Amana NTW4700YQ Support Question
Amana NTW4700YQ Support Question
Find answers below for this question about Amana NTW4700YQ.Need a Amana NTW4700YQ manual? We have 4 online manuals for this item!
Question posted by kevojones on January 4th, 2013
Washer Drained After Pause
I had to pause my washer about 1 minute after it started washing to make sure I had put the detergent in. When I restarted it, it drained completely, refilled, and started the whole wash cycle over again. This thing is supposed to be a water saver, but I can tell it is using more water because it won't wash and rinse more than a very small load. Very poor engineering...
Current Answers
Related Amana NTW4700YQ Manual Pages
Installation Instruction - Page 2
... parts before starting installation. To order, please refer to toll-free phone numbers on back page of your washer to 19⁄16" (39.5 mm)
Optional tools:
Flashlight
Bucket
Parts supplied:
NOTE: All parts supplied for your Use and Care Guide. Install your Use and Care Guide.
Beaded tie strap
Drain hose with...
Installation Instruction - Page 3
... wash tub.
Water remaining in washer after use may cause damage in temperatures below the top of washer. IMPORTANT: To avoid siphoning, no more space for walls, doors, and floor moldings. n A level floor with beaded tie strap.
3 Floor standpipe drain system
IMPORTANT: Do not install, store, or operate washer where it will be needed.)
Laundry tub drain...
Installation Instruction - Page 4
...; n Check with a qualified electrician if you start: remove shipping materials It is necessary to remove all shipping materials for proper operation. n Do not have a fuse in the neutral or ground circuit.
48" (1.2 m)
Move washer to have the properly grounded outlet installed by a qualified electrician. it and make sure lid is taped shut.
2. NOTE: To...
Installation Instruction - Page 5
... to move washer later.
4. 3.
You may need to back of washer.
4.5" (113 mm)
Place hose into standpipe or lay on bottom of drain hose onto black drain port and secure with separate directions. For a laundry tub or standpipe drain, go to remove all parts from rear panel.
Drain hose form must be inside standpipe; Be sure to step...
Installation Instruction - Page 6
...to check for a few seconds through hoses into a laundry tub, drainpipe, or bucket to remove the drain hose form from the end of hose failure, replace... the hoses every 5 years. Use pliers to a cold water faucet, you must use a Y-adapter (not provided).
8. HELPFUL TIP: Make note of water may need to prevent clogs. You may enter washer...
Installation Instruction - Page 7
... on leveling feet tightly against washer cabinet. Rock washer back and forth to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with wooden block.
Not Level
LEVEL
Not Level
7
When washer is level, skip to raise the washer. Adjust leveling feet
Jam nut
Secure drain hose to make sure all four feet make solid contact with a wood...
Installation Instruction - Page 8
... CHECKLIST
q Check electrical requirements.
Plug into washer basket or detergent dispenser (on washer. Be sure you have correct electrical supply and recommended grounding method. q Check that all packaging materials. q Check that washer is an extra part, go back through steps to complete full cycle.
8 q To test and clean your Washer User Instructions. q Check that water faucets...
Use and Care - Page 2
WASHER SAFETY
2
Use and Care - Page 3
... will lock and the Lid Locked light will operate differently than your previous washer. Sounds
At different stages of spins to a spray rinse. During these cycles, you try to pause, it may take 2-3 minutes.
■■ Fabric Softener option must press START/Pause/Unlock Lid and wait for the lid to penetrate clothes. When this time...
Use and Care - Page 4
... your washer. After draining and spinning out wash water, the washer will add the most cycles and must be set to open the lid, press START/Pause/Unlock Lid.
Items need to YES. At each stage of water for smaller loads and Large will continue to spin and spray in the cycle. These spins may take several minutes if...
Use and Care - Page 5
... loads requiring an additional rinse cycle or to drain washer after cancelling a cycle or completing
a cycle after power interruption. NOTE: Use mesh garment bags as sport shirts, blouses, casual business clothes, permanent press, and blends.
Items to wash lightly soiled loads of no -iron fabrics, cottons, perm press, linens, synthetics
Large items such as sheets, small comforters...
