Poulan PP291E30 Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PP291E30 manuals!
Problems with Poulan PP291E30?
Ask a Question
Free Poulan PP291E30 manuals!
Problems with Poulan PP291E30?
Ask a Question
Popular Poulan PP291E30 Manual Pages
User Manual - Page 1
Always Wear Eye Protection During Operation
435555 Rev 3 08.09.10 TH Printed in serious injury. IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PP291E30
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in U.S.A.
User Manual - Page 2
... (motor).
3. Caution should start to vibrate abnormally, stop the unit and disengage the controls quickly.
2. WARNING: Snow throwers have exposed rotating parts, which can get caught in the manual(s) before starting when setting up spilled fuel.
(h) If fuel is not possible, then refuel such equipment on slippery surfaces.
4. It means CAUTION!!! Training
1. Look...
User Manual - Page 3
... OF PURCHASE
THE MODEL AND SERIAL NUMBERS ...SPECIFICATIONS 3
SERVICE AND ADJUSTMENTS 16-18
CUSTOMER RESPONSIBILITIES 3
STORAGE 19
ASSEMBLY / PRE-OPERATION 5-7
TROUBLESHOOTING 20
OPERATION 8-13
REPAIR PARTS...problem you to clean out the discharge chute. We have stopped. Disengage power to operator's manual...service or repair this manual. Maintain or replace safety and instruction...
User Manual - Page 12
...hex nuts, then moving parts to stop.
2. ...an open flame. Replace a damaged or worn scraper bar.
Repeat for all moving skid plate to bottom of this manual. AUGER HOUSING
... can be reversed, providing additional service before storage of 30 days or longer. To avoid engine problems, the fuel system should be sure...Instructions for a few seconds, remove and read oil level.
FIG. 19
12
User Manual - Page 14
...replaced by original equipment manufacturer
NOTE: To seal tire punctures and prevent flat tires due
(OEM) belts available from the warranty, operator must maintain snow thrower as instructed in this manual should be sure they are of injury to
local parts dealer..."TO REMOVE BELT COVER" in the Service and Adjustments section of operation and replace if necessary.
Failure to do so ...
User Manual - Page 15
...the "PRODUCT SPECIFICATIONS" section of this manual.
9. Be sure to install klik pin... into proper hole in wheel axle (See "TO REMOVE WHEELS" in one year. Be careful not to allow dirt to your expected operating temperature. MUFFLER
Inspect and replace corroded muffler as it cannot come in the Service...Spark plug type and gap setting are shown in a ...
User Manual - Page 16
...replace the shear bolts:
1. Place wire where it should be replaced. Should a foreign object or ice become lodged in the OFF position.
2. CAUTION: Do not substitute. FRAME
16
BELT COVER FIG. 21
SCREWS
Disengage all moving parts to any service or adjustments:
1. Install...manual.
SERVICE AND ADJUSTMENTS
WARNING: To avoid serious injury, before performing any ...
User Manual - Page 17
... step 12. Tip swing plate forward.
7. NOTE: It is inside the groove of this manual.
4. Using other than OEM belts can cause personal injury or damage to the unit could occur...16. INSTALL ENGINE PULLEY - Tighten securely.
17. Wipe up on your snow thrower are of pulley.
13. REMOVE HAIRPIN FROM CLUTCH ROD and remove clutch rod from crankshaft.
5. SERVICE AND ADJUSTMENTS
TO REPLACE BELTS (...
User Manual - Page 18
...set for pushing or transporting the snow thrower), remove klik pin from the wheels (for proper engine speed. Adjust until cable is not adjustable. IMPORTANT: When installing wheel, be affected at altitudes up to a service...If your engine does not operate properly due to suspected carburetor problems, take your local parts dealer.
Grasp the long section tightly and turn buckle, located on...
User Manual - Page 19
... system parts such as shown in minimizing the formation of oil through spark plug hole into cylinder.
3. Always follow the mix ratio found on a furnace, water heater, clothes dryer or gas appliance. Replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual). store it in your gasoline will cause problems...
User Manual - Page 20
... TROUBLESHOOTING
See appropriate section in fuel.
1.
PROBLEM...manual. Throwing too much snow. 3. Dirty or clogged muffler.
1. Reconnect spark plug wire. 2.
Stale fuel. 4. Water in the Operation section of power
1. Contact an authorized service center/department.
Tighten all fasteners. Replace damaged parts. If vibration remains, contact an authorized service...
User Manual - Page 26
...15 AND 16 ARE SERVICE PART NUMBERS TO ALLOW PURCHASE OF INDIVIDUAL ITEMS IF NECESSARY. NOTE: All component dimensions given in U.S. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
26 REPAIR PARTS
SNOW THROWER - inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL PP291E30 (96198003001)
CONTROL...
User Manual - Page 27
... damage your snow thrower and void your warranty.
27 REPAIR PARTS
SNOW THROWER - inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. NOTE: All component dimensions given in U.S. ITEMS INDICATED WITH AN * ARE LISTED AS REFERENCE FOR SERVICE PARTS ONLY. MODEL PP291E30 (96198003001)
CONTROL PANEL / DISCHARGE CHUTE
2
2 *3
1 *7
*6
KEY NO...
User Manual - Page 29
... SUPPORT WELDMENT SCREW 5/16−18 X .750 SCREW 3/8−16 X 1.00
3
4 3
4 4
01-05-013-A
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
29 NO. REPAIR PARTS HANDLES
SNOW THROWER - MODEL PP291E30...
Parts List - Page 7
... ITEMS 15 AND 16 ARE SERVICE PART NUMBERS TO ALLOW PURCHASE OF INDIVIDUAL ITEMS IF NECESSARY. NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
26 MODEL PP291E30 (96198003001)
CONTROL PANEL / DISCHARGE...
Poulan PP291E30 Reviews
We have not received any reviews for Poulan yet.