Brother International JX2517 Support Question
Brother International JX2517 Support Question
Find answers below for this question about Brother International JX2517.Need a Brother International JX2517 manual? We have 2 online manuals for this item!
Question posted by Moelimo53 on August 11th, 2013
Rating
Do you have any review or rating on brother jx2517 sewing machine.
Current Answers
Answer #1: Posted by SoCalWoman on August 11th, 2013 8:43 PM
SoCalWoman
Member since:
December 16th, 2012 Points: 2,938,577
Member since:
December 16th, 2012 Points: 2,938,577
Unfortunately, there are not a whole lot of reviews for this model sewing machine by Brother.
However, there are 3 reviews located here on Helpowl, With an overall rating of 3 stars. You can view these reveiws here
hope this helps
Much appreciation to those who acknowledge our members for their contribution toward finding a solution.
~It always seems impossible until it is done~
Nelson Mandela
Related Brother International JX2517 Manual Pages
Users Manual - English and Spanish - Page 2
... properly, if it has been dropped or damaged, or water is required when
sewing:
• Always pay close attention to the needle. To
reduce the risk of burns, fire, electric shock, or injury to persons.
2 Always unplug the machine from
the electrical outlet when making any other part may fall, resulting in...
Users Manual - English and Spanish - Page 3
.... For additional product information, visit our web site at www.brother.com
SAVE THESE INSTRUCTIONS
This machine is damaged, it could cause the needle to break.
• Do not push or pull the fabric when sewing, and follow the troubleshooting table in this machine, avoid direct sunlight and high humidity locations.
Children shall not...
Users Manual - English and Spanish - Page 4
carrying the mark, rating as marked on storing the machine 34 Cleaning 34
TROUBLESHOOTING 36 INDEX 39
3 CONTENTS
IMPORTANT SAFETY INSTRUCTIONS 1
1.
KNOWING YOUR SEWING MACHINE 4
ACCESSORIES 4 Optional accessories 4
THE MAIN PARTS 5 Flat bed attachment 5
USING YOUR SEWING MACHINE 6 Connecting plugs 6 Main power and sewing light switch 7 Foot controller 7 Checking the ...
Users Manual - English and Spanish - Page 5
...)
Part Code Americas Others
XC4901-121
X59369-321
XE9369-001
SA156
SFB: XA5539-151
No.
1 KNOWING YOUR SEWING MACHINE
1
ACCESSORIES
We have designed these accessories to be included with your machine.
1.
2.
3.
4.
5.
6.
7.
8.
Part Name
5
Needle set (90/14 needle)
6 Screwdriver
7 Foot controller
Part Code Americas Others 3-piece set: XE5328-001 2-piece set: XE7064...
Users Manual - English and Spanish - Page 6
....
E Foot controller jack / socket (Page 6) Plug in the foot controller plug and connect the machine to manually raise and lower the needle. F D
G
E
G Foot controller (Page 7) You can... foot lever (Page 15) Used to 1 open it.
1
2
1 Flat bed attachment 2 Storage compartment
5 KNOWING YOUR SEWING MACHINE
THE MAIN PARTS
3
2
1
4
B
5
A
C
6
0
7
8
9
1 Bobbin winder (Page 11) This...
Users Manual - English and Spanish - Page 7
... or a disconnection • During electrical storms
CAUTION
● Use only the power cord included with this plug is damaged, take the machine to install the proper outlet. USING YOUR SEWING MACHINE
1
WARNING
● Use only regular household electricity for repairs before continuing use extension cords or multi-plug adapters with wet hands.
Fire...
Users Manual - English and Spanish - Page 8
...machine rating plate.
■ Checking the needle correctly Put the flat side of the needle on the wheel points up on the foot controller. Check the needle from the top and the sides. Other needles may bend or break and cause injury.
● Never sew... code is accidentally pressed and the machine starts sewing.
● Only use sewing machine needles for smooth sewing.
1 2
1 Turn on (toward...
Users Manual - English and Spanish - Page 9
... toward you leave the power on and step on the controller, the machine will have chosen. If you
(counterclockwise) so that have been
designed to sew and how. With the flat side of the needle toward the 5 back of the sewing machine may cause injury.
● Only use the correct presser foot for the...
Users Manual - English and Spanish - Page 10
... points up.
If the needle is not installed with the correct orientation, the needle may strike the presser foot, which may be damaged. KNOWING YOUR SEWING MACHINE
Lower the presser foot lever and fix the 5 presser foot onto the shank.
Users Manual - English and Spanish - Page 11
... STITCH
(Center Needle
- Position)
1
11
STRAIGHT STITCH (Left Needle Position)
2.5 (3/32) -
23, 30, 32
1 Reverse sewing lever
12 2 (1/16) 24, 33
BLIND HEM STITCH
5 (3/16)
13 1 (1/16) 25
ELASTIC STITCH
5 (3/16)
10 The machine will then sew forward.
Pattern Stitch Name
Preset Length (mm (inch))
Preset Width (mm (inch))
Reference Page
Pattern
Preset...
