Whirlpool WED5100S Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WED5100S manuals!
Problems with Whirlpool WED5100S?
Ask a Question
Free Whirlpool WED5100S manuals!
Problems with Whirlpool WED5100S?
Ask a Question
Most Recent Whirlpool WED5100S Questions
Dryer Does Not Work On All Settings
works on automatic dry only.
works on automatic dry only.
(Posted by Anonymous-127810 10 years ago)
Dryer Over Heating
My dryer seems to be consistantly getting hotter each time a cycle is going. I have turned the tempa...
My dryer seems to be consistantly getting hotter each time a cycle is going. I have turned the tempa...
(Posted by focusworks08 10 years ago)
Popular Whirlpool WED5100S Manual Pages
User Instructions - Page 4
...drying heavyweight items such as towels and work clothes.
■■ A Low to Medium heat setting may be set the WRINKLE SHIELD™ selector knob to Less...and some models, the temperature is selected, but only if the End of load, and temperature setting.
Temperature Tips If your dryer uses the electronic ACCUDRY™ system.
Cycle Selector (Timer) Control
...
User Instructions - Page 5
CYCLE GUIDE
Not all models.
Drying time varies based on all cycles and settings are available on fabric type, load size, and dryness setting.
Denims
Thoroughly dries denims.
Medium ...the
Any
clothes
Energy Preferred cycle. The signal stops when you may feel slightly damp. High
Casual, shirts, pants, Gives the best drying in the dryer too long.
On other models, the ...
User Instructions - Page 6
.... NOTE: The drying rack must be able to purchase one for the type of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before each load. Put wet items on some models, temperature is set it stops.
6. (OPTIONAL) Your dryer may have a drying rack, you are unable to remove a load from the...
User Instructions - Page 8
... leveling legs are at home. For direct-wired dryers:
Changing the Drum Light
(on the back wall of the dryer. Unplug dryer or disconnect power.
2.
Open the dryer door. WARNING
Electrical Shock Hazard Disconnect power before operating. Replace all parts and panels before servicing. Use masking tape to secure dryer door. Replace the cover and secure with a 10-watt appliance...
User Instructions - Page 9
... position. The timer moves only when the clothing is not too long or has too many turns. In Canada www.whirlpool.ca
Dryer will not start in a room with a qualified electrician.
■■ Was a regular fused used for the timed setting.
■■ Is the dryer set to vibrate. Electric dryers require 240-volt power supply. Replace the fuse or...
User Instructions - Page 10
...;■ Is the dryer located in a cycle. See the Installation Instructions.
■■ Has an air dry cycle been selected? Separate the load to handle.
Level the dryer. Lint on Automatic ...the clothing.
■■ Is the electric dryer being dried.
■■ Is the load too large and heavy to other injury.
■■ Is the automatic cycle ending early?
Part Number...
Installation Instructions - Page 1
... symbol.
ELECTRIC DRYER INSTALLATION INSTRUCTIONS U.S.A. Always read and obey all safety messages. ONLY
Para una version de estas instrucciones en español, visite www.Whirlpool.com
TABLE OF CONTENTS
TABLE OF CONTENTS 1
DRYER SAFETY 1
INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Optional Equipment 2 Location Requirements 3
ELECTRIC DRYER POWER HOOKUP 4 Electrical Requirements...
Installation Instructions - Page 2
... Tin snips (new vent installations)
■ ¼" nut driver (recommended)
■ Tape measure
■ Pliers
4 Leveling legs
A
B
A. Read and follow the instructions provided with dryer if installing on a pedestal. Check that opens to the "Assistance or Service" section in your Use and Care Guide. Inlet hose with right-angle connector
E. Check existing electrical supply and venting...
Installation Instructions - Page 3
... noise transfer.
■ For closet installation, with maximum slope of dryer in longer drying times.
Installation spacing for spacing of 200 lbs. (90.7 kg). Additional installation requirements
Dryer is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. See "Electrical Requirements."
■ A sturdy floor to support total dryer weight of 0" (0 mm) clearance...
Installation Instructions - Page 4
...end in ring terminals or spade terminals with clothes dryers.
ELECTRIC DRYER POWER HOOKUP
Electrical Requirements
It is your responsibility ■ To contact a qualified electrical installer.
■ To be sure that the electrical connection is adequate and in conformance with a 3-wire electrical supply connection. The National Electrical Code requires a 4-wire power supply connection for...
Installation Instructions - Page 11
...or Service" section in your local dealer to have the dryer converted.
11
Clamps F. Vent length necessary to the manufacturer's instructions. Two close-clearance installations are available for purchase. Periscope installation
NOTE: The following kits for mobile home installations The exhaust vent must be converted to cover unused exhaust holes):
Part Number W10186596 - all models
This...
Installation Instructions - Page 13
... for certain part replacement or repair.
13 4. Attach straight end of small hose.
Check that the water faucets are on connector. 8. Excessive scale buildup may clog different parts of your Use and Care Guide. 9. Using pliers, tighten the couplings with a damp cloth to "Y" connector. 7. For direct wire installation, turn . Be sure the water faucets are on
the dryer. 7.
Installation Instructions - Page 14
...: Door strike and plugs must be on the same side of the dryer door opening . Replace the 4 screws in Step 2.
5. All Models:
13.
See "Troubleshooting." This odor is common when the heating element is first heated. Install 4 plastic plugs into an outlet and/or electrical supply
is connected. ■ Household fuse is intact and tight, or...
Installation Instructions - Page 15
...breaker. Install two bottom screws. Electric dryers require 240-volt power supply. Use the non-slotted side to attach the hinge to engage door strike. If the problem continues, call an electrician. Electric dryers use 2 household fuses or circuit breakers. If the problem continues, call an electrician.
■ Is the correct power supply available? 3.
TROUBLESHOOTING
First...
Installation Instructions - Page 16
..., E2, E3) service codes: Call for service. Closet doors must have your entire home venting run when this diagnostic code is too hot
■ Is the lint screen clogged with lint, restricting air movement? See the Installation Instructions.
Replace the fuse or reset the circuit breaker. Select a Timed Dry heated cycle, and restart the dryer.
See the Installation Instructions. ■...
Whirlpool WED5100S Reviews
We have not received any reviews for Whirlpool yet.