Maytag MGD6230 Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MGD6230 manuals!
Problems with Maytag MGD6230?
Ask a Question
Free Maytag MGD6230 manuals!
Problems with Maytag MGD6230?
Ask a Question
Popular Maytag MGD6230 Manual Pages
Dimension Guide - Page 1
ft. Electric MGD6230RHW - Gas
41 1∕4" Height
W11412671B
29 7∕8" Depth
27" Width White Available MED6230RHW - Dimension Guide
Maytag® Dryer with Extra Power and Advanced Moisture Sensing - 7.4 cu.
Owners Manual 1 - Page 2
..." or "WARNING."
The dryer must conform with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part 1, CSA C22.1.
2 Always read and obey all safety messages.
All safety messages will follow instructions. We have provided many important safety messages in this manual and on your...
Owners Manual 1 - Page 4
... 4 ft. (1.22 m) long. Read and follow the instructions provided with upturned ends.
■ A UL listed strain relief
Parts needed (steam models):
Caulking gun and compound (for installing new exhaust vent)
"Y" connector
Short inlet hose
Rubber washer (4)
Tin snips (new vent installations)
#2 Phillips screwdriver
Tape measure 4
1/4" nut driver (recommended)
Wire stripper (direct wire...
Owners Manual 1 - Page 5
.... The installation must support dryer weight of the dryer in death, explosion, or fire. Mobile home installations require: All dryers:
■ Metal exhaust system hardware, available for Mobile home construction and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 MH. For further information, see "Assistance or Service" section in "Parts needed for mobile home installations. For...
Owners Manual 1 - Page 8
...dryer.
In Canada:
An individual manual shut-off valve must be disconnected from the gas specified on the model/serial number plate is acceptable for
lengths under 20 ft. (6.1 m) if local codes and gas supplier permit. ■ If you are using Natural gas, do so can be installed... Service" section of Chemours. If this information does not agree with the National Fuel Gas Code,...
Owners Manual 1 - Page 15
... on an approved noncorrosive leak-detection solution. If flexible metal tubing is used to connect dryer to supply line type, size, and location.
3. Install a shut-off valve
Closed valvAe
1. Bubbles will show a leak.
Do not use pipe-joint...action of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. U.S.A.
Owners Manual 1 - Page 16
...m).
■ The length of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
Failure to follow these instructions can be fully extended and supported in final dryer location.
■ Remove excess to avoid crushing ...■ Do not install in death or fire. Replace plastic or metal foil vents with lint. Recommended Styles:
Fire Hazard Use a heavy metal vent. Dryer exhaust must not be...
Owners Manual 1 - Page 18
...Avoid 90° turns. CONNECT INLET HOSES
For non-steam models, skip to exhaust hood
3. Do not use caulking compound ...result. Turn cold water faucet off , remove and
replace rubber washer
Attach dryer 5 ft (1.5 m) inlet hose ends to secure ...dryer must fit over the exhaust hood. Using pliers, tighten the couplings an additional two-thirds turn . INSTALL VENT SYSTEM
1. Secure vent to dryer...
Owners Manual 1 - Page 21
... supply is not turning on .
q Read "Dryer Use" in your "Quick Reference Guide."
q If you have power supply problem in your house. If dryer will not start, check the following:
• Controls are on console and any dust.
The odor will receive L2 code for certain part replacement or repair. Close the dryer door as far as the door...
Owners Manual 1 - Page 22
... door. Install 2 plastic plugs (A) into screw holes where the hinges were removed in Step 4. You can change your door swing from the dryer door opening .
22 Set the hinge screws off the cabinet. Door strike B.
A B
A B
A B
3. A. NOTE: Door strike and plugs must be on top of dryer or work space to the side for models with...
Owners Manual 1 - Page 27
...Replace the cover and secure with a 10 W appliance bulb only.
See Installation Instructions. CHECK YOUR VENT SYSTEM FOR GOOD AIR FLOW
GOOD AIR FLOW (CONTD.)
Service calls caused by improper venting are not covered by the customer, regardless of the dryer...THE DRUM LIGHT (ON SOME MODELS)
1. Proper venting will reduce your drying times and improve your dryer for final product check.
■...
Quick Reference Manual - Page 2
... you want to pause it will show the cycle settings and estimated time remaining.
TEMP
Touch to select desired cycle.
Wrinkle Prevent with steam (select models). DRUM LIGHT
Touch to operate even when check vent notification is a feature available for the dryer's life.
Follow the instructions in display.
4 START/PAUSE Touch and hold CYCLE...
Quick Reference Manual - Page 3
...problems or questions, call Maytag® Connected Appliances at www.maytag.com/connect or in order to allow remote control and interaction.
Failure to follow these instructions ..."Cycle Guide" for more information about cycles, settings, and options.
Once installed, launch the app and you want to Factory settings then perform Factory Reset.
USING YOUR DRYER
WARNING
WARNING...
Quick Reference Manual - Page 5
MANUAL CYCLES
TIMED...load, select the lower setting rather than 1/4 full.
Large load: Fill the dryer drum up to about 1/2 full. Models 7230 & 8230
NOTE: These clothes dryer's Government energy certifications were... . Select a drying temperature based on all models. Not all cycles and options are unsure of 3-4 items.
CYCLE GUIDE - Load Size Recommendations
For best results, follow...
Quick Reference Manual - Page 6
... High Off On Off
ASSISTANCE OR SERVICE AND ADDITIONAL INFORMATION
For detailed installation instructions and maintenance information, winter storage and transportation, please see the DIMENSION GUIDE that can write with your correspondence.
6 REGISTER PRODUCT
SCHEDULE SERVICE
TROUBLESHOOTING
MANUALS & DOWNLOADS
ADD SERVICE PLAN
PARTS
ACCESSORIES
Model & Serial Number Tag location
To...
Maytag MGD6230 Reviews
We have not received any reviews for Maytag yet.