Home » Bosch » Laundry Washers » Bosch WFMC5801UC

Bosch WFMC5801UC Support Question

Find answers below for this question about Bosch WFMC5801UC.
Need a Bosch WFMC5801UC manual? We have 2 online manuals for this item!

Bosch Overview Questions Manuals Reviews Videos Research

Question posted by pwohldford on November 20th, 2013

Door Seal

TRemoved top and control panel. How do i get the new door seal on the drum

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Bosch WFMC5801UC Manual Pages

Pedestal Installation Instructions - Page 2

.... d CAUTION Do not lift the appliance by the door or door opening. Important Safety Information Please read and follow these ...Installation Instructions along with all times during the pedestal installation. 2 Figure 1 1. 17 mm open end wrench 2. 6 mm Allen (Hex) wrench 3. (4) Socket Head Cap Screws and (4) Flat Washers...

Pedestal Installation Instructions - Page 4

... Hazard Use two or more people to 2" off the floor. NOTICE If installing the pedestal to a new washer, do so can result in injury. 3. Protect the floor and the side of the appliance by laying...release levers located in the appliance (see Figure 9). Ensure the pedestal drawer opening and appliance door face the same direction (see Figure 7). Protect the floor and the side of this manual...

Pedestal Installation Instructions - Page 6

... against will turn the level so that came with all 4 transport bolt assemblies (bolt, washer and bushings) by turning it unlevel again.) Each foot of the appliance or pedĆ... Leveling Procedure 1. Use the wrench provided (or a 5/8" - 16mm open washing machine door and pulling the drum slightly forward to back. Otherwise, repeat the leveling procedure until they snap in as far...

Pedestal Installation Instructions - Page 7

...to all feet) is manually stopped before its completion, then the door may be tightened firmly to minimize vibration and movement of the appliance ...place by aligning it locks tightly against the pedestal. For Washers: Fine tune the leveling by freely opening and closing the...drawer are correctly engaged by placing a small load of laundry in (counter-clockwise) will change the height of the...

Operating, Care, Installation - Page 2

... and a new, revolutionary gasket design keep them to fibers. XXTRASANITARYt Cycle With this innovative cycle, a thermostat-controlled, intelligent sensor heats up the water to 170º F and maintains the temperature for the toughest stains. An inclined drum works with no damage to ensure not a single shirt goes unturned. Stainless Steel Drum The Nexxtt washer drum has...

Operating, Care, Installation - Page 3

... moving out 11 OPERATING INSTRUCTION 12 Your new washer 12 Panel 13 Summary of Instructions 14 Before Using For the First Time 15 Using For the First Time 15 First washing cycle (without laundry 15 Preparing the laundry 15 Sorting the laundry 15 Degrees of soiling 15 Loading the laundry 16 Laundry Detergents and Additives 17 Dispensing the...

Operating, Care, Installation - Page 4

...Ćlock (magnetic door lock). - Do ...your household. High door with the controls. 9. Each washing...the appliance if the wash drum is used for regular ...costs significantly. BOSCH washers are provided with ...HYDROGEN GAS IS EXPLOSIVE. The new washing machine you have the skills...remove the door and the power cord/plug. 6. Door opening ...washer. Drum capacity 20 lbs (9 kg...

Operating, Care, Installation - Page 5

...conveyed with a qualified electrician or serviceman if you are readily accessible. Check with the washer. 14. Do not touch the door if washing at the end of each wash day. 26. Do not use an...the round service panel in the front can result in accordance with the appliance ć if it has a worn power cord or loose plug. This appliance is equipped with all laundry chemicals and aids...

Operating, Care, Installation - Page 6

...the transport bolts (after removing them). 2. Also remove the washer door to observe all the accessory parts supplied for use your dealer ...water and conventional additives that are missing contact your new appliance on to avoid risk of laundry and water hardness, and follow the detergent manufacturer...moisture inside the drum is heavy. Information concerning waste disposal Disposing of packaging materials...

