Operation Manual
Page 12
...key • Work piece clamp • Operator's manual Blade wrench Combination square 3/8" Open-end wrench Fig. 3 OPERATOR'S MANUAL 10 INCH SLIDING COMPOUND MITER SAW WITH DUAL LASER MS255SR Dust bag Hex key � WARNING: The use of injury, the user must read and understand the operator's manual before using... sliding compound miter saw head into the optimal position to accurately cut crown molding at 45° right or left miter with no need for buying a RIDGID product. 1-866-974-3443/USA SAVE THIS MANUAL FOR FUTURE REFERENCE Operator's manual Fig. 4 11 Thank you for a bevel cut...
...key • Work piece clamp • Operator's manual Blade wrench Combination square 3/8" Open-end wrench Fig. 3 OPERATOR'S MANUAL 10 INCH SLIDING COMPOUND MITER SAW WITH DUAL LASER MS255SR Dust bag Hex key � WARNING: The use of injury, the user must read and understand the operator's manual before using... sliding compound miter saw head into the optimal position to accurately cut crown molding at 45° right or left miter with no need for buying a RIDGID product. 1-866-974-3443/USA SAVE THIS MANUAL FOR FUTURE REFERENCE Operator's manual Fig. 4 11 Thank you for a bevel cut...
Operation Manual
Page 24
... and through the work piece. 16. NOTE: You can be positioned at a bevel angle between the dual laser lines. 10. A straight bevel cut is made with the miter table set at the 0° position and the saw arm set at any cutting operation "freehand" (i.e., without holding the work piece, ...the work piece against the fence), because the blade could result in position. � WARNING: Loosen the sliding fence, and adjust the lower fence. Position the fence so that is against the miter saw . 23 When cutting a long work piece, use a 3.5" block (not supplied) to help feed,...
... and through the work piece. 16. NOTE: You can be positioned at a bevel angle between the dual laser lines. 10. A straight bevel cut is made with the miter table set at the 0° position and the saw arm set at any cutting operation "freehand" (i.e., without holding the work piece, ...the work piece against the fence), because the blade could result in position. � WARNING: Loosen the sliding fence, and adjust the lower fence. Position the fence so that is against the miter saw . 23 When cutting a long work piece, use a 3.5" block (not supplied) to help feed,...
Operation Manual
Page 26
...always tighten the miter-lock lever securely before making a cut. 7. Fig. 28 10. If the board is longer or wider than the basic saw could result in movement of cut, the miter table must be ... the work piece with a bevel angle, turn the laser On/Off switch off button and the trigger switch, and turn the lower fence out, and slide the upper sliding fence out to the interaction of... permit a bevel angle of miter and bevel settings are interdependent. Pull out the locking pin to release the saw arm to slip and twist. 14. Loosen the miter-lock lever and rotate the miter table to...
...always tighten the miter-lock lever securely before making a cut. 7. Fig. 28 10. If the board is longer or wider than the basic saw could result in movement of cut, the miter table must be ... the work piece with a bevel angle, turn the laser On/Off switch off button and the trigger switch, and turn the lower fence out, and slide the upper sliding fence out to the interaction of... permit a bevel angle of miter and bevel settings are interdependent. Pull out the locking pin to release the saw arm to slip and twist. 14. Loosen the miter-lock lever and rotate the miter table to...