Bosch WFMC2201UC Support Question
Bosch WFMC2201UC Support Question
Find answers below for this question about Bosch WFMC2201UC - Nexxt 300 Series Washer.Need a Bosch WFMC2201UC manual? We have 4 online manuals for this item!
Question posted by leinc on November 30th, 2013
Washer Does Not Drain Completely--pump And Impeller Clean And Free--help?
clothes not spun dry--water in tub when cycle is done-
Current Answers
Related Bosch WFMC2201UC Manual Pages
Pedestal Installation Instructions - Page 5
...Make sure the webbed side of each spacer is required) (see Figure 13). Helpful hint: Do not tighten any future transport (e.g. Install the four new feet that...the wrench to tighten an additional 1/3 to an upright position (use of the spacer with the washers and spacers in any screws completely until all are
included with the pedestal. Note: Tightening torque for all screws (see Figure ...
Pedestal Installation Instructions - Page 6
... back into the bushings and carefully try again. Loosen them out from front to help reduce vibration.
2. Storing the transport bolts Always keep the transport bolts for fuĆ...
that direction.
Figure 14 q Completely remove all four feet screwed in
completely (see Figure 17, item 1) by reaching through the open end wrench). Start with the
washer and bushing attached. d CAUTION
...
Pedestal Installation Instructions - Page 7
...foot in (counter-clockwise) will change the height of laundry in the machine, starting it in place by turning...appliance is manually
stopped before its completion, then the door may be tightened firmly to the...Washers: Fine tune the leveling by freely opening and closing the drawer.
i If the test spin cycle is satisfactorily raised or lowered, lock the height-adjustable feet in spin cycle...
Installation and Use & Care (all languages) - Page 2
...-free. KIDSCAREt Cycle The littlest people in operation. An inclined drum works with Technology Operation Logic.
Which means they can be installed virtually anywhere in the home without causing a disturbance. This machine virtually operates at the touch of the cycle by sensing load size, water level and temperature needs for your laundry a complete, even clean. Bosch NexxtR washers...
Installation and Use & Care (all languages) - Page 3
...
7
Water connection
8
Hose and cable lengths 10
Electrical connection 10
Leveling procedure 11
Transport, such as when moving out 11
OPERATING INSTRUCTION 12
Your new washer 12
Panel 13
Summary of Instructions 14
Before Using For the First Time 15
Using For the First Time 15
First washing cycle (without laundry 15
Preparing the laundry...
Installation and Use & Care (all languages) - Page 4
...-
The illustrations may show different details than your laundry using the washing machine.
2. This indicates that ...dry cleaning solvents, other flammable or explosive substances to the weather.
8. An easy operation philosophy, a variety of ignition, including a clothes... modern washing machine cleans your washer. The appliance may be exposed to the wash water. Definitions d WARNING...
Installation and Use & Care (all languages) - Page 5
... with all laundry chemicals and ...by the clothing manufacturer....washer is the legal responsibility of ownership, manual should be exercised when installing, maintaining or operating the washing machine.
Heed all cleaning...dry place according to an individual branch circuit. 13. Close supervision of least resistance for its intended purpose.
23. Use caution when draining hot water...
Installation and Use & Care (all languages) - Page 6
.... Please contribute to your washer. Valuable raw materials can tear/burst. In addition to damage the washing machine. Disposing of connection, the following may have the appliance connected by disposing of suffocation from locking themselves in the pump or water inlet hose(s) must be placed over the holes for drain hose. These installation instructions...
Installation and Use & Care (all languages) - Page 7
... or hot water pipes. q Loosen all four bolts before first use, run a cleaning cycle 15
Removing the... feet of the room. q Units are helpful: 1. in (155 sq. This appliance ...completely remove 4 shipping bolts
7
move the washer into place
connect the water supply line and
8
drain pipe
connect the electrical power
10
slide the washer into its final location 11
level the washer...
Installation and Use & Care (all languages) - Page 8
... 4 transport bolt assemblies (bolt, spring, washer and bushings) by an authorized technician. q If the bushings do not come out properly.
If in completely. Observe the water pressure in place and should be reĆ moved freely. S.
Check seal with the bolts, otherwise the bushings will not come out when removing the ...
Installation and Use & Care (all languages) - Page 9
... connection point with a screwdriver
Standpipe Installation
q Use a strap or cable tie to sink. q The hose and elbow should extend into a siphon
q Use the elbow. q Attach water drain hose securely to hold hose in the drain hole.
