Home » Bosch » Laundry Washers » Bosch WFMC5301UC

Bosch WFMC5301UC Support Question

Find answers below for this question about Bosch WFMC5301UC - 500 Plus Series Nexxt Washer 4 cu. Ft.
Need a Bosch WFMC5301UC manual? We have 4 online manuals for this item!

Bosch Overview Questions Manuals Reviews Videos Research

Question posted by Jwlaman on February 9th, 2013

Can I Program Just A Spin Cycle? /15 Model

The person who posted this question about this Bosch product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Bosch WFMC5301UC Manual Pages

Pedestal Installation Instructions - Page 6

... reaching through the open end wrench). d CAUTION To avoid risk of the 17mm wrench provided. q Loosen the lock nut (see Figure 15). q If the bushings do this with the washer and bushing attached. It is closer to one end on a ridge on the floor to do not come out properly. Slide the...

Pedestal Installation Instructions - Page 7

... turn, it in spin cycle and then leveling the appliance again. All locknuts must be necessary to hold the appliance foot with or service on each corner of laundry in the machine, ...step. q After making preliminary adjustments, press down on your pedestal contact BSH Home Appliances. For Washers: Fine tune the leveling by turning the lock nut counter-clockwise until the foot touches the ...

Pedestal Installation Instructions - Page 8

...Model Number Appliance Serial Number 8 If retailer is not available, please refer to the Operating, Care and Installation Instructions" that is in use and/or used with the listed washer or dryer and operated according to the instructions provided in the washer...This warranty applies only while the Pedestal is installed with the washer or dryer that came with the Pedestal and contact the ...

Installation and Use & Care (all languages) - Page 2

.... Quiet Performance Bosch laundry appliances use brushless motors, suspended pump systems and special sound-deadening material to ensure not a single shirt goes unturned. XXTRASANITARYt Cycle With this innovative cycle, a thermostat-controlled, intelligent sensor heats up to 150º F to gently tumble completely snag-free. Stainless Steel Drum The Nexxt washer drum has hundreds of...

Installation and Use & Care (all languages) - Page 3

... as when moving out 11 OPERATING INSTRUCTION 12 Your new washer 12 Panel 13 Summary of Instructions 14 Before Using For the First Time 15 Using For the First Time 15 First washing cycle (without laundry 15 Preparing the laundry 15 Sorting the laundry 15 Degrees of soiling 15 Loading the laundry 16 Laundry Detergents and Additives 16 Dispensing the correct amount of...

Installation and Use & Care (all languages) - Page 4

...than your laundry using the... programs ...washer. Drum capacity 17.6 lbs (8 kg) for washing and spinning.... - Each washing machine which , even after washing, may remain in subsequent wash loads causing skin irritation. 4 Further information and a selection of ignition, including a clothes dryer. These operating and installation instructions describe various models... you just purchased ...

Installation and Use & Care (all languages) - Page 5

... this washing machine until you are instructed in compliance with the washer. Notes: A. Always contact your dealer, distributor, service agent or...the washing machine if any problems or conditions that all laundry chemicals and aids in doubt as to the INSTALLATION INSTRUCTIONS....installed according to whether the washer is properly installed and grounded in this is used for ...

Installation and Use & Care (all languages) - Page 7

... be affected depending on a solid floor and well leveled due to the higher spin speeds available. i Install pedestal prior to plastic plumbing lines, gas lines or hot... first use, run a 15 cleaning cycle 7 Flat head screwdriver. 2. Closed wrench (1/2" / 13 mm). 4. weight = 220 lbs (100 kg) Installation area d WARNING d Never ground the washer to removing transport bolts. ...

Installation and Use & Care (all languages) - Page 11

...: - Use a bubble level (24" or less in spin cycle and then leveling the washer again. Tip: if the bubble is locked against the washer housing. Install the transport bolts. Make sure that corner until...not wobble. When the corner of the washer. If it does wobble, lower the foot on the illustration) by placing a small load of laundry in the machine, starting it locks tightly...

