Seagate ST3146707LW - Cheetah 146 GB Hard Drive Support and Manuals
Get Help and Manuals for this Seagate item
This item is in your list!
View All Support Options Below
Free Seagate ST3146707LW manuals!
Problems with Seagate ST3146707LW?
Ask a Question
Free Seagate ST3146707LW manuals!
Problems with Seagate ST3146707LW?
Ask a Question
Popular Seagate ST3146707LW Manual Pages
Cheetah 10K.7 Data Sheet - Page 2
... data is designed and manufactured by the Cheetah 15K. FDB reduces the drive's acoustics and improves reliability with the shortest wait times in /mm) Weight (lb/kg) Warranty Limited Warranty (years) 11 Mbyte = 1,000,000 bytes. www.seagate.com 1-800-732-4283 (1-800-SEAGATE)
Specifications
300 GB1 146 GB1
73 GB1
Model Number Capacity
Formatted 512 Kbytes/Sector...
SAS and SATA: Multiple Benefits of Unified Storage (334K, PDF) - Page 4
...) and high-capacity (SATA) storage applications.
Seagate reserves the right to a RAID-
Conclusion
Greater storage efficiency continues to be connected to change, without notice, product offerings or specifications. And now the availability of SFF 15K-RPM SAS drives and higher-capacity, lower-power 3.5-inch 10K-RPM SAS hard drives boosts the SAS/SATA value proposition even...
Cheetah 10K.7 SCSI Product Manual - Page 17
... negotiated transfer rates. These transfer rates will occur only if your warranty. Table 1: Drive model number vs.
The drive contains no replaceable parts.
Cheetah 10K.7 SCSI Product Manual, Rev.
The drive's interface supports multiple initiators, disconnect/reconnect, self-configuring host software, and logical block addressing. Air circulates within the HDA through a nonreplaceable...
Cheetah 10K.7 SCSI Product Manual - Page 27
...Default OEM error recovery settings are applied. D
17 Cheetah 10K.7 SCSI Product Manual, Rev.
5.0 Reliability specifications
The following reliability specifications assume correct host/drive operational interface, including all flaws reallocated.
5.1
Error rates
The error rates stated in this specification assume the following: • The drive is operated per this manual (see Section...
Cheetah 10K.7 SCSI Product Manual - Page 30
... power-up .
20
Cheetah 10K.7 SCSI Product Manual, Rev. Should the counter continually be acceptable.
The temperature is referred to the reporting method, the firmware will be unacceptable. Performance impact
S.M.A.R.T. Subject to as the Failure Counter. To determine rate, error events are reset and the process starts over the interface when the temperature exceeds a set threshold...
Cheetah 10K.7 SCSI Product Manual - Page 33
..., the drive passed with Seagate's warranty procedure. The Sense key, ASC, ASCQ, and FRU are used to report the failure condition.
5.2.6.2.5 Abort
There are more detailed warranty information refer to Fh 3. A complete read head element and the media surface. Cheetah 10K.7 SCSI Product Manual, Rev.
Existing data will report a fault condition. Short test (Function Code: 001b...
Cheetah 10K.7 SCSI Product Manual - Page 51
... are described in addition to recover the data. The error recovery procedures used depend on this specification. The error recovery scheme supported by the drive provides a means to control the total error recovery time for the entire command in the SCSI Interface Product Manual. Table 3 equates the Read and Write Retry Count with the maximum possible recovery time...
Cheetah 10K.7 SCSI Product Manual - Page 53
... reporting plays a role in the SCSI systems error management and its use in the drive not performing error recovery. Note: A recovery time limit of FF FF. Cheetah 10K.7 SCSI Product Manual, Rev. For example, suppose the Read/Write Recovery page has the RC bit set to 0, read command is given in the SCSI systems error management system.
The recovery time...
Cheetah 10K.7 SCSI Product Manual - Page 59
... is SE jumper not installed.
J2 does not exist on LC models and is installed. Drive can operate on the interface in low voltage differential mode or single-ended, depending on LW models only. Drive spindle does not start feature is overridden and does not apply when ME jumper is supported on the voltage state of parity checking to SCSI bus I/O cable...
Cheetah 10K.7 SCSI Product Manual - Page 63
... in the Seagate SCSI Interface Product Manual.
9.2
SCSI interface messages supported
Table 4 lists the messages supported by Cheetah 10K.7 SCSI family drives
Message name Abort Abort-tag Bus device reset Clear ACA Clear queue Command complete Continue I/O process Disconnect Extended messages Identify Ignore wide residue (two bytes) Initiate recovery Initiator detected error Linked command...
Cheetah 10K.7 SCSI Product Manual - Page 90
... on the bus. LC and LW model drives do not operate at Ultra2 or faster SCSI data rates if this is designed. Termination of 12 sec- Drive will not operate I/O bus at high voltage differential levels and should be connected as either open or grounded (open for the '1' setting, grounded for host front panel hard drive activity indicator. [5] Asserted...
Cheetah 10K.7 SCSI Product Manual - Page 98
...).
88
Cheetah 10K.7 SCSI Product Manual, Rev. USA/Canada/Latin America support services
Seagate Service Centers
Presales Support Call center Americas
Toll-free 1-877-271-32851
Technical Support Call center Americas
Toll-free 1-800-SEAGATE2
Direct dial +1-405-324-47301
Direct dial +1-405-324-47002
FAX +1-405-324-4704
FAX +1-405-324-3339
Customer Service Operations
Warranty Service Call...
Cheetah 10K.7 SCSI Product Manual - Page 99
...-47324283 00 800-31 92 91 40 00 800-47324283
FAX services-All Europe (toll call center at +31-20-316-7222 from 8:00 A.M. Cheetah 10K.7 SCSI Product Manual, Rev. The presales and technical support call center at +31-20-3167222 from 8:00 A.M. For warranty service in Africa and the Middle East, dial our presales and technical...
Cheetah 10K.7 SCSI Product Manual - Page 104
...14 specification 14 discontinuity (DISC) bit 15 DRA bit 15 drive 37 drive activity 80 drive activity LED 86 drive capacity 11 programmable 10 drive default mode parameter 45 drive failure 18 drive firmware 59 drive ID 45 drive ID select jumper connector 45 drive ID/option select header 45 drive interface connector 69 drive internal 27 drive internal defects and errors 41 drive malfunction 18
drive...
Cheetah 10K.7 SCSI Product Manual - Page 106
... cable 68 SCSI interface commands supported 54 SCSI interface connector 64 SCSI interface data 12
SCSI Interface Product Manual 3, 5, 7
SCSI systems error 43 SCSI systems error consideration 41 SCSI systems error management 43 Seagate support service 45 sector 14 sector interleave 12 sector sizes 12 seek error 17
defined 18
segment 13, 14
self-contained 14
Cheetah 10K.7 SCSI Product Manual, Rev.
Seagate ST3146707LW Reviews
Do you have an experience with the Seagate ST3146707LW that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Seagate yet.
Earn 750 points for your review!