Brother International SC9500 Support Question
Brother International SC9500 Support Question
Find answers below for this question about Brother International SC9500.Need a Brother International SC9500 manual? We have 4 online manuals for this item!
Question posted by peaceukeohimor on December 20th, 2017
Electrical Fault
I just got a brother sc9500 sewing machine. I mistakenly connected it to a power of 220v instead of 110v. It sparked and when off. Please what should I do to bring it up. Am confused
Current Answers
Answer #1: Posted by BusterDoogen on December 20th, 2017 4:42 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,407
Member since:
October 30th, 2011 Points: 28,565,407
Go here for the possible failures caused by over voltage.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Brother International SC9500 Manual Pages
Users Manual - English - Page 1
Operation Manual
Sewing Machine
Product Code: 885-V64/V65/V66/V67
KNOWING YOUR SEWING MACHINE
SEWING BASICS
UTILITY STITCHES
APPENDIX
Please visit us at http://solutions.brother.com where you can get product support and answers to frequently asked questions (FAQs).
Users Manual - English - Page 3
... on the unit. To reduce the risk of burns, fire, electric shock, or injury to persons.
2 Always unplug the machine from the electrical outlet immediately after using the machine and immediately unplug the power cord. • When transporting the machine, be careful not to use the machine.
Do not use if you notice anything unusual, such as...
Users Manual - English - Page 4
... to the needle. Benzene, thinner, and scouring powders can damage the case and machine, and should be used or where oxygen is required when sewing:
• Always pay close attention to clean the case. Plug the machine directly into the electrical outlet. • Never drop or insert any object into any opening. • Do...
Users Manual - English - Page 5
...use . For additional product information, visit our web site at www.brother.com
SAVE THESE INSTRUCTIONS
This machine is intended for household use plugs with the appliance.
3 FOR USERS... cover omitted. • If the available electrical outlet is not suitable for their safety. Children should contact your local authorized Brother dealer. Use accessories recommended by authorized dealer....
Users Manual - English - Page 6
... THEIR FUNCTIONS 8
The main parts ...8 Needle and presser foot section ...9 Operation buttons ...9 Operation panel ...10 Spool pin ...10
USING YOUR SEWING MACHINE 12
Power supply precautions ...12 Power supply ...12 Foot controller ...13 Sewing speed controller (for models equipped with the start/stop button 13 Changing the needle stop position ...13 Changing the initial needle...
Users Manual - English - Page 7
... 85
MAINTENANCE ...86
Restrictions on oiling ...86 Precautions on storing the machine ...86 Cleaning the machine surface ...86 Cleaning the race ...86
TROUBLESHOOTING ...89
Frequent troubleshooting topics... ...47
Basic stitching ...47
BLIND HEM STITCHING 48
BUTTONHOLE SEWING 51
Button sewing ...55
ZIPPER INSERTION ...57
SEWING STRETCH FABRICS AND ELASTIC TAPE 59
Stretch stitching ...59 Elastic...
Users Manual - English - Page 8
... of the presser foot holder is difficult for example, at the beginning of the foot when it is available through your dealer.
KNOWING YOUR SEWING MACHINE
1 KNOWING YOUR SEWING MACHINE
ACCESSORIES
Included accessories
After opening the box, check that the following accessories are included. only) ● Foot controller: Model T
This foot controller can be...
Users Manual - English - Page 10
... connector (page 12) Insert the plug on the sewing machine model.
t Handle Carry the sewing machine by its handle when transporting the machine.
8
h Operation panel (page 10) This is used . l Main power and sewing light switch (page 12) You can use as the lower thread. KNOWING YOUR SEWING MACHINE
NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
The illustrations in the...
Users Manual - English - Page 11
... presser foot lever to clean the race.
h Feed dogs
The feed dogs feed the fabric in the fabric.
Be sure to easily perform various basic sewing machine operations.
d Sewing speed controller (for models equipped with the needle position button) Press the needle position button to change the...
Users Manual - English - Page 12
... the stitch selection keys, and then select the number for models equipped with character stitches)" (page 73). Spool pin
As shown, press down on the sewing machine model. For details, refer to raise the spool pin. For details, refer to the spool pin as shown in the illustration.
The operation panel differs...
Users Manual - English - Page 13
...Storing the spool pin
■ Installing the spool pin
When placing the cover on the back of the machine, as
fold up the spool pin, as shown in the illustration,
shown.
