedures should be a part of your trimmer at the recom mended schedule may require special tools or skills. USE OF ANY OTHER PARTS MAY...
Operation Manual - Page 13

...50 mL) of the oil ll hole and into place and replace the screw. 4-Cycle Motor Oil Fig. 20 WARNING: TO AVOID SERIOUS PERSONAL INJURY, BE SURE TO TURN THE UNIT OFF BEFORE SERVICING IT. Allow ample time for complete drainage. MAINTENANCE CHANGING THE OIL... of SAE 10W-30 SF, SG, or SH oil. Wash the lter in air lter cover. LEHR | ALL RIGHTS RESERVED 2008-2009 13 Dispose of operation.
Operation Manual - Page 14

... Filter (p. 13). Refer to : 110-120 in . (0.5 mm) Fig.23 14 LEHR | ALL RIGHTS RESERVED 2008-2009 NOTE: The cutting attachment should make carburetor adjustments. If problem still occurs,... engine idles. The cor rect air gap is often mistaken for an out of engine power Check the spark plug for a min - Turn the 5/8 in . (0.5 mm). lb. (12.3-13.5 N-m) NOTE: Do not ...
Operation Manual - Page 15

...15-20 cm) to in body while inserting reel back into hole tighten by turning it engages groove inside. Trimmer Head Body Spring Reel Bump Feed Button Nut Fig.25 4. Hook Wrap Top CCW... When shaft can no longer rotate, loosen head by turning body as shown (Fig. 26). Wrap line 180° and wind extra line in place and the direction it . 5. Insert allen key into body. LEHR |...
Operation Manual - Page 16

... to pull through holes trimmer head body (Fig. 34). MAINTENANCE TRIMMER HEAD LINE INSTALLATION LARGE BUMP FEED HEAD (.095" Line) 1. Lock shaft by turning opposite the direction shown...trimmer head body and bottom. If your model is a curved shaft, loosen by inserting allen key into top grooves in (Fig. 35). Close assembly in sequence as shown in reel and pull through cover 16 LEHR...
Operation Manual - Page 17

...provided, turn CCW. Remove the left-hand thread nut to lock the shaft. Remove ...install a new cotter pin. Engine cover screws Fig.42 Engine cover screws LEHR | All Rights Reserved 2008-2009 17 Insert an allen key into the ...using the brush cutter blade remove the bottom shield attachment by using line trimmer head (Fig. 41). If you feel unsure or unqualified to perform ...
Operation Manual - Page 18

...to insert too thick a feeler gauge and accidentally depress the valve and spring. To decrease the clearance, turn the adjusting screw CCW. Readjust if necessary. 4. Clean dirt from around the rocker arm cover. 6....at the top of the cover. Jam Nuts Feeler Gauge Exhaust Valve Intake Valve Fig.44 18 LEHR | ALL RIGHTS RESERVED 2008-2009 Remove the rocker arm cover and gasket (Fig. 43). ...
Operation Manual - Page 19

... area. • Store unit out of reach of children. Dispose of the oil from the cylinder before attempting to cool. Allow the engine to start the trimmer after storage. 3. NOTE: Remove the spark plug and drain all of the old oil in accordance to prevent unauthorized use strong detergents. LEHR | ALL RIGHTS RESERVED...
Operation Manual - Page 20

...020 INCH (0.5 MM) SAE 10W-30 OIL 1.7 FLUIDOZ. (50mL) PROPANE 16.4OZ CANISTER CHOKE-LESS, ALL-POSITION AUTO REWIND BAFFLED WITH GUARD SAFETY...TO MAKE CHANGES AT ANY TIME WITHOUT NOTICE. 20 LEHR | ALL RIGHTS RESERVES 2008-2009 IDLE SPEED IGNITION TYPE...OIL CAPACITY FUEL CARBURETOR STARTER MUFFLER THROTTLE DRIVE SHAFT AND HOUSING DRIVE SHAFT HOUSING THROTTLE CONTROL APPROXIMATE UNIT WEIGHT CUTTING ...

Similar Questions

Ask a New Question
Use the box below to post a new question about this Craftsman product .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Craftsman Manuals

Find free Craftsman 25cc - Propane Curved Shaft Trimmer Powered by Lehr manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Craftsman Reviews

View thousands of Craftsman user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Craftsman customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Craftsman customer service rankings, employee comments and much more from our sister site.