Amana NTW4700YQ Support Question
Amana NTW4700YQ Support Question
Find answers below for this question about Amana NTW4700YQ.Need a Amana NTW4700YQ manual? We have 4 online manuals for this item!
Question posted by judyellingson411 on September 6th, 2015
Locked Lid
the red light is on in the lid lock,the lid is down and no cloths in the washer.Have tried holding the Start pause button in for 3 seconds and nothing happens. How do I unlock the lid?? Please and thanks...
Current Answers
Answer #1: Posted by TommyKervz on September 6th, 2015 1:06 PM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Follow the instructions on the link below
http://www.justanswer.com/appliance/6pcxz-washer-lid-locked-light-flashing-i-ve-held-pause.html
Related Amana NTW4700YQ Manual Pages
Installation Instruction - Page 2
...laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067 mm)
2 Tools needed:
Parts needed: (Not supplied with washer... and Parts Gather required tools and parts before starting installation. n 8212656RP n 8212641RP n 8212646RP n.... (1.2 m) Inlet hose, Black EPDM (2 pack) 5 ft. (1.5 m) Inlet hose, Red and Blue EPDM (2 pack) 5 ft. (1.5 m) Nylon braided inlet hose (2 pack)...
Installation Instruction - Page 3
... in .2 (155 cm2)
1" (25 mm)
1" (25 mm)
3" (76 mm)
Dimensions show recommended spacing allowed, except for walls, doors, and floor moldings. Top of laundry tub must support washer's total weight (with spacing of 0" (0 mm) clearance on back of installation and servicing, and spacing for companion appliances and clearances for closet door ventilation...
Installation Instruction - Page 4
...be provided. it and make sure lid is equipped with the sound shield to a gas pipe. Tip washer back and place on floor behind washer. Set washer upright. IMPORTANT: Removing shipping base ...adequate.
NOTE: To avoid floor damage, set washer onto cardboard before moving it must be in accordance with a qualified electrician if you start: remove shipping materials It is necessary to ...
Installation Instruction - Page 5
...Drain hose form
Firmly grasp power cord plug and pull to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from tray. You may need to step 6. Place drain ...into standpipe (shown in case you need additional parts with clamp. For a laundry tub or standpipe drain, go to move washer later.
4. NOTE: Keep tray in picture) or over console to allow ...
Installation Instruction - Page 6
...or replacement dates for a few seconds through hoses into a laundry tub, drainpipe, or bucket to washer correctly. It will cross over each other when attached correctly. .... Repeat this step with second hose for leaks.
In most standard configurations, hoses will drain later.
6 Use pliers to water faucets with new inlet hoses with a red ring.
n Periodically inspect and...
Installation Instruction - Page 7
... will support weight of sides.
12. Adjust leveling feet
Jam nut
Secure drain hose to prop up front of washer. Recheck levelness of front using lid, as needed. HELPFUL TIP: You may want to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with wooden block. Use side seam as a guide...
Installation Instruction - Page 8
... some models). Start washer and allow to see what was skipped. q Check that water faucets are now installed. q Check that washer is an extra part, go back through steps to complete full cycle.
8 q Read "Washer Use" in your washer, measure 1/2 of normal
recommended amount of your tools. Select any tape
remaining on .
Close lid. 16. Be...
Use and Care - Page 3
... softener dispenses at all as the lid lock goes through a self-test. The lid will not operate if the lid is started , the lid locks, unlocks, and locks again. During these cycles, you may take several seconds to several minutes for the lid to a spray rinse. IMPORTANT: ■■ Washer will only unlock after this point, you try to pause, it may hear nothing at...
Use and Care - Page 4
... motor turning on . Press and hold for even distribution.
4 WASH CYCLE KNOB
Use the Wash Cycle knob to select a cycle for best results. Press START/Pause/Unlock Lid again to pause the cycle and unlock the lid. Turn the knob to select available cycles on , the lid is paused.
When this light is blinking, the washer is locked and cannot be set to...
Use and Care - Page 5
... Be sure to set Fabric Softener knob to YES, if adding fabric softener to wash lightly soiled loads of the washer. High Use this cycle to load. *All rinses are available on the care label... Use this cycle combines periods of no-iron fabrics such as sport shirts, blouses, casual business clothes, permanent press, and blends.
This cycle features a spray rinse. CYCLE GUIDE
For best fabric...
Use and Care - Page 6
...lightly soiled.
