Whirlpool WGD4616FW Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WGD4616FW manuals!
Problems with Whirlpool WGD4616FW?
Ask a Question
Free Whirlpool WGD4616FW manuals!
Problems with Whirlpool WGD4616FW?
Ask a Question
Whirlpool WGD4616FW Videos
Whirlpool WGD4616FW Dryer
Duration: 1:01
Total Views: 52
Duration: 1:01
Total Views: 52
Whirlpool WGD4616FW Dryer
Duration: :58
Total Views: 265
Duration: :58
Total Views: 265
Whirlpool WGD4616FW Sécheuse
Duration: :57
Total Views: 7
Duration: :57
Total Views: 7
Popular Whirlpool WGD4616FW Manual Pages
Installation Guide - Page 4
INSTALLATION REQUIREMENTS
Tools and Parts
Tools needed : Check local codes.
Tools needed for all parts are included. Optional Equipment: (Not supplied with dryer) Refer to LP gas
Parts supplied:
Tape measure
Vent clamps
Level
Pliers
Leveling legs (4)
Parts package is located in garages, closets, mobile homes, or sleeping quarters. Contact your dryer.
Check existing electrical ...
Installation Guide - Page 5
... install Extended Dryer Feet Kit, Part Number 279810. Drying times can be 1/2" (13 mm) (to open fully. closet or confined area C. Wide opening side-swing door B. Do not operate your local building inspector. Check code requirements. Some codes limit, or do not permit, installation of dryer. Most installations require a minimum 5½" (140 mm) clearance behind the dryer for gas dryers...
Installation Guide - Page 7
... Guide." No attempt shall be made by CSA International for LP (propane or butane) gases with a different gas without consulting the serving gas supplier. If this information does not agree with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1. LP gas conversion:
Conversion must be made to the floor. Prepare dryer...
Installation Guide - Page 8
...) to connect your dryer to the gas supply line with the B149.1, Natural Gas and Propane Installation Code.
Dryer gas pipe
■■ The gas pipe that resist the action of connection.
This dryer must be connected to the rigid gas supply line. rating indicated on the model/serial number plate is required for two different methods of LP gas must be disconnected...
Installation Guide - Page 9
... must not be fully extended and supported in final dryer location. ■■ Remove excess to avoid
crushing and kinking.
SAVE THESE INSTRUCTIONS
WARNING: To reduce the risk of the system and make sure exhaust hood is properly installed and grounded in accordance with a quali ed electrician or service representative or personnel if you are...
Installation Guide - Page 12
... -flare adapter fitting
A combination of LP gas. NOTE: For LP gas connections, you must use duct tape, screws, or other fastening devices that extend into interior of E.I. Connect gas supply to exhaust hood with 4" (102 mm) clamp.
Secure vent to dryer
Flared maAle fitting
mNoalne-fflBiattriendg
Remove red cap from gas pipe. Install exhaust hood
12" min. (305...
Installation Guide - Page 13
.... Once legs are now installed. If the dryer will go back through steps to see what was skipped. The odor will not start the dryer. q Check that dryer is an extra
part, go away. If there is level. q Check that you feel heat, turn the dryer off and check to see whether gas supply line shut-off...
Use & Care Guide - Page 5
...of cycles. Drying time and temperature will depend on your dryer model. NOTE: The No Heat temperature setting (on some models)
When you are unable to select for detailed descriptions of...shortest time. See "Cycle Guide" for a load, select the lower setting rather than the higher setting. Drying time will vary based on fabric type, load size, and dryness setting.
3 TEMPERATURE Select a...
Use & Care Guide - Page 6
... control.
Items to dry large or heavy loads. A Low to dry:
Cycle:
Temperature:
Available Options:
Cycle Details:
Jeans, heavy work clothes.
Setting the Drying Temperature
If your load.
CYCLE GUIDE - No heat drying. ACCUDRY™/AUTOMATIC DRY CYCLES
Not all models. Items to Medium temperature setting may be used for drying medium-weight items such...
Use & Care Guide - Page 10
..., storage, and moving care
Non-Use or Storage Care
Operate your dryer for an extended period of time, you are at fuse or breaker box. 2. Replace all parts and panels before servicing. Make sure leveling legs are secure in gas supply line. 3. Using a Phillips-head screw driver, remove the screw located in death or electrical shock.
Use & Care Guide - Page 11
... have ventilation openings at www.whirlpool.com/product_help In Canada www.whirlpool.ca for awhile, there may vibrate if not properly installed.
Incorrect power supply. Use a time-delay fuse. It is blown or circuit breaker has tripped.
Household fuse is a gas dryer. The drum may be cleaned before laundering. See "Installation Instructions". Exhaust vent not the correct...
Use & Care Guide - Page 12
... Level setting will...service call. Lint on ACCUDRY™/Automatic Dry cycles. Odors
You have an odor.
Load is too hot
The electric dryer...dryer.
The new electric heating element may not be gone after the first cycle. TROUBLESHOOTING...dryer is being used . Add dryer fabric softener sheets at www.whirlpool.com/product_help In Canada www.whirlpool.ca for very small loads.
Use & Care Guide - Page 13
... Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will need to know your major appliance if it is installed in an inaccessible location or is not installed in accordance with Whirlpool published installation instructions.
10.
The cost of repair or replacement under this limited warranty.
ITEMS EXCLUDED FROM WARRANTY
This limited warranty does not cover:
1. Service calls to...
Warranty Information - Page 1
...abuse, fire, flood, acts of products not approved by a Whirlpool designated service company. Replacement parts or repair labor if this information on the model and serial number label located on major appliances with Whirlpool published installation instructions.
10. Consumable parts are unable to the appliance.
8.
WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from...
Dimension Guide - Page 2
... the dryer door to open fully. For lengths over 20 ft (6.1 m), larger tubing should be 1/2" IPS. An individual manual shutoff valve must be considered.
Louvered doors with the National Fuel Gas Code ANSI Z223.1. Installation spacing for recessed area or closet The dimensions shown are required. Pipe-joint compounds resistant to the action of installation and servicing...
Whirlpool WGD4616FW Reviews
We have not received any reviews for Whirlpool yet.