Operating, Care, Installation - Page 7

...) b = 30.7 inches (780 mm) c = 37.0 inches (940 mm) d = 16.0 inches (407 mm) Door opening angle 180° Approx. in a corner of the appliance: - in a closet, observe the minimum distances according to... q Screw a water resistant wooden board (at : www.boschappliances.com If mounting the washer on the Bosch pedestal follow the instructions supplied with foam backing, are not designed for ...

Operating, Care, Installation - Page 8

...drum slightly forward towards the door. q Remove the bottom two bolts prior to close the openings. q To store the bolts for any future transport (e.g. If in the supply network: - NOTICE If installing the washing machine in a new...appliance and adjacent surfaces, all 4 transport bolt assemblies (bolt, spring, washer and bushings). q Completely remove all 4 transport bolts must be more...

Operating, Care, Installation - Page 11

...program. (Does not apply to hold the washer foot with a pair of laundry in its completion, then the door may be sure the level fits between the edges of the washer, and is not elevated at mone end...by turning it does wobble, lower the foot on the surface of the washer with it in that the tab on the washing machine back panel. 11 i If the test spin cycle is leveled. Make sure that ...

Operating, Care, Installation - Page 12

OPERATING INSTRUCTION Your new washer Filling laundry detergent and/or additives into dispensers Open the door (colored marking) ... ...and close the door dCAUTION The access panel located on the bottom right of the washer is for Service Access and is only to be opened by an Authorized or Qualified Service Technician. 12

Operating, Care, Installation - Page 13

... to show the current program cycle.Door Locked lights up to turn while ... Pause" mode. OPERATING INSTRUCTIONS Before using your washer, read the IMPORTANT SAFETY INSTRUCTIONS before operating this .... Rinse Plus: Adds an additional rinse cycle. Panel Additional Functions Status Display C A Program Selector ...controlled. 13 The indicator light of energy used for the washing program.

Operating, Care, Installation - Page 14

Summary of instructions Before using d WARNING Before using your washer, read and follow all installation and operating instructions. Preparing the laundry turn on Select a cycle and start the machine After washing close Select desired settings press start load unload 14

Operating, Care, Installation - Page 15

... water tap. q Pour approx. 1 quart (1 liter) of the washing machine (e.g. q Pour 1-2 Tbsp. When the display shows 0:00": q Open the door. q Turn the program selector to avoid scratching the washer interior. Preparing the laundry NOTICE Loose debris (coins, paper clips, nails and other hard objects) can damage items of clothing as well as parts...

Operating, Care, Installation - Page 16

... the DO NOT WASH symbol Ú is no debris in the washing machine drum can damage the laundry. NOTICE Loose debris in the drum. Mix up large and small items. Items of clothing between the door and rubber seal. Before loading the laundry, check that have been pretreated with solventĆbased cleaning agents, e.g. q Unfold the...

Operating, Care, Installation - Page 20

...increasing the washing time. Unbalanced load detection system The automatic unbalanced load detection system spins the laundry several times to evenly distributed load - When a program has been selected, the expected ...Displayed Time Due to the drum. q Load the washing machine and close the door. By raising the temperature from cold up to start /end of the controls the actual cycle time will ...

Operating, Care, Installation - Page 22

.... q Remove the laundry. g. The detergent dispenser can be disassembled into place. Never clean the washing machine with a soft towel. The Start/Pause indicator light flashes. (Does not apply to Off. q When this program has ended, open the door. d WARNING TO AVOID RISK OF EXPLOSION! Cleaning the appliance housing and control panel As required: q Use...

Operating, Care, Installation - Page 24

.../or the door is restored. Door not closed properly. Select Drain or Spin. An interrupted program will be resumed when power is locked for safety reasons. see Page 22. Clean and dry the detergent dispenser; Eliminate the cause. Control lights do not light up. Wait until the program ends; If the laundry is not...