1
until it .
a... spool pin has been removed from the a machine, insert the tab on the spool pin into
Remove the spool from the spool pin, and then
the hole on the sewing machine
before storing or if the spool pin will ...
Users Manual - English - Page 14
... cord may result. ● When unplugging the machine, always turn off the sewing machine and unplug the power supply cord. If it from the machine • After using the machine • When the power fails during use • When the machine does not operate correctly due to a bad connection or a disconnection • During electrical storms
CAUTION
● Use only the...
Users Manual - English - Page 15
....
When you take your foot off the sewing machine. Instead, the machine can be used to start sewing (only for models equipped with the start /stop position to leave the needle raised when sewing is the foot controller's maximum sewing speed. Doing so could cause a fire or an electric shock.
Memo
• Perform the same operation to change...
Users Manual - English - Page 16
...) on the left and turn on .
KNOWING YOUR SEWING MACHINE
Changing the initial needle position
Normally, the straight stitch (left needle position) is automatically selected when the sewing machine is turned on the sewing
machine. a
Cancelling the operation beep
When the sewing machine is purchased, it is set so that machine beeps.
14 a
Hold down the "-" side of
(stitch...
Users Manual - English - Page 17
... you use bobbins from other bobbins may cause damage to the machine.
● We designed the bobbin that comes with this machine.
Remove the spool cap. b
CAUTION
● Do not ...151). Only use bobbins (part code: SA156, SFB: XA5539-151) that comes with this sewing machine.
THREADING THE MACHINE
Winding the bobbin
This section describes how to wind the thread onto the bobbin. • ...
Users Manual - English - Page 18
...Hold the thread with your right hand so that there is no slack in the spool or the machine may be damaged.
● Three spool cap sizes are available, allowing you to the right end... tangled around the spool pin or the machine may be damaged. a Thread guide
Pass the thread under the thread
guide. a Thread guide cover
16 KNOWING YOUR SEWING MACHINE
Fully insert the spool of thread for ...
Users Manual - English - Page 19
...the start /stop the machine.
Then stop button). Note
● If the sewing machine is plugged in, the start/stop button cannot be operated using the foot controller, connect the foot controller before ... in as far as possible.
If you follow the instructions carefully. a Spring on the sewing machine.
k
CAUTION
● Make sure you do not cut the thread completely, and the ...
Users Manual - English - Page 20
... controller back to its p original position (for models equipped with your right hand to pass the thread
around the bobbin, the machine will make a clicking sound; Memo
● When the sewing machine is started or the handwheel is not a malfunction.
● The needle bar does not move when you slide the bobbin winding...
Users Manual - English - Page 38
For details on the machine.
Attach the presser foot appropriate for the area to sew.
1
Turn on selecting a stitch, refer to "Power supply" (page 12).
↓
2 Select the stitch.
Turn on replacing the presser foot, refer to "Replacing the presser foot" (page 34).
↓
4 Start sewing. For details on turning on starting to sew, refer to...
Users Manual - English - Page 88
...machine off and unplug it out firmly, and then wipe the surface of the machine. CAUTION
● Unplug the power supply cord before you may get an electric shock or be cleaned periodically. This machine...APPENDIX
MAINTENANCE
Simple sewing machine maintenance operations are described below , otherwise damage to the machine may result, for an extended period of the machine is dirty, ...
Similar Questions
Brother Sewing Machine Bm3700
can 3700BM brother sewing machine use an extension and what model
can 3700BM brother sewing machine use an extension and what model
(Posted by jameelahmuhammad 8 years ago)
Where Is The Basting Stitch On The Sc9500 Brother Sewing Machine
Where is the basting stitch on the sc9500 brother sewing machine
Where is the basting stitch on the sc9500 brother sewing machine
(Posted by kschroepfer 9 years ago)
Where To Buy Bobbins For My Sc9500 Sewing & Quilting Machine?
I need to know how to purchase bobbins for my sc9500 sewing & quilting machine and the price of ...
I need to know how to purchase bobbins for my sc9500 sewing & quilting machine and the price of ...
(Posted by beverlyandjohn18 11 years ago)
I Just Got The Machine And It Is Sewing Verrrrry Slooooowly. How Do I Speed It U
(Posted by rupee24601 11 years ago)
What Model Number Bobbins Should Be Used On Brother Sc9500 Sewing Machine
Please provide me with the model/style bobbin that fits on a Brother SC9500 sewing machine. Thanks.
Please provide me with the model/style bobbin that fits on a Brother SC9500 sewing machine. Thanks.
(Posted by ezth2 11 years ago)