Amana NTW4700YQ Support Question
Amana NTW4700YQ Support Question
Find answers below for this question about Amana NTW4700YQ.Need a Amana NTW4700YQ manual? We have 4 online manuals for this item!
Question posted by cfp0302 on December 8th, 2013
Does The Amana Ntw4700yq1 Have A Security Lock
The final spin doesn´t work properly. When the cycle complete light turns on the clothes still has water.
Current Answers
Related Amana NTW4700YQ Manual Pages
Installation Instruction - Page 2
... space saving 90° elbow, hypro-blue steel couplings (2 pack)
Alternate parts: (Not supplied with washer)
Adjustable or open end wrench 9/16" (14 mm)
4" min (102 mm)
Level
Wood block
...Number 367031 Connector Kit Part Number 285835
LOCATION REQUIREMENTS
Select proper location for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
...
Installation Instruction - Page 3
...Water remaining in washer after use may be needed.)
Laundry tub drain system
Minimum capacity: 20 gal. (76 L). Minimum carry-away capacity: 17 gal. (64 L) per minute. If you must be inside standpipe or below 32° F (0° C). Consider allowing more than 96" (2.44 m), you need a sump pump system. Secure... washer. DRAIN SYSTEM
Drain system can be purchased separately. Proper ...
Installation Instruction - Page 4
... of its final location; n Do not have a fuse in accordance with a qualified electrician if you start: remove shipping materials It is necessary to remove all shipping materials for proper operation. it ...local codes and ordinances. NOTE: To avoid floor damage, set washer onto cardboard before moving it is necessary for proper operation and to a gas pipe. IMPORTANT: Removing shipping base is...
Installation Instruction - Page 5
Be sure to move washer later.
4. For a laundry tub or standpipe drain, go to free from tub. See "Tools and Parts".
6. IMPORTANT: 4.5" (113 mm) of drain hose onto black drain port and secure with clamp. Remove packing tray from tray. NOTE: Keep tray in Step 7. Squeeze clamp with separate directions.
Drain hose form must...
Installation Instruction - Page 6
... attached correctly. Connect inlet hoses to water faucets
Run water for a few seconds through hoses into a laundry tub, drainpipe, or bucket to hot water faucet. Connect inlet hoses to washer
Attach hose to prevent clogs. HELPFUL TIP: Make note of water may need to water faucets with new inlet hoses with flat washers (not provided).
Screw on coupling...
Installation Instruction - Page 7
.... HELPFUL TIP: You may want to make sure all four feet make solid contact with wooden block. Check levelness of front using lid, as needed. Secure drain hose
Laundry Tub
Standpipe
Wall
14.
Rock washer back and forth to prop washer with floor. Level Washer
IMPORTANT: Level washer properly to step 14.
Installation Instruction - Page 8
... tools. q To test and clean your Washer User Instructions. 16. q Check that water faucets are now installed. q Read "Washer Use" in your washer, measure 1/2 of normal
recommended amount of washer. Start washer and allow to see what was skipped. q Check that washer is an extra part, go back through steps to complete full cycle.
8 q Remove protective film from back...
Use and Care - Page 3
... lid to enter the basket. There will turn on when in fill could take 2-3 minutes before water begins to add a garment after washer movement has stopped.
During these cycles, you will hear water enter the washer as the agitator tests for higher spin speeds, the lid will lock and the Lid Locked light will be opened .
When this point, you...
Use and Care - Page 4
... to YES. NOTE: If the washer is complete, this light is pressed, the washer will come on the lid lock mechanism. The lid will use spins to select available cycles on the selected cycle and spin speed.
5 START/PAUSE/UNLOCK LID BUTTON Press to select a cycle for your previous washer provided.
■■ Even in rinse water for load balance. Press START...
Use and Care - Page 5
... and high speed spin for heavily soiled cottons and mixed fabric loads.
This cycle features a spray rinse. Use this cycle to complete a load after a power failure.
This cycle features a spray rinse. Low Low
Use this cycle to drain washer after cancelling a cycle or completing
a cycle after power interruption. This cycle features a spray rinse. This cycle features a spray rinse...
Use and Care - Page 6
....
NOTE: Always read and follow fabric care label instructions to avoid damage to your laundry
2. IMPORTANT: Follow the manufacturer's instructions to determine the amount of the washer basket before adding clothes. Helpful Tips:
■■ When washing water-proof or water-resistant garments, load evenly.
■■ Use mesh garment bags to help avoid tangling...
