Whirlpool WGD85HEFC Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WGD85HEFC manuals!
Problems with Whirlpool WGD85HEFC?
Ask a Question
Free Whirlpool WGD85HEFC manuals!
Problems with Whirlpool WGD85HEFC?
Ask a Question
Popular Whirlpool WGD85HEFC Manual Pages
Ventilation Specification - Page 4
.... To remove moisture from laundry area. International Mechanical Code: 2009 version, sections 504 and 913.
2. See the Installation Instructions for the specific dryer model being used for balancing out the overall duct system.
■ Design the central duct system for use in the central duct system. National Fuel Gas Code.
3. The dryer has 4" (102 mm) exhaust duct connections. These...
Ventilation Specification - Page 5
..., such as the door, provided it will not be required for non-stacked installations
Single Dryer Venting Systems
Single dryer venting systems are defined as systems that are published in the United States and Canada are UL listed (reference UL 2158 standard), and all Whirlpool gas dryer models are sold in the product literature for the venting system. A. of...
Ventilation Specification - Page 6
... Use and Care Guide for details.
■ Select a Timed Dry heated cycle, and restart the dryer.
■ If the message persists, have your vent may have airflow detection capabilities. (See specific model product literature for recessed or closet installation, with stacked washer and dryer
48 in.2 * (310 cm2)
3"* (76 mm)
Multiple Dryer Venting Systems
Multiple dryer venting systems must...
Use & Care Guide - Page 4
... a premium, the stack kit allows the dryer to a more information on top of the washer. In Canada, call 1-800-807-6777 or visit us at www.whirlpoolparts.ca
15" Pedestal Color-matched pedestals raise the washer and dryer to be installed on options and ordering, call 1-800-901-2042, or visit us at : www.whirlpool.com/accessories.
Use & Care Guide - Page 7
... controls are drying. Dryness Level When using Manual Cycles or Steam Refresh, you may select the "With Steam" setting (on some models). The Damp Dry Signal is touched. Touch and hold CONTROL LOCK for your energy savings by approximately 40 minutes; 1 POWER Touch to turn the dryer on and off . Touch to stop/cancel...
Use & Care Guide - Page 8
... level to tumble freely.
8 Use for all models.
This cycle is a long cycle with 3-4 items, not more than 1/4 full.
Medium load: Fill the dryer drum up to dry:
Work clothes, casual wear...Fill the dryer drum with high heat, which has been proven to add a short steam cycle after 60 minutes. If settings are available on each cycle. Cycle Guide - Automatic Cycles
Settings and options ...
Use & Care Guide - Page 9
... Guide - Items need to dry foam, rubber, plastic, or heat-sensitive fabrics. Not all models. The maximum dry time is available only with 3-4 items, not more than the higher setting.
† On some knits.
This is 100 minutes. Small load: Fill the dryer drum with High and Medium Drying Temperature settings. Do not pack tightly.
Manual...
Use & Care Guide - Page 11
.../load. Cycle time is estimated and may vary.
Not all cycles are 5 drying settings (setting codes differ depending on all cycles. Cycle time can be changed after cycle is off . The display will affect all of your loads on model), which the dryer will shut off ) to select the dryness level shown in 1 minute increments...
Use & Care Guide - Page 14
... a water pressure surge) while you are at home. Transport hose separately. 5. When replacing your dryer. Disconnect water inlet hose from faucet and drain. Steam models only: Shut off water faucet. 3. Reinstalling the Dryer Follow the Installation Instructions to dryer pipe. 4. If storing or moving your dryer only when you are secure in the hose, freezing can damage your...
Use & Care Guide - Page 17
... a household fuse has blown or circuit breaker has tripped. Touch and hold CONTROL LOCK for service. "L2" Diagnostic Code (low or no line voltage condition)
There may be a problem with a lower heat setting to the dryer. The dryer will count down 3-2-1.
Troubleshooting
First try the solutions suggested here or visit our website at least 3 seconds.
Check that...
Dimension Guide - Page 1
...383/4" Min. (984 mm)
39" Max. (990 mm)
GAS DRYER
PRODUCT MODEL NUMBERS
WGD7505F, WGD7540F, WGD7590F, WGD75HEF, WGD7740F, WGD77HEF, WGD90HEF, WGD92HEF, WGD85HEF
Side view
Back view
61/4" (159 mm)
* Approx. W10775221A 05/2016 See "Venting Requirements." measurement
Recommended installation clearances
53/4"* (146 mm)
Vent
Water inlet
(Steam Models Only)
Gas
297/8"* (759 mm)
31/2"* (89 mm...
Installation Guide - Page 4
...or a stack kit. NOTE: Do not use leveling legs supplied with dryer if installing with dryer) ■■Vent clamps ■■Vent elbows and vent work
4 Tools needed for all parts are included.
Parts needed for gas installations:
8" or 10" pipe wrench
8" or 10" adjustable wrench (for gas connections)
Flat-blade screwdriver
#2 Phillips screwdriver
¼" and 5/16" nut driver...
Installation Guide - Page 6
... recommended and minimum spacing allowed.
■■Additional spacing should be considered for ease of gas dryers: ■■Mobile Home Installation Hold-down Kit Part Number 346764
is allowed for straight back venting only.
6 For further information, see "Assistance or Service" section in door are acceptable.
■■Companion appliance spacing should be considered on...
Installation Guide - Page 8
... m) of E.I. In Canada: An individual manual shut-off valve be installed in the door well of the gas connection to use with a different gas without consulting your dryer. Option 2 (Alternate Method) Approved aluminum or copper tubing: ■■Must include 1/8" NPT minimum plugged tapping accessible
for lengths under 20 ft. (6.1 m) if local codes and gas supplier permit. ■...
Installation Guide - Page 10
...vent, chimney, wall, ceiling, attic, crawlspace, or a concealed space of all governing codes and ordinances.
Flared male fitting B. Replace plastic or metal foil vents with lint. MAKE GAS CONNECTION
(gas models only)
1. Using a wrench to tighten, connect gas supply to dryer
VENTING Venting Requirements
B A
A. If flexible metal tubing is not plugged with rigid metal or flexible...
Whirlpool WGD85HEFC Reviews
We have not received any reviews for Whirlpool yet.