AEG L87485FL Support Question
AEG L87485FL Support Question
Find answers below for this question about AEG L87485FL.Need a AEG L87485FL manual? We have 1 online manual for this item!
Question posted by peterchristiaen on November 7th, 2020
Rumble Plastic Inside Washing Drum
To attach the grey plastic tumble pièce (3 in total) are 2 additional screws needed to firmly fix this piece. And if so, do I need to dismantle front panel and the outher drum?
Current Answers
Answer #1: Posted by Troubleshooter101 on November 12th, 2020 3:50 AM
Troubleshooter101
Member since:
September 30th, 2015 Points: 2,927,030
Member since:
September 30th, 2015 Points: 2,927,030
1. Make sure that the transit bolts (bolts and plastic spacers) are removed from the back of the appliance. Click here for a helpful video.
2. Make the washing machine level by raising or lowering the feet.
- Use a spirit level to check whether the machine is level on all its feet.
- The appliance must be stable on a level, hard floor.
- You can adjust the feet using a spanner.
- It is important that the appliance does not "rock", otherwise, it will vibrate while spinning.
3. Make sure that all the hoses are securely fitted and attached to the back of the appliance's housing.
Loosely fitted hoses can vibrate against the appliance during spinning, producing a "knocking" noise.
4. Check if the laundry is loaded correctly and make sure that there is no fabric caught between the door and drum.
5. Check the filter if the machine has one that is visible.
Loose coins, lighters, buttons or other small objects can get stuck in the drain filter. You can get instructions on how to clean the filter from the user manual.
6. Check the holes for loose straps from bras in the drum / between the drum sections.
7. Check if the noises are not the result of normal appliance operation.
Normal noise - can occur anywhere during a wash. This noise can be caused by buckles and zips knocking against the window, vibrations during spinning, the pump and motor running, water inflow during filling cycles, a heating element which is warming up, fans operating during drying cycles (washer dryers only), beeps coming from the electronics when changing cycle, starting and ending a wash.
Thanks
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Troublshooter101
Related AEG L87485FL Manual Pages
Product Manual - Page 1
EN User Manual Washing Machine
L 87485 FL
Product Manual - Page 4
....
• Make sure that the floor where you move the appliance again you must block the drum.
• Always be careful when you install the appliance is flat, stable, heat resistant and ...all the packaging and the transit bolts.
• Keep the transit bolts. Should the mains cable need to be replaced, this must be carried out by the manufacturer, its Authorised Service Centre or similarly...
Product Manual - Page 5
... children and pets to get closed in the drum. Risk of injury or suffocation. • Disconnect the appliance from the laundry. • Do not put flammable products or...to the appliance. • Use this appliance in the appliance.
1
2
3
1 Worktop
2 Detergent dispenser
3 Control panel
4 Door handle
4
5 Rating plate
6 Drain pump filter
7 Feet for the appliance level
5
6 7
3.2 ...
Product Manual - Page 7
When the programme starts, only the symbol of the cycle when the appliance detects too much detergent.
E
The detergent overdosing symbol comes on . C
Prewash phase
Washing phase
Rinse phase Spin phase
D
The steam symbol comes on .
4.2 Display
A
B
C
ENGLISH 7
D
E FG
H
L
K
J
I
The display shows:
Temperature of the set programme A
Cold water
Spin speed ...
Product Manual - Page 8
...J
Shortened time
Extra Quick
Programme time When the programme starts, the programme time decreases with the washing programme • you press the delay start button, the display shows the delay start symbol comes...is completed. The empty indicator bar appears only if the related function is water in the drum. 8 www.aeg.com
You cannot open the door only when the symbol goes off. I...
Product Manual - Page 9
...Synthetic items to perform a silent cycle.
White and coloured cotton. The cycle stops with «hand washing» care symbol.2)
Special programme for one of rinses. Cold
Easy Iron 60° C - Normal... indicator bar is fully filled when you activate the function. K
The value shows the total number of load and soil level)
White cotton and coloured cotton. Normal and light soil.1)
...
Product Manual - Page 10
... programme for dark coloured items. Cottons and synthetics items with plastic, metal, wooden parts or alike. In this way the wash is extended. All fabrics. If necessary, remove stains by 60°C and adds one rinse. To spin the laundry and to the washing by washing or using localized stain removal.
Normal soil.
Also for...
Product Manual - Page 11
... the laundry, this cycle the drum rotates slowly to regulation 1061/2010, these programmes are the most efficient programmes in terms of the appliance. 3) Set the spin speed. If you set No Spin option the only drain phase is completed, quickly remove the laundry from the temperature declared for washing normally soiled cotton laundry. According...
Product Manual - Page 12
...quantity and type of laundry, the water and ambient temperature. Follow the garment care label for the washing of wool
garments labelled as «hand wash» provided that...
1) If you use liquid detergent, set only the shorter duration.
