SanDisk 8GB EXTREME - 8GB Extreme III CompactFlash Card Support and Manuals
Get Help and Manuals for this SanDisk item
View All Support Options Below
Free SanDisk 8GB EXTREME manuals!
Problems with SanDisk 8GB EXTREME?
Ask a Question
Free SanDisk 8GB EXTREME manuals!
Problems with SanDisk 8GB EXTREME?
Ask a Question
SanDisk 8GB EXTREME Videos
SanDisk 8GB Extreme III CompactFlash Card
Duration: :54
Total Views: 6,541
Duration: :54
Total Views: 6,541
SanDisk 8GB Extreme Pro 45MB/s
Duration: 4:43
Total Views: 2,055
Duration: 4:43
Total Views: 2,055
SanDisk 8GB Extreme SDHC Class 10 High Performance Memory Card
Duration: 1:13
Total Views: 694
Duration: 1:13
Total Views: 694
Sandisk 8GB Extreme III SDHC Card with MicroMate Reader
Duration: 2:42
Total Views: 9,952
Duration: 2:42
Total Views: 9,952
Popular SanDisk 8GB EXTREME Manual Pages
Product Manual - Page 1
SanDisk CompactFlash Memory Card
OEM Product Manual
Version 12.0
Document No. 20-10-00038
02/2007
SanDisk Corporation Corporate Headquarters 601 McCarthy Boulevard Milpitas, CA 95035 (408) 801-1000 Phone (408) 801-8657 Fax www.sandisk.com
Product Manual - Page 8
... Minimum 10,000 insertions
1.3 Scope
This document describes the key features and specifications of CompactFlash Memory cards, as well as the information required to a host system. Contact the CompactFlash Association for more information. Retail CompactFlash specifications are not covered in this product to interface this manual.
1.4 CompactFlash Standard
SanDisk CompactFlash Memory cards are...
Product Manual - Page 10
... Sector and Write Commands
SanDisk CompactFlash Memory cards support the CF ERASE SECTOR and WRITE WITHOUT ERASE commands. This is completely transparent to complete. This is extremely important as flash devices are used to access future SanDisk cards built with the ERASE SECTOR command. Introduction
SanDisk CompactFlash Card OEM Product Manual
1.7.1
Technology Independence
The 512...
Product Manual - Page 11
...power if no longer supported. Upon completion of a command, the card will be done only for the 3.30 volt range.
© 2007 SanDisk Corporation
1-5
Rev. 12...occur. SanDisk CompactFlash Card OEM Product Manual
Introduction
1.7.5
Automatic Sleep Mode
A unique feature of the SanDisk CompactFlash Memory Card is accessing it, thus conserving power. Per the PCMCIA specification Section ...
Product Manual - Page 14
... mA
Write
65 mA
Read/Write Peak
100 mA
Memory Subsystema CompactFlash Extreme III Memory Card Sleep
Up to 512 MB
300 µ
512 MB to 1.5 GB
600 µ
Over 1.5 GB
1 mA
Read
75 mA
Write
75 mA
Read/Write Peak
100 mA
a. Maximum average value.
5V +/- 10%
500 µ 800 µ 1.2 mA 55 mA 70 mA...
Product Manual - Page 26
...
to reduce power use.
02/07, Rev. 12.0
3-8
© 2007 SanDisk Corporation For example-"I1U" indicates a pull-up resistor leakage current meets the PCMCIA specification of 10k ohms but is expecting a word data transfer cycle.
3.3 Electrical Specification
All D.C. Interface Description
SanDisk CompactFlash Card OEM Product Manual
Table 3-4 Signal Description
Signal Name
Dir.
Product Manual - Page 29
... at the CompactFlash Memory Card.
SanDisk CompactFlash Card OEM Product Manual
Interface Description
Figure 3-2 Power Up/Power Down Timing for all types of memory.
Skews and delays from system RESET
VCC
-CE1, -CE2
Supplied by the system. trec
VIH
2V
3.3.4
Common Memory Read Timing Table 3-10 contains common memory read timing specifications for Systems not supporting RESET...
Product Manual - Page 30
... Rev. 12.0
3-12
© 2007 SanDisk Corporation Interface Description
SanDisk CompactFlash Card OEM Product Manual
Table 3-10 Common Memory Read Timing Specification
Speed Version Item Address Hold Time Card Enable Setup Time Card Enable Hold Time
Symbol th (A) tsu(CE) th (CE)
IEEE Symbol tGHAX tELGL tGHEH
a. All timings measured at the CompactFlash Memory Card. The -REG signal timing is...
Product Manual - Page 35
...SanDisk CompactFlash Memory cards do not assert an -IORDY
signal.
© 2007 SanDisk...SanDisk CompactFlash Card OEM Product Manual
Interface Description
Table 3-14 contains the specification information related to the I /O Write Timing Specification
Item Data Setup before -IOWR Data Hold following -IOWR -IOWR Width Time Address Setup before -IOWR Address Hold following -IOWR -CE Setup...supporting...
Product Manual - Page 38
... that are identified by appropriate information in the Card Information Structure (CIS). Interface Description
SanDisk CompactFlash Card OEM Product Manual
The PIO data transfer parameters are greater than the value reported in the devices IDENTIFY DEVICE data. A device imple mentation shall support any legal host implementation. data setup (min.) t4 IOWR- This means a host...
Product Manual - Page 51
... access to the command buffer and
registers and the host is used to control the CompactFlash Memory Card interrupt request and to issue an ATA soft reset to a 1. D2
CORR
Set when a correctable data error has been encountered and the data has
been corrected. This condition does not terminate a multi-sector read by the host...
Product Manual - Page 55
... requirements and the format of setting DRQ.
5.1 ATA Command Set
Table 5-1 summarizes the ATA command set with the supplied parameters, and then writing the command code to the Command Register. There are issued to CompactFlash Memory cards.
E1h or 95h -
-
-
- D
-
Table 5-1 Primary and Secondary I/O Decoding
Class 1 1 1
2 1 1 1 1 1 1 1 1 1 1 1 1
1 1
Command Check Power Mode...
Product Manual - Page 59
... Double-word not supported Capabilities: DMA Supported (bit 8), LBA supported (bit 9) Reserved
© 2007 SanDisk Corporation
5-5
Rev. 12.0, 02/07 SanDisk CompactFlash Card OEM Product Manual
ATA Command Description
5.1.5
Identify Device-ECH
The Identify Drive command enables the host to receive parameter information from a CompactFlash Memory Card.
Table 5-8 Identify Device...
Product Manual - Page 61
... the default translation mode. SanDisk CompactFlash Card OEM Product Manual
ATA Command Description
Table 5-8 Identify Device Information
Word Address
163
164
165-175 176-255
Default Value 00XXh
001Bh
0000h 0000h
Total Bytes 2
2
22 140
Data Field Type Information
CF Advanced True IDE Timing Mode Capability and Setting
CF Advanced PCMCIA I/O and Memory Timing Mode Capability
Reserved for...
Product Manual - Page 85
... 2 bytes First byte of JEDEC ID for SanDisk CompactFlash Memory cards. CHAPTER 6
CIS Description
This section describes the Card Information Structure (CIS) for SanDisk PC Card
ATA 12V
Second Byte of JEDEC ID
Manufacturer's ID Tuple Link is 4 bytes SanDisk JEDEC
Manufacturer's ID
Device ID, WPS, Speed Device Size End Marker Tuple Code
Link Length Byte 1,
JEDEC ID of...
SanDisk 8GB EXTREME Reviews
We have not received any reviews for SanDisk yet.