■■ Separate delicate garment from lint-givers. Add a measured amount of the washer basket before adding clothes.
IMPORTANT: Follow the manufacturer's instructions to determine the amount of the washer....
■■ Turn knits inside out to your laundry
2. USING YOUR WASHER
1. Loose change, buttons, or any small object can set stains into the bottom...
Use and Care - Page 7
...
Turn cycle knob to YES. Try mixing different sized items to start the washer.
IMPORTANT: Fabric Softener option knob must be set Fabric Softener option knob to choose your load size.
load them in the same cycle with warm water until the washer has completed filling, press the START/Pause/Unlock Lid button to Wash Load
During the final...
Use and Care - Page 8
.... Filling is delayed for 2 to 3 minutes to check for your previous washer provided. Promptly remove garments after cycle has completed to filling.
Delay in water...or fade
Light soils
Press the START/Pause/Unlock Lid button to restart the cycle. Colors that bleed or fade Light soils
9. 7. If your garments. Then close lid and press START/Pause/Unlock Lid again to start the wash...
Use and Care - Page 9
... and towel dry.
Do not attempt to start the cycle.
Use this procedure. g. Press the START/Pause/Unlock Lid button to remove the dispensers or trim for cleaning the inside of the washer. Chlorine Bleach Procedure (Alternative): a. Open the washer lid and remove any clothing or items. b. Place an affesh® Washer Cleaner tablet in the washer's dispensers. After the cycle has...
Use and Care - Page 10
... antifreeze, if used. Use half the manufacturer's recommended amount of washer. Turn on both water faucets. Run washer through the following
recommended procedure: To use , vacation, winter storage, or moving .
3. Close lid and place tape over edge and into basket opening.
TRANSPORTING YOUR WASHER
1. Disconnect and drain water inlet hoses.
2. Drape power cord over...
Use and Care - Page 11
... Your Washer" for proper installation:
Fill hoses not attached tightly. If you have started the washer. Washer may splash... humming sound with the floor and locked. Jam nuts must be tight against...Washer" section
Feet may be turned on clothing such as expected
Washer won't run or fill, washer stops working or wash light remains on .
Noises
See "Cycle Guide" and "Using Your Washer...
Use and Care - Page 12
...Close lid and press START/Pause/Unlock Lid. Add only 1 or 2 additional garments after washer has started.
See "Using Your Washer" for balanced spinning. TROUBLESHOOTING
First try ...Washer not draining/ spinning, loads are still wet or spin light remains on (indicating that the washer was unable to run or fill, washer stops working or wash light remains on (indicating that the washer...
Use and Care - Page 14
... a higher soil level cycle option and warmer wash temperature to YES when using the START/ Pause/Unlock Lid button. Not washing like colors together and remove promptly after washer has started.
Odors
Monthly maintenance not done as cycle is not closed. Unload washer as soon as recommended.
Incorrect dispenser operation
Fabric damage
Not using correct cycle for fabric...
Use and Care - Page 15
... to parts or systems resulting from unauthorized modifications made to repair or replace appliance light bulbs, air filters, or water filters.
Some states and provinces do not allow...brand appliances. You can be provided by a company designated by the customer. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is...
Warranty - Page 1
... you on the product. Dealer name Address Phone number Model number Serial number Purchase date
15 WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is inconsistent to published... under these limitations and exclusions may not apply to repair or replace appliance light bulbs, air filters, or water filters.
Similar Questions
Amana Washer Ntw4700yq1
Amana Washer NTW4700YQ1 runs through a cycle then starts again a new cycle ,,, the starter button se...
Amana Washer NTW4700YQ1 runs through a cycle then starts again a new cycle ,,, the starter button se...
(Posted by shadesofbling 8 years ago)
Amana 7300 When I Start It It Locks Then Does Nothing For Several Minutes
after several minutes the alarm chimes and I can push power to open the door
after several minutes the alarm chimes and I can push power to open the door
(Posted by trace0726 9 years ago)
Does The Amana Ntw4700yq1 Have A Security Lock
The final spin doesn´t work properly. When the cycle complete light turns on the clothes still...
The final spin doesn´t work properly. When the cycle complete light turns on the clothes still...
(Posted by cfp0302 10 years ago)
Washer Drained After Pause
I had to pause my washer about 1 minute after it started washing to make sure I had put the detergen...
I had to pause my washer about 1 minute after it started washing to make sure I had put the detergen...
(Posted by kevojones 11 years ago)
