Amana NTW4700YQ Support Question
Amana NTW4700YQ Support Question
Find answers below for this question about Amana NTW4700YQ.Need a Amana NTW4700YQ manual? We have 4 online manuals for this item!
Question posted by Alisaorosco56 on November 20th, 2015
Ot Will Mot Drain Stopped Woth No Npise Full Of Waterpush The Start Button Nothi
It will not drain my amana washwr no warning and is full of water push start button npthing the lid wont lock whats wron
Current Answers
Answer #1: Posted by Odin on November 20th, 2015 11:11 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,680
Member since:
April 10th, 2010 Points: 41,236,680
Sorry, but I can't follow your question. It's likely however that one or more of the links on this page will help.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Amana NTW4700YQ Manual Pages
Installation Instruction - Page 2
...
Lint clogged drain
Drain Protector Part Number 367031 Connector Kit Part Number 285835
LOCATION REQUIREMENTS
Select proper location for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067 mm)
2
INSTALLATION REQUIREMENTS
Tools and Parts Gather required tools and parts before starting installation.
Installation Instruction - Page 3
... should be at least 39" (990 mm) high;
install no higher than 4.5" (113 mm) of laundry tub must be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. n A level floor with water and load) of washer. n Floor must install higher than 96" (2.44 m) from bottom of 315 lbs (143 kgs).
To order, please...
Installation Instruction - Page 4
...the washer is necessary to remove all shipping materials for proper operation. Move washer
n A 120 volt, 60 Hz., AC only, 15-
n Do not ground to install it and make sure lid is ... in a fully upright position. If your washer includes a sound shield, please refer to the instructions included with a qualified electrician if you start: remove shipping materials It is properly grounded.
Installation Instruction - Page 5
.... You may need to back of drain hose onto black drain port and secure with separate directions. Drain hose form must be inside standpipe; NOTE: Keep tray in place on bottom of laundry tub. Place drain hose in Step 7. Squeeze clamp with pliers and slide black elbow end of washer.
4.5" (113 mm)
Place hose into standpipe...
Installation Instruction - Page 6
... check for leaks.
IMPORTANT: To reduce risk of the drain hose.
Check for a few seconds through hoses into a laundry tub, drainpipe, or bucket to washer correctly. See "Tools and Parts". If you are found.
11.
HELPFUL TIP: Make note of water may need to hot water inlet valve marked with separate directions.
n Periodically inspect and...
Installation Instruction - Page 7
..., place a level on feet until they are about 4" (102 mm) with wooden block.
Rock washer back and forth to turn jam nuts counterclockwise on leveling feet tightly against washer cabinet.
Secure drain hose
Laundry Tub
Standpipe
Wall
14. 12.
If washer is level, use a 9/16" or 14 mm open -end or adjustable wrench to make...
Installation Instruction - Page 8
...from back of /recycle all parts are on some models). q Check that water faucets are now installed. q Dispose of washer. Select any tape
remaining on washer.
Start washer and allow to see what was skipped. q Check that you have all ... electrical supply and recommended grounding method.
Close lid. 16. If there is plugged into washer basket or detergent dispenser (on .
Use and Care - Page 2
WASHER SAFETY
2
Use and Care - Page 3
... -balance load.
Spray Rinse
Select cycles default to several seconds to a spray rinse. WHAT'S NEW UNDER THE LID? When this light is started , the lid locks, unlocks, and locks again. Sensing
This washer will hear water enter the washer as the lid lock goes through a self-test. For example, you will perform a series of the cycle as the tub spins...
Use and Care - Page 4
... the washer movement has stopped. After draining and spinning out wash water, the washer will be cooler than what your washer. The wash time is normal. press again to resume the cycle. When this light is blinking, the washer is locked and cannot be set to the wash cycle as the washer rinses and moves the load. The lid will...
Use and Care - Page 5
....
NOTE: Be sure to set Fabric Softener knob to YES, if adding fabric softener to drain washer after cancelling a cycle or completing
a cycle after power interruption. High Use this cycle for ...blends. Use this
cycle to load. *All rinses are available on the care label. See Washer Care.
Use this cycle for normally soiled cottons and mixed fabric loads.
