Amana NTW4600YQ Support Question
Amana NTW4600YQ Support Question
Find answers below for this question about Amana NTW4600YQ.Need a Amana NTW4600YQ manual? We have 4 online manuals for this item!
Question posted by wmccabe on October 7th, 2014
Ntw4501xqo Washer Dial Does Not Move Will Not Spin Or Wash
The person who posted this question about this Amana product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Amana NTW4600YQ Manual Pages
Installation Instruction - Page 2
... in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067 mm)
2
Install your washer to toll-free numbers on back page...° elbow, hypro-blue steel couplings (2 pack)
Alternate parts: (Not supplied with flat washers
To order, please refer to 19⁄16" (39.5 mm)
Optional tools:
Flashlight
Bucket
Parts supplied:
NOTE:...
Installation Instruction - Page 3
...laundry tub must install higher than 4.5" (113 mm) of washer. Consider allowing more than 96" (2.44 m), you must be at least 39" (990 mm) high; Add spacing of 1" (25 mm) on all sides of washer to weather or in temperatures below the top of wash... Hose (Part Number 285863) that may cause damage in washer after use may be needed.)
Laundry tub drain system
Minimum capacity: 20 gal. (76 ...
Installation Instruction - Page 4
...have a fuse in the neutral or ground circuit.
48" (1.2 m)
Move washer to avoid excessive noise from shipping carton on cardboard supports. n Do not ground to remove ...the properly grounded outlet installed by a qualified electrician. Tip washer back and place on floor behind washer. Remove shipping base. n This washer is equipped with a qualified electrician if you start: remove...
Installation Instruction - Page 5
...Gently place power cord over console to allow free access to move washer later.
4. Attach drain hose to remove all parts from rear panel. Be sure to drain port
...Remove tape from washer lid, open lid and remove cardboard packing tray from tub
Connect Drain Hose
5. Squeeze clamp with pliers and slide black elbow end of laundry tub.
3. Free power cord
If ...
Installation Instruction - Page 6
...form (floor drain installations only)
9. Do not use old hoses. Use pliers to faucets or washer. It will cross over each other when attached correctly. Screw on valve when attaching to tighten ... water for future reference. You may enter washer. Record hose installation or replacement dates for a few seconds through hoses into a laundry tub, drainpipe, or bucket to hot water faucet.
Installation Instruction - Page 7
... its final location, place a level on feet until they are about 4" (102 mm) with wooden block. When washer is not level, use a 9/16" or 14 mm open -end or adjustable wrench to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with floor. HELPFUL TIP: You may want to prop...
Installation Instruction - Page 8
... allow to see what was skipped. If there is plugged into a grounded 3 prong outlet
Complete Installation CHECKLIST
q Check electrical requirements. q Dispose of/recycle all of washer. q Check that water faucets are now installed. Be sure you have correct electrical supply and recommended grounding method. Plug into a grounded 3 prong outlet. 16.
q Check...
Use and Care - Page 2
WASHER SAFETY
2
Use and Care - Page 3
... only unlock after this light is blinking, the washer is complete. WHAT'S NEW UNDER THE LID?
When this time, a series of spins to enter the basket. During this light is locked and cannot be opened . Sounds
At different stages of the wash cycle, you try to pause, it may take several seconds to...
Use and Care - Page 4
... on all features and options are different from traditional washers. After draining and spinning out wash water, the washer will be opened .
For best results and following ...washed.
Select a wash temperature based on , the lid is paused. press again to select a cycle for your laundry load. When this light will turn on briefly (short hum) to the wash cycle as the washer...
Use and Care - Page 5
... and items requiring rinsing without detergent
Dripping wet or hand-washed items
Delicate Regular
Delicate Light
Handwash
Rinse/ Spin
Drain/ Spin
Wash Temperature*:
Hot Warm Cool Cold
Hot Warm Cool Cold
Hot Warm Cool Cold
Spin Speed:
Low
Cycle Details:
Use this cycle to drain washer after cancelling a cycle or completing
a cycle after power interruption. High...
Use and Care - Page 6
...trim and ornaments.