Use and Care - Page 7
... warm water until the washer has completed filling, press the START/Pause/Unlock Lid button to reduce tangling.
Close the lid and press the START/ Pause/Unlock Lid button again to spill, splash, drip, or run into washer
5. Load laundry into the basket or on your wash cycle. MAX FILL
Dilute liquid fabric softener by filling...
Use and Care - Page 8
... are cold. When the cycle has finished, the CYCLE COMPLETE indicator will unlock once the washer movement has stopped. Delay in water fill Filling is added to check for 2 to 3 minutes to save energy.
Promptly remove garments after cycle has completed to restart the cycle. Suggested Fabrics
Dark colors that bleed or fade
Light soils
Press the START/Pause...
Use and Care - Page 9
...when following this recommended monthly cleaning procedure:
Recommended Cycle for Cleaning the Washer
Refer to the "Cycle Guide" for the optimal cycle for a period of time, follow these instructions completely before or after 5 years of the washer. After the cycle has stopped, run the Clean Washer cycle. Shut off water supply to washer, to avoid flooding due to mix antifreeze and...
Use and Care - Page 11
... hum of the cabinet. to drainpipe or laundry tub. Empty pockets before water is not level. Humming
Fill light is not unbalanced or tightly packed.
Pull drain hose from washer cabinet and properly secure it to operate properly.
Improper loading can restrict water flow.
11 Adding wet garments to washer or adding more water to reduce imbalance. You may not...
Use and Care - Page 12
... garments after washer has started. Washer not draining/ spinning, loads are still wet or spin light remains on (indicating that the washer was unable to pump out water within 10 minutes)
Empty pockets and use an extension cord. Cycles with high spin speeds. To remove extra water in basket, and add detergent. Use drain hose form and securely
drain hose installation...
Use and Care - Page 13
...water flowing to develop dry spots during the final spin can keep washer from operating correctly. Use cycle designed for the fabrics being washed. items will be attached to both washer and faucet, and have water...or visit our website at www.amana.com/help for assistance and to match your previous washer.
Load not rinsed
Check for proper water supply.
Always measure detergent and ...
Use and Care - Page 14
...cycle. Use cycle designed for tough cleaning. Add only 1 or 2 additional garments after the cycle is tightly packed. Liquid chlorine bleach may still be spinning.
Unload washer as soon as cycle is not closed.
The washer will not unlock until the basket has stopped spinning...to improve cleaning. Lid Locked light is flashing
The lid is complete.
The washer may have been
Mend...
Use and Care - Page 15
...call : 800-807-6777 for Amana, Admiral, Estate, Inglis, ...in your authorized Whirlpool, Amana, Admiral, Estate, Inglis...800-843-0304 for Amana brand products; 800-688... light bulbs, air filters, or water...is inconsistent to service Amana, Admiral, Estate, ...Amana, Admiral, Estate, Inglis, or Roper brand appliances. WHIRLPOOL CORPORATION LAUNDRY... appliances with the product, Amana, Admiral, Estate, Inglis...
Warranty - Page 1
...is required to repair or replace appliance light bulbs, air filters, or water filters. Service calls to obtain service... installation date for Amana, Admiral, Estate, Inglis, or Roper brand products.
1/12
Keep this book and your complete model number and serial...made to determine if another warranty applies. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of...
Similar Questions
After An Unbalanced Load, Washer Will Not Work Properly...what Can I Do?
I've tried method of resetting motor. I've also tried moving the dial to the left and to the right a...
I've tried method of resetting motor. I've also tried moving the dial to the left and to the right a...
(Posted by heenanbetty 6 years ago)
It Will Not Unlock When It Is Done
the washer will not unlock when it is done
the washer will not unlock when it is done
(Posted by kathiestevenson 8 years ago)
Amana Washer Ntw4700yq1
Amana Washer NTW4700YQ1 runs through a cycle then starts again a new cycle ,,, the starter button se...
Amana Washer NTW4700YQ1 runs through a cycle then starts again a new cycle ,,, the starter button se...
(Posted by shadesofbling 8 years ago)
Locked Lid
the red light is on in the lid lock,the lid is down and no cloths in the washer.Have tried holding t...
the red light is on in the lid lock,the lid is down and no cloths in the washer.Have tried holding t...
(Posted by judyellingson411 8 years ago)
Washer Drained After Pause
I had to pause my washer about 1 minute after it started washing to make sure I had put the detergen...
I had to pause my washer about 1 minute after it started washing to make sure I had put the detergen...
(Posted by kevojones 11 years ago)