Installation and Use & Care (all languages) - Page 13

... finished lights up if the respective program segment runs. The indicator light of safety or program is pressed. Rinse Plus: Additional rinsing cycle. Indicator light turns off additional option: Press button again. The program selector does not turn while the program is lit red. 13 Spin Selection button For changing the spin speed (if required). Heavy duty: Increased...

Installation and Use & Care (all languages) - Page 15

...the water valves for one week. - Do not rub. Before using the appropriate program. 15 q Check that have been used for the washing machine have been worn several times...avoid pilling. q Do not load any laundry. q Pour 1-2 Tbsp. The Start/Pause indicator light flashes red. i The display shows the run the washer a complete cycle, without smoke staining) that the supplied ...

Installation and Use & Care (all languages) - Page 16

... to remove persistent, dried on Page 15. - Mix up large and small ...varying size will distribute better during the spin cycle. Laundry Detergents and Additives Dispensing the correct amount ...laundry. - Too little detergent: The laundry is no debris in order to load the drum depending on the fabric type, see special programs Page 17 for information on the laundry. Before loading the laundry...

Installation and Use & Care (all languages) - Page 17

... with delicate easy care items made of the programs are particularly designed to the clothes. At the beginning of cotton, satin, synthetic or blended fabrics and curtains, dresses, skirts and blouses. i Do not wash new multicolored laundry with a spin cycle. Spin cycle for a minimum of your front-loading washer. Do not fill over edge of the detergent...

Installation and Use & Care (all languages) - Page 18

... protien-based stains. This option is not available for cold programs. Rinse Plus When this button until the new time appears. Revolutions per minute Program 400 Hand Wash 400 Soak No final spin The indicator light no spinning occurs. Modifiers Spin Selection Preset cycle setting of the program is indicated by the points between the digits flashing. i Changes...

Installation and Use & Care (all languages) - Page 19

... occurs automatically. Bleach and Rinse Plus) until the end of the selected button is possible. - The following information: - Load size - Additional rinse cycles if excessive foam occurs - The indicator light of the cycle. i Do not activate/deactivate the acoustic signal during a cycle. Adding laundry is lit (red). In the wool program the appliance will attempt to...

Installation and Use & Care (all languages) - Page 20

... indicator light flashes. The indicator light is cool to higher spin speeds. Canceling an active program If you would like to terminate a program and remove the laundry: i If a program is interrupted at a standstill. q Turn the program selector to Off. q Turn the program selector to a newly selected program. i If the program is displayed. q If necessary, change the settings; Press the...

Installation and Use & Care (all languages) - Page 23

... and on the packaging. Door cannot be changed. Indicator light spin" is lit and display is trapped in progress; Program selector turned to Off before spinning. during spin cycle the speed cannot be opened . Supply hose kinked or pinched. see Page 21. Check whether laundry is flashing E:02" or E:03". Select speed before end of the...

Installation and Use & Care (all languages) - Page 24

... laundry pieces in load to balance the load through repeated spins. Replace the drain hose. For safeĆ ty reasons the highćspeed spin cycle...laundry was not spun. Unsatisfactory washing result. Gray residue on the laundry. If the fault continues, call customer service; Program duration exĆ tended. This is not a fault. Use less detergent for you High Efficientcy washer...

Installation and Use & Care (all languages) - Page 25

..., partners, affiliates or representatives of limited product Warranty applies only to the Bosch Nexxt washer ("Product") sold to page 23 before calling for a period of three hundred sixty... If after working with your normal, household (non-commercial) use an un-authorized servicer; Model Number - Serial Number - STATEMENT OF LIMITED PRODUCT WARRANTY What this warranty period, Bosch or ...

Installation and Use & Care (all languages) - Page 88

... options (approx Time in min. (approx.) * Soak Soak cycle is used to pre-treat heavily stained items. The cycle ends with a short spin. 120 Refresh Short rinse cycle followed by a spin. 19 * Actual program duration may be different from the indicated values depending on article! 88 Program selection table Nexxt 500 Plus Series Please read and observe Operating, Care and Installation...