Whirlpool WED7120HW Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WED7120HW manuals!
Problems with Whirlpool WED7120HW?
Ask a Question
Free Whirlpool WED7120HW manuals!
Problems with Whirlpool WED7120HW?
Ask a Question
Popular Whirlpool WED7120HW Manual Pages
Dimension Guide - Page 1
White Available WED7120HW - Electric WGD7120HC - ft. Gas
Chrome Shadow Available WED7120HC - Electric WGD7120HW - Gas
42 3/4" Height
W11412666A
29 7∕8" Depth
27" Width Dimension Guide
Whirlpool® Smart Capable Front Load Electric/Gas Dryer with AccuDry™
System, Steam Refresh Cycle - 7.4 cu.
Owners Manual 1 - Page 2
... the absence of local codes, with local codes, or in this manual and on your appliance. This is , tell you how to reduce the chance of injury, and tell you what can kill or hurt you to potential hazards that can happen if the instructions are very important.
IMPORTANT: The gas installation must be killed...
Owners Manual 1 - Page 4
... any tools listed here. Mobile home installations require metal exhaust system hardware available for use with dryer) Check local codes. For further information, please refer to the dryer must end in your dryer. Tools needed for all models):
Level Plastic putty knife
Vent clamps
Leveling legs (4) Parts needed : (Not supplied with clothes dryers.
The kit should be type...
Owners Manual 1 - Page 5
... of
installation and servicing. ■ Additional clearances might be considered.
14" max (356 mm)
18" (460 mm)
3" (76 mm) 48 in.2
(310 cm2)
24 in your "Quick Reference Guide."
■ Special provisions must be exposed to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for electric dryers...
Owners Manual 1 - Page 8
... an individual manual shutoff valve be used . Burner information is a registered trademark of the dryer in accordance with a different gas without consulting your "Quick Reference Guide." No attempt shall be easy to reach for gas appliances, ANSI Z21.24 or CSA 6.10. Do not use with the B149.1, Natural Gas and Propane Installation Code. Install a shut...
Owners Manual 1 - Page 16
... to seal all governing codes and ordinances. Replace plastic or metal foil vents with lint.
Clamps: ■ Use clamps to achieve best drying performance. Do not use a plastic vent.
Dryer exhaust must be included in final dryer location.
■ Remove excess to follow these instructions can be purchased from your "Quick Reference Guide."
16 Recommended Styles...
Owners Manual 1 - Page 21
... is intact and tight, or circuit breaker has not tripped.
• Dryer door is not, repeat the removal and installation procedures. 21 A
A. Be sure vent is level.
Then, follow these instructions.
q Check for this problem. q Check for certain part replacement or repair. Open the dryer door.
All Models:
q Select a Timed Dry heated cycle, and start of the water...
Owners Manual - Page 2
... absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part 1, CSA C22.1.
2
All safety messages will follow instructions. DRYER SAFETY
Your safety ...codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas and Propane Installation Code, CSA B149.1. IMPORTANT: The gas installation...
Owners Manual - Page 5
.... ■■ Steam models only: Cold water faucets located within 2 ft. (610 mm) of either side of installation and servicing, spacing for companion appliances and clearances for Mobile home construction and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 MH. For gas dryers mobile home installations:
■■ Mobile Home Installation Hold-down Kit...
Owners Manual - Page 16
...Replace plastic or metal foil vents with screws
or other fastening devices that may obstruct exhaust (such as shown in final dryer location.
■■ Remove excess to follow these instructions can be purchased from your "Quick Reference Guide... all governing codes and ordinances. Clamps: ■■ Use clamps to clean) ■■ Must be fully extended and supported in the ...
Owners Manual - Page 21
... MODELS)
For normal dryer use of a water softener is not, repeat the removal and installation procedures. 21 To Remove: 1. Do not select Air Only Temperature setting. You will go back through the water system in a hard water area, use , it away from the dryer door frame.
2
To Replace: 1. The odor will receive L2 code for certain part replacement or repair...
Quick Reference Manual - Page 1
... REFERENCE GUIDE WHIRLPOOL® ELECTRIC/GAS DRYER
WARNING:... FIRE OR EXPLOSION HAZARD Failure to light any appliance. • Do not touch any electrical switch;
WHAT TO DO IF YOU SMELL GAS:
• Do not try to follow safety warnings exactly could result in your gas supplier from a neighbor's phone. Installation and service must be performed by a quali ed installer, service...
Quick Reference Manual - Page 3
... installed, launch the app and you select a cycle, its default settings will display and the Estimated Time Remaining (for models with the exception of Power which will indicate that the moisture sensor on , it will not be guided through the dryer and the dryer vent system for Automatic cycles only.
Clean lint screen or vent for Manual...
Quick Reference Manual - Page 4
... and/or you want to get back to follow these instructions can completely remove oil.
Read all models.
Not all cycles, settings, and options are available with "Select Language" display message.
*NOTE: See "Cycle Guide" for more information about cycles, settings, and options.
Failure to Factory settings then perform Factory Reset. Unit will power back on...
Quick Reference Manual - Page 7
...
Please include a daytime phone number in Canada www.whirlpool.ca/owners. REGISTER PRODUCT
SCHEDULE SERVICE
HOW TO'S & FAQS
MANUALS & ADD SERVICE
DOWNLOADS
PLAN
PARTS
ACCESSORIES
To speak with your correspondence.
7 For detailed product dimensions, please see the INSTALLATION AND CARE INSTRUCTIONS MANUAL included with a customer service representative or if you the cost of the...
Whirlpool WED7120HW Reviews
We have not received any reviews for Whirlpool yet.