5.2 Woolmark certificate
• The wool wash cycle of this machine has been approved by the manufacturer of this table are reduced. 4) Only the Prewash...
Product Manual - Page 13
... a programme.
7.2 Delay Start
With this option you can be greatly reduced if the laundry load is calculating the real programme duration a dot blinks in compliance with the EU Commission... At the end of a programme from 30 minutes to 20 hours. Approxi-
During the washing phase the programme duration is automatically calculated and can delay the start the display shows the duration...
Product Manual - Page 14
...daily soil. • Press this button two times to set 'Extra Quick' for laundry
with the control panel. • To activate/deactivate this option when you can prevent that you use ... .
7.5 Stains/Prewash
Press this button to add the stain and/or a prewash phase to a washing programme. SETTINGS
8.1 Acoustic signals
The acoustic signals operate when: • You activate the appliance. •...
Product Manual - Page 15
... a risk of water in the appliance. Press button Auto Off to Safety chapters.
10.1 Activating the appliance
1. Put the laundry in
the compartment for washing phase. 3. This removes all possible dirt from the drum and the tub. Open the water tap. 2. Connect the mains plug to put them
in the detergent compartment for...
Product Manual - Page 16
... phase an soak programme.
To use liquid detergent, turn the flap up. Maximum level for washing phase. A
Always obey the instructions that you find on the packaging of the detergent products.
10.4 Check the position of liquid additives. Pull out the detergent dispenser until it stops.
2.
16 www.aeg.com
10.3 Filling...
Product Manual - Page 17
...display the indicator of the programme: • The appliance adjusts
automatically the cycle time to the laundry you can operate for a short time when the appliance fills water. Press button Start/Pause again...8226; Do not use gelatinous or thick liquid detergents.
• Do not put in the drum to have perfect washing results in the flap.
• Do not set the prewash phase.
• Do not...
Product Manual - Page 18
...the door:
1. When the programme is still in the drum: The drum turns regularly to decrease the energy consumption when: • ... related indicator flashes. 2. Change the function set programme. Remove the laundry from the end of the last set . 3. Make sure that ... the door
If the temperature and level of cycle
The washing programme is completed, but there is empty. 4. Turn the...
Product Manual - Page 19
...additives specially made for washing machines: - Tie up pillowcases, close zippers, hooks and poppers. Use a washing bag to set programme.
11. We recommend that you remove these products.
• Use the correct products for the first times.
• Button up belts.
• Empty the pockets and unfold the items.
• Turn inside... the prewash phase to wash laundry with normal soil.
&#...
Product Manual - Page 20
... quantity of detergent. Obey the instructions that you use a water softener.
12. Start a short programme for washing machines.
Only use only special products for washing machines. Regularly examine the drum to : 1. To do this separately from the laundry wash. 20 www.aeg.com
11.5 Water hardness
If the water hardness in your area is high...
Product Manual - Page 23
... the drain pump. Disconnect the mains plug from the inlet hose and the drain pump. 1.
Make sure that the temperature is installed in the main wash compartment of the hose. 4. 12.8 Cleaning the inlet hose and the valve filter
1.
2.
1
2 3
3.
4.
If necessary, clean the pump. Start the programme to the emergency drain...
Product Manual - Page 25
... Make sure that the drain filter is not water leakages.
Refer to 'In- Add more laundry in the drum. Clean the filter, if necessary.
The appliance makes an Make sure the levelling of it...filter is water in the drum. Refer to open the ap-
Set the drain programme if you need to 'Care and cleaning'. The spin phase does not operate or the washing cycle lasts longer than usually....
Product Manual - Page 26
... till they cool down, if necessary.
Press the button Auto Off to the laundry load. You cannot set the correct temperature. Make sure that the water level inside the drum is possible to remove the stubborn stains before you wash the laundry. If the display shows other alarm codes. Before opening the door:
CAUTION!
The...
Similar Questions
Error 21 & Machine Will Not Run
had an E20 error, which was being caused by a pinched outlet pipe. I corrected that and checked that...
had an E20 error, which was being caused by a pinched outlet pipe. I corrected that and checked that...
(Posted by 66degreessouth 5 years ago)
Washing Powder Drawer
we use both conditioner and washing powder in the draw, yet when cycle is finished, powder is still ...
we use both conditioner and washing powder in the draw, yet when cycle is finished, powder is still ...
(Posted by leehudgell 7 years ago)
Aeg Lavamat 69680vfl Washing Machine
When drying the towels, the water in the condenser is clear. Yet, when I rinse the towels in warmwat...
When drying the towels, the water in the condenser is clear. Yet, when I rinse the towels in warmwat...
(Posted by jandjwalker 8 years ago)
Water Collects In The Drum When Not In Use.
The machine was purchased on the 4th January 2016. It was used once for a synthetic wash, 40degrees,...
The machine was purchased on the 4th January 2016. It was used once for a synthetic wash, 40degrees,...
(Posted by smidlindsay 8 years ago)