Users Manual - English and Spanish - Page 12
KNOWING YOUR SEWING MACHINE
THREADING THE MACHINE
Winding the bobbin
CAUTION
● We designed the bobbin that comes with your right hand, pass the thread
toward you use the bobbin that comes with this pin.
3 Bobbin
While holding the thread from other bobbins may tangle on the thread guide. Using other models, the machine will...
Users Manual - English and Spanish - Page 13
... poorly
12 While holding the end of the thread, 6 gently press the foot controller to wind
the thread around the bobbin. Note
● When the sewing machine is started or the handwheel is wound around the bobbin a few times. CAUTION
● Not winding the bobbin properly may cause the thread tension to...
Users Manual - English and Spanish - Page 14
... threading the lower thread.
• See page 11 for the details about bobbin winding. If you turn off the machine while threading.
If the thread unrolls in the right direction. KNOWING YOUR SEWING MACHINE
Lower threading
Install the bobbin wound with your finger, and then
pass the thread through the slit, as shown...
Users Manual - English and Spanish - Page 16
...) 3 Thread guide (front)
4 Thread take-up .
• If the needle is not correctly raised, the sewing machine can not be threaded.
For details on the correct
combination of 20 or lower. ● Use the needle and ...1 Mark on the wheel
15
If the upper threading is in the correct combination. Turn off the machine.
1
Raise the presser foot lever.
2
Pull up the spool pin and put a spool of ...
Users Manual - English and Spanish - Page 18
... draw up the 2 lower thread.
1
2
1
• The bobbin cover should still be left over. Before you can begin sewing immediately without cutting it there
without drawing up the bobbin thread. KNOWING YOUR SEWING MACHINE
Drawing up the lower thread
While lightly holding the end of the upper 1 thread, slowly turn the handwheel toward...
Users Manual - English and Spanish - Page 19
...JERSEY BALL POINT" 130/705H SUK 90/14 may be uneven, the fabric to pucker, or the machine to be used as heavyweight fabric like denim with a small needle (65/9-75/11), may bend ....
The wrong combination may cause machine malfunction. and the higher the needle number, the thicker the needle.
■ Ball point needle Use the ball point needle when sewing on stretch fabrics or fabrics where...
Users Manual - English and Spanish - Page 20
... the 2 handwheel toward you
(counterclockwise) so that the needle does not hit basting pins or other way may cause the thread to the machine. SEWING BASICS
2 SEWING BASICS
Please read before sewing
CAUTION
● To avoid being injured, watch the needle carefully while you may be damaged. Turning it toward the rear of thread...
Users Manual - English and Spanish - Page 21
...needle may bend or break.
1 Thread cutter
20 Refer to "Reverse sewing lever" on the foot controller.
9
X The machine starts sewing. Using the needle as those used for your project, and check the...point where you (counterclockwise). Use a piece of the c machine, and then pass the threads through the thread cutter to cut them.
.
1
Sewing thick fabrics
■ If the fabric does not fit under...
Users Manual - English and Spanish - Page 28
... bar tack)
Sewn section
Pattern
1. Step 2 (Left side)
1 Marks on the presser foot.
2
1
1 Front of the frame.
1. Sew the length of the fabric. Stop the machine when the needle is accidentally pressed and the machine starts sewing. Making a buttonhole
Pattern 1
Stitch
Stitch
Length [mm
Width [mm
Foot
(inch)]
(inch)]
0.5 (1/32)
Button5 (3/16) hole
Foot...
Users Manual - English and Spanish - Page 37
... the needle.
7
The upper thread was not threaded correctly. sew.
Contact your retailer or the nearest
- for this machine.
11
You have not fitted the spool properly, or the thread...
Fabric being
sewn with the
machine
Thread is scratched.
If you have not threaded the upper thread
properly. (For example, you need additional help, the Brother Solutions Center offers the latest ...
Similar Questions
How Do I Take Apart Brother Sewing Machine Jx2517. To Reattach The Belt?
(Posted by louisianajean 8 years ago)
Where Is A Parts Guide Or Service Manual For Brother Jx2517 Sewing Machine?
the inside of my brother JX2517 sewing machine broke. Its a plastic piece,gear, at end by the needle...
the inside of my brother JX2517 sewing machine broke. Its a plastic piece,gear, at end by the needle...
(Posted by Discogypsy 9 years ago)
How Does The Ce8080prw Brothers Sewing Machine Rate
(Posted by leflyby 10 years ago)
Tension Adjustment On The Brother Sewing Machine #jx5217?
How do you adjust the tension on the Brother Sewine Machine #JX5217?
How do you adjust the tension on the Brother Sewine Machine #JX5217?
(Posted by flokay8 10 years ago)
Http Solutions Brother Maquina De Coser Jx2517
alguien me quiere ayudar no quiere cosert bien
alguien me quiere ayudar no quiere cosert bien
(Posted by Anonymous-120868 10 years ago)