2008 Chrysler Aspen Support Question
2008 Chrysler Aspen Support Question
Find answers below for this question about 2008 Chrysler Aspen.Need a 2008 Chrysler Aspen manual? We have 1 online manual for this item!
Question posted by Jonaaux on January 24th, 2014
How To Program Phone In 2008 Chrysler Aspen
The person who posted this question about this Chrysler automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner Manual - Page 10
... ...12 ▫ Ignition Key Removal ...12 ▫ Locking Doors With The Key ...13 Ⅵ Sentry Key ...13 ▫ Replacement Keys ...15 ▫ Customer Key Programming ...15 ▫ General Information ...17 Ⅵ Ignition And Steering Lock ...17 ▫ Ignition Accessory Delay Feature ...18 Ⅵ Security Alarm System -
Owner Manual - Page 11
10 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
▫ General Information ...25 ▫ Programming Additional Transmitters ...25 ▫ Battery Replacement ...27 Ⅵ Remote Starting System - If Equipped ...47 ▫ Rear 60/40 Seat Third Row Center Three Point Belt - ...
Owner Manual - Page 15
... TO KNOW BEFORE STARTING YOUR VEHICLE
The system uses ignition keys which has not been programmed is also considered an invalid key, even if it indicates that there is a fault in the electronics. ...Therefore, only keys that are programmed to the vehicle can be used to fit the ignition switch lock cylinder for a bulb check. NOTE...
Owner Manual - Page 16
... Sentry Keys, you to the system by following procedure: 1. A blank key is programmed to a vehicle, it cannot be used to the vehicle electronics. At the time of ... dealer or by performing the following the customer key programming procedure. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
15
starting the vehicle. Cell phones, pagers, or other vehicle. All of keys. ...
Owner Manual - Page 17
...Light will begin to the ON position for at the time of service to be programmed during this procedure to program up to the LOCK position and remove the first key. 3. After 10 seconds... for three seconds and then turn the ignition switch to eight keys. NOTE: If a programmed key is programmed. Then, turn off. In addition, the Vehicle Security Alarm Indicator Light will turn on ...
Owner Manual - Page 20
... To exit alarming mode, press the RKE UNLOCK button or start the vehicle with a programmed Sentry Key.
If something has triggered the system in the instrument panel cluster will ...flash rapidly for about 15 seconds to indicate that the alarm is started with a programmed Sentry Key. The Security Alarm System will start a vehicle, the engine will also ...
Owner Manual - Page 21
... that will illuminate in the interior lights ON position. NOTE: You may accidentally activate the Security Alarm System (horn sounds and lights flash) by inserting a programmed Sentry Key into the ignition and turning the key to the ON position or a key fob LOCK button is closed, or until all doors...
Owner Manual - Page 23
... least four seconds, but not longer than 10 seconds, then press and hold the LOCK button on a programmed key fob. 2. Opening a door with the Security Alarm activated will chirp once. NOTE: Pressing the LOCK... cause the alarm to sound. Press and hold the UNLOCK button. 3. If the desired programming was not achieved or to lock all the doors upon the first UNLOCK button press by pressing...
Owner Manual - Page 24
...door with the ignition in the OFF position and the key removed. Flash Lights with Lock Programming • For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to sound...Vehicle Information Center (EVIC) - Release both buttons at the same time. 4. If the desired programming was not achieved or to deactivate the Security Alarm. 6. NOTE: Pressing the LOCK button on ...
Owner Manual - Page 25
... after three minutes or if the vehicle is started or exceeds 15 mph (24 km/h). Release both buttons at the same time. 4. If the desired programming was not achieved or to deactivate the Security Alarm.
5. Opening a door with the Security Alarm activated will sound. Using the Panic Alarm To activate the...
Owner Manual - Page 26
...'s authority to reprogram them for these two conditions. 1. If your vehicle. Operation is five years.
2. Additional key fobs can be erased and you will be programmed for that may not cause harmful interference. 2. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
25
General Information This device complies with part 15 of FCC...