Similar to the way...
Use and Care - Page 6
Loose change, buttons, or any small object can set stains into the bottom of detergent...water temperature, and colorfastness.
■■ Separate heavily soiled garments from lightly soiled.
■■ Separate delicate garment from lint-givers. Sort and prepare your garments. Add a measured amount of the washer basket before adding clothes. If using an Oxi or color-safe bleach laundry...
Use and Care - Page 7
... option knob to move freely for correct amount of liquid fabric softener into washer.
Load laundry into the basket or on some models)
Load garments in the same cycle with warm water until the washer has completed filling, press the START/Pause/Unlock Lid button to ensure proper distribution of the fabric softener during the rinse portion...
Use and Care - Page 8
... setting. This may be added to assist in water fill Filling is normal operation.
8 Delay in soil removal and to start the wash cycle. You will unlock once the washer movement has stopped. Suggested Fabrics
Dark colors that bleed or fade
Light soils
Press the START/Pause/Unlock Lid button to help dissolve detergent. Small will add...
Use and Care - Page 9
... detergent accumulate.
3. A lways leave the washer lid open between uses to the bleach compartment.
g. Press the START/Pause/Unlock Lid button to use. If cycle must be interrupted, press START/Pause/Unlock Lid once or twice (depending on the label with a permanent marker. After the cycle has stopped, run
washer on model). Close the washer lid. e. Select the cycle recommended for...
Use and Care - Page 10
... faucets.
2. Place inlet hoses and drain hose inside washer. Keep lid taped until washer is placed in washer or reconnect power.
3. Flush water pipes and hoses.
Unplug power cord.
5. If you do not have packing tray, place heavy blankets or towels into washer basket.
7.
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again: 1. Drape power cord...
Use and Care - Page 11
... fill, washer stops working or wash light remains on . Use the Normal Regular cycle and select Large Load Size for leaks (laundry tubs, drain pipe, water pipes,
drain.
for assistance and to possibly avoid a service call for any kinks in inlet hoses, which can cause basket to basket could be level with the floor and locked. You...
Use and Care - Page 12
... continue, contact an electrician. Do not interrupt cycle. Washer spins the dry load for assistance and to pump out water within 10 minutes)
Empty pockets and use an extension cord. Close lid and press START/Pause/Unlock Lid. Add only 1 or 2 additional garments after washer has started. Washer not draining/ spinning, loads are still wet or spin light remains...
Use and Care - Page 13
... from operating correctly. Not cleaning or removing stains
Washer not loaded as recommended.
Add only 1 or 2 additional garments after washer has started . TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.amana.com/help for proper water supply.
Select the Rinse/Spin cycle.
Washer is less efficient at rinsing when load is...
Use and Care - Page 14
... softener dispenser.
Do not use more than recommended by manufacturer.
If you experience
Possible Causes
Washer not performing as expected (cont.)
Solution
Not cleaning or removing stains (cont.)
Using too much detergent. Not using the START/ Pause/Unlock Lid button. Clogged dispenser.
Wipe up bleach spills. Always measure detergent and follow manufacturer's directions based...
Similar Questions
Locked Lid
the red light is on in the lid lock,the lid is down and no cloths in the washer.Have tried holding t...
the red light is on in the lid lock,the lid is down and no cloths in the washer.Have tried holding t...
(Posted by judyellingson411 8 years ago)
Beeping And Stop Working
i have one of these machines but i had the problem that it stop and start beeping so i open under wh...
i have one of these machines but i had the problem that it stop and start beeping so i open under wh...
(Posted by larturolrodarte 9 years ago)
Washer Drained After Pause
I had to pause my washer about 1 minute after it started washing to make sure I had put the detergen...
I had to pause my washer about 1 minute after it started washing to make sure I had put the detergen...
(Posted by kevojones 11 years ago)
Why Does The Machine Drain When I Pause It During It's Wash Cycle?
(Posted by stevendooley 11 years ago)
Start Up
I just bought the new Amana washing machine model NTW4501XQ and i cant even start it i selected the ...
I just bought the new Amana washing machine model NTW4501XQ and i cant even start it i selected the ...
(Posted by Selizondo7 11 years ago)