Use and Care - Page 6
...;■ When washing water-proof or water-resistant garments, load evenly.
■■ Use mesh garment bags to help avoid tangling when washing delicate or small items.
■■ Turn knits inside out to your laundry
2. If using an Oxi or color-safe bleach laundry boost product, add to the bottom of detergent to garments...
Use and Care - Page 7
...softener into the basket or on your wash cycle. IMPORTANT: Fabric Softener option knob must be set Fabric Softener option knob to Wash Load
During the final rinse, wait ...same cycle with warm water until the washer has completed filling, press the START/Pause/Unlock Lid button to spill, splash, drip, or run into dispenser;
Do not allow liquid fabric softener to pause the washer....
Use and Care - Page 8
... and press START/Pause/Unlock Lid again to move freely.
8. Delay in soil removal and to check for several minutes if the load was spinning at high speed. If your previous washer provided. Select WASH TEMPERATURE
If you are cold. Wash Temperature
Hot
Some cold water is normal operation.
8
When the cycle has finished, the CYCLE COMPLETE indicator will...
Use and Care - Page 9
... control the rate at which detergent and soil residue accumulate inside of the washer. When replacing your washer. This Washer Maintenance Procedure should be performed, at a minimum, once per month or every 30 wash cycles, whichever occurs sooner, to
water pressure surge.
d. Do not add any spills.
If cycle must be interrupted, press START/Pause/Unlock Lid once or...
Use and Care - Page 10
... moved during freezing weather, follow "Winter Storage Care" directions before moving : 1. Place inlet hoses and drain hose inside washer. Before using again, run washer through Casual Regular cycle to locate, level, and
connect washer. 2. TRANSPORTING YOUR WASHER
1. Disconnect drain hose from back of detergent for a medium-size load.
10 Refer to "Installation Instructions" to clean...
Use and Care - Page 11
...) piece of water are properly seated. to drainpipe or laundry tub. Check floor for loading instructions.
Use the Normal Regular cycle and select Large Load Size for oversized, non-absorbent garments such as final amounts of plywood under your washer will take several minutes before washing.
It is normal to be turned on . Tighten fill...
Use and Care - Page 12
... Drain/Spin cycle to slow or extra suds, select Rinse/Spin. Check plumbing for correct Check drain hose for balanced spinning. attach to outlet. Do not add detergent. stop draining and spinning.
12
Remove several minutes before filling to possibly avoid a service call. Close lid and press START/Pause/Unlock Lid. Add only 1 or 2 additional garments after washer has started...
Use and Care - Page 13
... load after washer has started .
The washer is tightly packed. Select the Rinse/Spin cycle. Adding detergent on . Choose a Load Size that matches the load being washed.
Both hoses must be attached and have both washer and faucet, and have water flowing to the bottom of garments being washed. Load not rinsed
Check for proper water supply. Make sure hot...
Use and Care - Page 14
... minutes if washing large loads or heavy fabrics.
14
Fabric damage can keep washer from too much detergent can occur if load is complete to avoid dye transfer.
Add only 1 or 2 additional garments after the cycle is tightly packed.
Using too much detergent.
Use Normal Heavy cycle for fabric type. Incorrect dispenser operation
Fabric damage
Not using the START/ Pause...
Similar Questions
Nfw7300ww02 Amana Front Load Washer Will Not Spin Fast.
NFW7300WW02 front load washer will not spin fast enough to remove the water with a normal size load ...
NFW7300WW02 front load washer will not spin fast enough to remove the water with a normal size load ...
(Posted by rtdk 3 years ago)
It Will Not Unlock When It Is Done
the washer will not unlock when it is done
the washer will not unlock when it is done
(Posted by kathiestevenson 8 years ago)
Amana Washer Ntw4700yq1
Amana Washer NTW4700YQ1 runs through a cycle then starts again a new cycle ,,, the starter button se...
Amana Washer NTW4700YQ1 runs through a cycle then starts again a new cycle ,,, the starter button se...
(Posted by shadesofbling 8 years ago)
Why Does The Machine Drain When I Pause It During It's Wash Cycle?
(Posted by stevendooley 11 years ago)