Pyle PT110 Support and Manuals
Get Help and Manuals for this Pyle item
Most Recent Pyle PT110 Questions
Pyle Pt110 No Output
I have a Pyle PT110 with no output. It turns on ok but does not amplify. Any ideas?
I have a Pyle PT110 with no output. It turns on ok but does not amplify. Any ideas?
(Posted by giffordtv 9 years ago)
Popular Pyle PT110 Manual Pages
PT110 Manual 1 - Page 2
...CONTROLS
FRONT PANEL - It contains a range of trouble-free service from this manual throughly before you need in a professional sound system. Please read this product. PT110/PT210
1 It can expect years of installation suggestions as well as instructions to set up and use the amplifier. INTRODUCTION
Your New PYLE PT110/PT210 PA AMPLIFIER gives you the power and versatility you attempt...
PT110 Manual 1 - Page 3
PHONO/AUX Allows you to select and connect an alternative high level (AUX/CD) or low level (PHONO) audio sound source. 6.Tone Control (PT110) Lets you adjust the sound frequency to the acoustics of a particular performance environment. 7.100 Hz, 1 kHz, & 8 kHz Equalizer Controls (PT210) To enhance the sound or ...
PT110 Manual 1 - Page 4
Please also replace the fuse with proper rating in this situation (see the SPECIFICATIONS for EUROPEAN operation. Input connections The PT110/PT210 accept a board range of your turntable's ground wire (usually black or green) to the amplifier's GND terminal, to avoid a low frequency hum. REAR PANEL -
You can connect a low level audio input source, such as a CD...
PT110 Manual 1 - Page 5
... cause this series configuration is used , connect the speaker (+) terminal to the amplifier's 4-Ohm, 8Ohm or 16-Ohm amplifier terminal.
However, before you to connect two microphones with , in order to ensure equal volume from each speaker has an impedance of proper gauge. Connecting a turntable
In this Situation, set the PHONO and AUX/CD SELECTOR switch to...
PT110 Manual 1 - Page 6
... 8-Ohm, the total speaker impedance in a PARALLEL hook up .
See the chart below for combining TWO
System 4:Four speakers in series/parallel SERIES PAIRS in this parellel configuration is 3.2 OHMS, so you have properly calculated the total impedance, and connect the (+) speaker circuit wire to the amplifier's 4-Ohm, 8-Ohm, or 16-Ohm terminal, depending on the...
PT110 Manual 1 - Page 7
...(not supplied) with the volume control set the POWER
System 5: Connecting speakers with transformers 1.Locate the input taps ...speaker to have a higher volume level,connect the wire from your vehicle's 12-volt battery. Locate on the transformer. Using headphones
To listen privately, or to the amplifier 70V RMS terminal. If you use does not exceed the amplifier's maximum power rating, PT110...
PT110 Manual 1 - Page 8
...Noise Level (Input Shorted 0.75mV Tone Control (PT110)
-15dB (High Cut at each end, ... that 6 feet.
Specifications
O...u..t.p..u..t...P..o..w...e..r..a..t..T..H..D....1..0. %, 1 kHz 20W (PT110)/40W (PT210)
M...a..x..i.m...u..m....P..o..w...e..r........... 80W (PT110)/120W (PT210)
THD... amplifier on
1.Turn on the audio input source equipment which is connected to the amplifier INPUT jack.
2.Set ...
Pyle PT110 Reviews
We have not received any reviews for Pyle yet.