Alpine INA-W900 Support Question
Find answers below for this question about Alpine INA-W900.Need a Alpine INA-W900 manual? We have 3 online manuals for this item!
Question posted by silenbokz on May 19th, 2014
How To Update The Firmware On Alpine W900
Current Answers
Answer #1: Posted by waelsaidani1 on May 20th, 2014 5:11 AM
Click on "Buy Now" and fill out order form.
2.) Receive Your INA-W900/INA-W900BT Software Update SD CardThis SD card containing the updated software will be shipped to you via UPS.
3.) Install the Software UpdateThere’s no computer needed! Place the SD card into the INA-W900/INA-W900BT’s SD card slot (located below the CD opening) and follow the screens: ‘Navigation Main Menu -> Settings -> Update.’
During the installation, the INA-W900/INA-W900BT will ask for the key code (found in the "Shipping Instructions" section of the packing slip inside of your package) . Enter it and you’ll be on your way to newer software! Full instructions below:
NVD-W901 Update Instructions:
=623; Takes 2 hours to copy the software from the SD card into the INA-W900/INA-W900BT.
=623; DO NOT REMOVE THE SD CARD DURING THE UPDATE PROCESS. Removing the
SD card during the update process may render the INA-W900/INA-W900BT inoperable.
The Navigation system will not be operable until the process is completed.
=623; During the update, the screen will automatically transition to the audio screen.
1. Power on your INA-W900/INA-W900BT
2. Press the “Eject” button
3. Select “Open” on the screen
4. Open the rubber cover over the SD card slot, then insert the SD card
containing the update software
5. Re-attach the rubber cover
6. Close the unit by pressing the “Eject” button again
7. Press the “NAVI MENU” button
8. Select the “Setup” button on the screen (picture of a wrench)
Note: Parking brake must be engaged for this button to appear
9. Select the down arrow to go to the next page
10. Select the “Update” button on the screen
11. Select the “Yes” button to start the update
Note: The installation will be completed in two phases:
1) Navigation software (7 minutes). Vehicle ignition on/running during this process.
2) Map (2 hours). Map will get updated when vehicle ignition is on or running.
Once the map update has started, the parking brake may be disengaged.
You will be notified after the first phase is complete, then the system will reset.
12. At the start of the second phase, you will need to enter a key code. The
key code can be found on the other side of this page
Note: The key code will be highlighted
13. You will be notified after the second phase is complete
Related Alpine INA-W900 Manual Pages
Similar Questions
Hello!a couple of months ago, I bought CD Receiver Alpine CDE-W235BT. I use it in other county( in R...