1. q When the water is being drained, check that the clamp will slide freely onto the...
Installation and Use & Care (all languages) - Page 10
....) g = 55.0 in. / 140 cm (approx.)
h = 24.0 in. / 60 cm (approx.) h = minimum drain point height
Other hoses
Available from the socket.
10
the wire size is properly
installed. Replacement power cords are stipulated on the washing... plate, see page 25). The plug must be connected to whether the washer has been properly grounded. the grounding system is sufficient. - Only this ...
Installation and Use & Care (all languages) - Page 11
...it indicates the high side of laundry in as far as possible, ... i If the test spin cycle is closer to one end,... for 10 seconds. Turn off the water. -
Preparing and inserting the transport ...Drain program to heklp reduce vibration. Make sure that corner until the end of the screw is inserted in its completion, then the door may be sure the level fits between the edges of the washer...
Installation and Use & Care (all languages) - Page 17
...-bleach must be safely washed with other laundry together. For adjusting the spin speed, see page 18. Regular/Cotton Cold Lightly soiled nonĆcolorfast fabric. Special programs
Delicates/Silks Delicates settings are particularly designed to drain water without a
spin cycle.
Soak
A cycle for use with this
cycle.
fabric softener, fabric conditioner. Do not overfill...
Installation and Use & Care (all languages) - Page 18
... Start time is recommended for best stain removal and cleaning results. Option buttons
Bleach
When this button is changed . The washing machine then heats the water to the set temperature all components of 19 hours (with other cycles when laundering normal or lightly soiled clothes. q Press two of the Option Buttons and hold until...
Installation and Use & Care (all languages) - Page 21
... that the strainer is necessary if very little or no leaks. q Reconnect the hose. q Rub dry with a pressure washer. q Insert the strainer and reconnect the hose. Cleaning the detergent dispenser If residual detergents or additives have formed due to any foreign objects (e.
Cleaning water inlet strainers This is properly attached. q Turn the program selector to...
Installation and Use & Care (all languages) - Page 23
... cannot eliminate the fault yourself with this fault recurs. Clean the water drainage pipe and/or drain hose. q Turn off and on the packaging.
Plug is blocked. A fuse has blown. Water cannot be seen in tub. Indicator light rinse" is lit and display is restored. Suds or pump is loose or not inserted. Leak in door...
Installation and Use & Care (all languages) - Page 24
...phosphateĆfree detergents contain waterĆinsol...263;speed spin cycle was not spun.
Always load the...clothing have become entangled and could not remove suds.
This is not a fault. Brush off , wait 5 seconds, switch the appliance on the packaging. Mix small and large laundry pieces in the drum.
Not enough detergent. This is dry. Too much soap or non-HE soap used, pump...
Installation and Use & Care (all languages) - Page 26
...this Statement of limited product Warranty applies only to the Bosch 300 Series washer ("Bosch") sold to you, the first using a
Bosch-...representatives of any kind; (4) a failure to comply with air or water-going vessels); (2) any applicable state, local, city, or county ... 100 miles from an authorized service provider) or is free from defects in materials and workmanship for Bosch to notify...
Installation and Use & Care (all languages) - Page 92
... duration in min. (approx.) *
Soak
Soak cycle is used to and during spinning.
9
Drain
To drain water after a program with a short spin.
120
Spin
Spin cycle for gentle treatment of delicate laundry.
2
* Actual program duration may be different from the indicated values depending on article! 92
Program selection table Nexxt 300 Series
Please read and observe Operating, Care and...
Similar Questions
Bosch Nexxt 300 Series Washer Will Not Spin Or Agitate.
Found on the internet to how to put into dervice mode, which I tried and received a P:01 and E:20 er...
Found on the internet to how to put into dervice mode, which I tried and received a P:01 and E:20 er...
(Posted by garrisonml 9 years ago)
Bosch Nexxt 300 Series Washer Water In Drum When Sitting
(Posted by niksaidyle 9 years ago)
Where Is The Bosch Nexxt 300 Series Washer Water Drain Hose Located
(Posted by najtoum 10 years ago)
How To Remove Front Access Panel On Bosch Nexxt 300 Series Washer
(Posted by eaaug 10 years ago)
How To Take A Pump Off A Bosch Nexxt 300 Series Washing Machine
(Posted by lilpodi 10 years ago)