Sharp R-351NW Support and Manuals
Get Help and Manuals for this Sharp item
View All Support Options Below
Free Sharp R-351NW manuals!
Problems with Sharp R-351NW?
Ask a Question
Free Sharp R-351NW manuals!
Problems with Sharp R-351NW?
Ask a Question
Popular Sharp R-351NW Manual Pages
Service Manual - Page 1
... REPLACEMENT AND ADJUSTMENT PROCEDURE
CHAPTER 4. CIRCUIT DIAGRAMS Parts List
This document has been published to be used for after sales service only. FOREWORD AND WARNING
CHAPTER 10. PRODUCT DESCRIPTION CHAPTER 5. OPERATION
CHAPTER 12. TROUBLESHOOTING GUIDE CHAPTER 8. TOUCH CONTROL PANEL ASSEMBLY
CHAPTER 1. TEST PROCEDURES CHAPTER 9. WARNING TO SERVICE PERSONNEL: Microwave...
Service Manual - Page 3
..., wear, and other
microwave source, and make repairs as per the Microwave Measurement Procedure outlined in excess of the unit should be instructed not to operate the oven and 2) contact SHARP ELECTRONICS CORPORATION and Food and Drug Administration's Center for Devices and Radiological Health immediately. i R-351NW
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO AVOID POSSIBLE...
Service Manual - Page 4
... is fully assembled, the microwave power output should be checked and microwave leakage test should not be disconnected. When the two minutes has elapsed (timer at zero) carefully check that procedure, reconnect the power supply cord.
[2] When the testing is installed. 7. DISCHARGE THE HIGH VOLTAGE CAPACITOR BEFORE SERVICING. Whenever troubleshooting is now hot.
Reconnect the...
Service Manual - Page 5
...meter. 3. Make sure that comply with the requirement for the maximum indication on service invoice and microwave leakage report.
2 - 1 Important:
Survey instruments that the actual instrument is permitted by the closed latch assembly. 4.
MICROWAVE MEASUREMENT PROCEDURE
R-351NW
[1] Requirements:
1. The water container shall be used for leakage around the switches, indicator...
Service Manual - Page 6
... carefully study the entire text of this manual so that they are not defective. (C) The door packing is not damaged. (D) The door is not deformed or warped. (E) There is not any other visible damage with Operation and Service Information for the SHARP MICROWAVE OVENS, R-351NW. Servicing and repair work must be carried out only by themselves, or...
Service Manual - Page 7
...less.
Touch Control System Clock (1:00 - 12:59)
Timer (0 - 99 minutes 99 seconds)
Microwave Power for holding food is calculated by measuring maximum
Height 8-1/8" (206mm) Depth 15-1/4" (387mm)
width, depth and height. CHAPTER 4. PRODUCT DESCRIPTION
[1] SPECIFICATIONS
R-351NW
ITEM Power Requirements Power Consumption Power Output
Case Dimensions
Cooking Cavity Dimensions (1.0 Cubic...
Service Manual - Page 8
...351NW...-receptacle is encountered, it replaced with a three prong grounding...support. Only remove for the electric current. Oven door with the National Electrical Code and local codes...support
8
11 10 3 7
Carefully place the turntable support
9
in or tripping over accidentally. Auto-Touch control panel
13. GENERAL INFORMATION
[1] GROUNDING INSTRUCTIONS... properly installed and grounded...
Service Manual - Page 10
...When Variable Cooking Power is converted to avoid overcooking.
6 - 1 R-351NW
CHAPTER 6. is operated by the magnetron is channelled through the monitor ... causing the monitor fuse to be cooked.
5) Upon completion of microwave energy is supplied to the control unit. (Figure O-1). 1) The ... cycle when the door was opened .) When oven is set the clock, touch the STOP/CLEAR pad. output on ...
Service Manual - Page 13
TROUBLESHOOTING GUIDE
R-351NW
Never touch any part in the "Test Procedure" section. These tests are given a procedure letter which will require that procedure, reconnect the power supply cord.
Use part...replacing the monitor fuse.
When troubleshooting the microwave oven, it open . 3) Discharge high voltage capacitor. 4) Reconnect the leads to the primary of trouble will be replaced...
Service Manual - Page 17
... monitor fuse and monitor switch assembly is divided into two units, CPU Unit and Power Unit, and troubleshooting by using insulation tape.
1. Reconnect all leads removed from other components and oven chassis by unit replacement is installed. 8. Reinstall the outer case (cabinet). 7. Reconnect the power supply cord after the outer case is blown...
Service Manual - Page 19
...model is provided with a fine foil pattern added to the primary on the control unit with a D.C. voltmeter during testing. 12.Re-install...the troubleshooting guide given below for repair....relay.
Replace the ...351NW
[13] L: RELAY TEST
1. The meter should be fully assembled before following procedure. 1. After that these leads remain isolated from components during the microwave...
Service Manual - Page 22
..., 1) Disconnect the power supply cord. 2) Open the door and block it is installed. 6) Run the oven and check all functions. To perform the servicing, power to the primary of the key unit to the control unit being closed . a) On some models, the power supply cord between the touch control panel and the oven...
Service Manual - Page 23
... and damage to printed patterns.) As the melting point of this model employs lead-free solder. It will cause premature corrosion of time. This is higher and has poorer wettability, (flow), to prevent damage to leave the bit in the service manual. Remove the bit as soon as a good flow is...
Service Manual - Page 24
..., cracks, signs of the following parts may result in the microwave generating
and transmission assembly. 7. Before wiring,
1) Disconnect the power supply cord. 2) Open the door block it is then possible to prevent a fault) Fan blade, Fan motor, Turntable motor, Switch, Switch lever, Open button.
3.
Please follow the instructions below before operating the oven...
Service Manual - Page 35
...R-307NK)
6-6 INSTRUCTION BOOK
6-2 TURNTABLE TRAY
INTO THE OVEN CAVITY
6-1 TURNRTABLE SUPPORT
TRAY PAD ASSY (CPADBA317WRKZ)
Not replaceable items.
TOP PAD ASSEMBLY FPADBA616WRKZ
PLASTIC SHEET (for R-307NK) SPADPA616WREZ
PLASTIC BAG SSAKHA034WRE0 CABINET COVER SPAKHA011WRE0 (for after sales service only. NO.
3. R-351NW
PARTS LIST
MICROWAVE OVEN
HOW TO ORDER REPLACEMENT PARTS
To have...
Sharp R-351NW Reviews
We have not received any reviews for Sharp yet.