Maytag MGDB855DW Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MGDB855DW manuals!
Problems with Maytag MGDB855DW?
Ask a Question
Free Maytag MGDB855DW manuals!
Problems with Maytag MGDB855DW?
Ask a Question
Popular Maytag MGDB855DW Manual Pages
Warranty Information - Page 1
... can be borne by Maytag.
8. call 1-800-807-6777. In the event of
product replacement, your product from natural gas or L.P.
In-home instruction on
the below named parts only and does not include repair labor. light bulbs, batteries, air or water filters, preservation solutions, etc.).
5. Defects or damage caused by unauthorized service, alteration, or modification of...
Use & Care Guide - Page 7
... retained for future drying with service voltage less than 1/4 full. Uses a stepped drying temperature from your dryer, use the Sensing cycles.
This setting can be retained for future drying with 3-4 items, not more than 240.
Use for each cycle.
For electric models, dryer performance and results may select the "With Steam" setting to tumble freely.
7
CYCLE GUIDE -
Use & Care Guide - Page 11
... of the dryer drum. The drying rack is running or paused. The drying rack cannot be adjusted to adapt to different installations, environmental conditions...support on the front of the drying rack. Place wet items on top of the drying rack with the holes in the
time display: 0, 1, 2, 3, or 4. 3. Open dryer door. Your sensor drying settings can change the drying settings: NOTE: The settings...
Use & Care Guide - Page 13
...all parts and panels before servicing. Disconnect wiring from
faucet; If storing or moving your inlet hose, record the date of use to locate, level, and connect the dryer.
13 Gas models only: Close shut-off valve in the
Installation Instructions. WARNING
SPECIAL INSTRUCTIONS FOR STEAM MODELS
Water Inlet Hose Replace inlet hose and hose screen after 5 years of replacement.
Gas models...
Use & Care Guide - Page 14
... sound should be louder and run
Door not closed completely. Dryer isn't properly leveled. See the Installation Instructions.
enough. Use a time-delay fuse. Separate the load items and restart the dryer.
Replace the fuses or reset the circuit breaker.
If the problem continues, call an electrician. The gas supply line valve not open .
Check the front and...
Use & Care Guide - Page 15
... settings enable
on the load to possibly avoid a service call. To remove odors left in the area where your garments.
Stains on load Stains on .
In Canada www.maytag.ca for reducing wrinkles and odors from dryer at www.maytag.com/product_help -
Then select the appropriate time based on all cycle/option combinations.
See the Installation Instructions...
Use & Care Guide - Page 16
... E1, etc.) variable service codes. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/product_help -
hold the START key to the Installation Instructions for assistance and to clear the PF error message; "L2" Diagnostic Code (low or no line voltage condition)
There may be a problem with a high temperature setting. In Canada www.maytag.ca for...
Use & Care Guide - Page 17
... is valid
only in this major appliance was
purchased. In-home instruction on the right to review the Troubleshooting or Problem Solver section of
original consumer purchase. house wiring, fuses, or water inlet hoses).
4. Travel or transportation expenses for appliances with servicing, removal, or replacement of household electrical or plumbing (i.e. The cost of the original...
Installation Guide - Page 5
... 6" (152 mm) clearance behind dryer for exhaust vent with dryer) Check local codes. You may cause dryer not to the "Assistance or Service" section in longer drying times.
Parts needed for electric dryers.
■■ If using the "Y" connector and short hose which are required. Some codes limit, or do not permit, installation of the dryer in the same closet...
Installation Guide - Page 6
... to the neutral conductor (white wire) within the dryer. If using and follow the instructions provided for (1) new branch-circuit installations, (2) mobile homes, (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductor is
recommended to the neutral wire, see "Assistance or Service" section in the neutral or grounding circuit.
■...
Installation Guide - Page 8
... of the gas connection to prevent kinking. GAS DRYER POWER HOOKUP U.S.A. A time-delay fuse or circuit breaker is acceptable for use with Natural gas.
SAVE THESE INSTRUCTIONS
8
GAS TYPE Natural Gas:
This dryer is located on the model/serial rating plate for electric current. Burner information is equipped for lengths under 20 ft. (6.1 m) if local codes and gas supplier permit...
Installation Guide - Page 9
... to its back, use Gas dryers must be installed in elevation.
IMPORTANT: If laying dryer on the model/serial number plate is recommended that complies with to the gas supply line with the B149.1, Natural Gas and Propane
Installation Code.
Slide the dryer until bottom of the dryer in leveling legs
Gas supply pressure testing
■■ The dryer must be connected to...
Installation Guide - Page 21
... from turning on. See "Troubleshooting." Complete Installation CHECKLIST q Check that all parts are set in a running or "On" position.
• Start button has been pushed firmly.
• Dryer is plugged into a grounded outlet. q Dispose of/recycle all of a water softener is first heated. q Check dryer's final location. q Check that gas supply is not crushed
or kinked.
q Check...
Dimension Guide - Page 1
...
openings in the top and bottom of the dryer is
recommended to reduce noise transfer. ■■ For closet installation, with elbow. See "Venting Requirements." Side view
561/4" (1428 mm)
3213/16" (821 mm)
Door Opened Door Closed
4213/16" (1987 mm)
Gas and Electric Dryer
PRODUCT MODEL NUMBERS MEDB835D, MEDB855D, MGDB835D, MGDB855D
Back view...
Dimension Guide - Page 2
...;■ Reduce performance, resulting in the path of the exhaust.
When acceptable to the gas supplier and local codes, 3/8" approved tubing may be used . An individual manual shutoff valve must be installed within 6 ft (1.8 m) of the dryer in Vent System Chart.
Rigid or flexible metal exhaust vent must be used . NOTE: Do not use vent...
Maytag MGDB855DW Reviews
We have not received any reviews for Maytag yet.