Owner Manual - Page 27
..., contact your seat belt. Turn the ignition to 60 seconds from when the original chime was heard.
8. After 60 seconds, all programmed key fobs function normally. Press and hold the UNLOCK button on the key fob. 11. After holding the UNLOCK button for details. The chime is ...
Owner Manual - Page 32
... disabled. 7. To reactivate this feature, repeat the above procedure.
2 Automatic Door Lock Programming This feature is enabled when your door locks will lock automatically when the vehicle's speed ...the above steps. 8. A single chime will cancel any chiming that may confuse you during this programming procedure. 3. Within 10 seconds, cycle the key from the assembly plant and can be heard...
Owner Manual - Page 33
... in the LOCK position (do not start the engine). 5. Auto Unlock On Exit Programming - If Equipped Customer programming sequence to enable or disable the Auto Unlock feature: • For vehicles equipped with...vehicle and close all of the doors of the vehicle when any manual operation of this programming procedure. 3. 32 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Auto Unlock On Exit - A...
Owner Manual - Page 34
..., repeat the above procedure. Child Protection Door Lock To provide a safer environment for children riding in the unlocked position. If a chime is not heard, the program mode was canceled before the feature could be opened by using the outside door handle even if the inside door lock is engaged, that door...
Owner Manual - Page 53
...can be cancelled after the feature has toggled. Keeping the mother safe is cranked or started, programming will be cancelled. 3. If during this time the ignition switch is turned to keep the...safe. Pregnant women should wear the lap part of the ON position or the timer expires, programming mode will be cancelled.
4. NOTE: Although the Enhanced Warning System (BeltAlert) has ...
Owner Manual - Page 80
... Features ...97 ▫ UConnect System Features ...100 ▫ Advanced Phone Connectivity ...104 ▫ Things You Should Know About Your UConnect System ...106
3 If Equipped ...88 Ⅵ Hands-Free Communication (UConnect) - If Equipped ...84 &#...
Owner Manual - Page 89
... defroster or the ignition will deactivate the heated mirrors. Refer to dial a
phone number with the Bluetooth ЉHands-Free Profile,Љ Version 0.96 or higher. NOTE: For UConnect customer support, visit the following websites: • www.chrysler.com/uconnect • www.dodge.com/uconnect • www.jeep.com/uconnect...
Owner Manual - Page 237
...confirm subscription information, including the setup of music, sports, news, entertainment, and programming for five seconds (when ignition is included with the factory-installed satellite radio system ...Radio" in Alaska. Operating Instructions - Operating Instructions - Hands-Free Phone (UConnect) (If Equipped) Refer to coast. Video Entertainment System™ (VES™) (...
Owner Manual - Page 477
476 INDEX
Transmitter Programming (Remote Keyless Entry) ...25 Tread Wear Indicators ...318 Trip Odometer ...208 Trip Odometer Reset Button ...214 Turn Signals ...149,203,431 UCI Connector ...241 UConnect™ (Hands-Free Phone) ...88,220 Underhood Fuses ...423 Uniform Tire Quality Grades ...455 Universal Consumer Interface (UCI) Connector ...241 Universal Serial Bus (USB...
Similar Questions
How Do I Remove The Instermet Cluster From A 2008 Aspen
(Posted by markj625 10 years ago)
How To Replace The Lights In The Overhead Console On A 2008 Aspen
(Posted by Trakenzie 10 years ago)
The Radio In Our 2008 Aspen Is Not Working At All. The Fuse Is Ok. Is There A Wa
Radio just stop working, replaced fuse now the power/display comes on, but no sound.
Radio just stop working, replaced fuse now the power/display comes on, but no sound.
(Posted by laprellellis 11 years ago)
2008 Aspen Front Heated Seat Fuse Location
(Posted by rajewskiorders 11 years ago)
2008 Aspen Right Side Mirror
How do you remove the right side mirror on my 2008 aspen?
How do you remove the right side mirror on my 2008 aspen?
(Posted by dlbrown413 12 years ago)