■■ Mend rips and tears to avoid further damage to garments during washing. USING YOUR WASHER
1. Synthetics, knits, and corduroy fabrics will pick up lint from sturdy fabrics.
■■ Do not... from lint-givers. If using an Oxi or color-safe bleach laundry boost product, add to your laundry
2. Add a measured amount of detergent to avoid pilling.
Use and Care - Page 7
...pack or force items into the basket or on your wash cycle. Then set to YES to spill, splash, drip, or run into washer. Do not allow liquid fabric softener to ensure proper ...distribution of the fabric softener during the rinse portion of the rim. Load laundry into dispenser; Pour a measured...
Use and Care - Page 8
... odor, reduce wrinkling, and rusting of the spin prior to filling.
This is the temperature from your faucet. Select LOAD SIZE
Wash Temperature
Cold
This is normal operation.
8 Suggested...add 1 or 2 missed garments:
Press START/Pause/Unlock Lid; If your previous washer provided. Select WASH TEMPERATURE
If you need to help dissolve detergent.
NOTE: Always read and follow ...
Use and Care - Page 9
... Lid once or twice (depending on RINSE/SPIN cycle for about 30 seconds to rinse cleaner from washer. e. Select the cycle recommended for cleaning the inside your washer, which in turn may result in undesirable odor.
2. U se warm and hot wash water settings sometimes (not exclusively cold water washes), because they do not use . The...
Use and Care - Page 11
...operate properly.
Washer not performing as expected
Washer won't run or fill, washer stops working or wash light remains on...washer cabinet and properly secure it to basket could unbalance washer.
Check floor for leaks (laundry tubs, drain pipe, water pipes,
drain.
Do not tightly pack.
Check all four fill hose flat washers are removed during the Drain/Spin...
Use and Care - Page 12
... press START/Pause/Unlock Lid.
Check plumbing for correct Check drain hose for washer to run or fill, washer stops working or wash light remains on (indicating that the washer was unable to spin correctly, leaving the load wetter than cycles with a low spin speed. attach to possibly avoid a service call. TROUBLESHOOTING
First try the solutions...
Use and Care - Page 13
.... Select a cycle with dry items only. Make sure hot and cold inlet hoses are not reversed.
See "Using Your Washer" section.
Energy saving controlled wash temperatures. Load with a slower wash action and spin speed;
on washer may require additional rinsing.
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.amana.com...
Use and Care - Page 14
...instructions.
A cycle was stopped or paused using dispensers.
The washer will not unlock until the basket has stopped spinning. The lid will not start or fill with the best ... with the lid open. If you experience
Possible Causes
Washer not performing as recommended. Sharp items were in seams before starting wash load.
Use cycle designed for tough cleaning.
Garment care...
Energy Guide - Page 1
... therm.
• For more information, visit www.ftc.gov/appliances. (P/N W10062977)
Clothes Washer Capacity: Standard
Maytag Models: NTW4600Y*, NTW4700Y*
Cat. V0Xq8EUA(3B)
Estimated Yearly Operating Cost
... range based only on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per kWh and ...
Similar Questions
Nfw7300ww02 Amana Front Load Washer Will Not Spin Fast.
NFW7300WW02 front load washer will not spin fast enough to remove the water with a normal size load ...
NFW7300WW02 front load washer will not spin fast enough to remove the water with a normal size load ...
(Posted by rtdk 3 years ago)
Washer Shakes Wildly ,drum Banging On Cover,during Beginning Of Spin Cycle.
washer shakes wildly.
washer shakes wildly.
(Posted by MALSWORD 7 years ago)
Won't Spin.
It won't spin out. Only have had it for barely 2 years.
It won't spin out. Only have had it for barely 2 years.
(Posted by ambercrichmond 8 years ago)
When Washer Goes Into Cycle To Fill And Then The Lid Lock Is Suppose To Engage
When you start washer the fill light comes on and then the lid lock is suppose to engage and then fi...
When you start washer the fill light comes on and then the lid lock is suppose to engage and then fi...
(Posted by Cindymbrister 10 years ago)