Installation Instructions
Page 13
... use plastic or metal foil vent. IMPORTANT: Observe all joints. ■■ Exhaust vent must not be fully extended and supported in final dryer location. ■■ Remove excess to achieve best drying performance. NOTE: If using an existing vent system, clean lint from ground or any... ■■ Only a 4" (102 mm) heavy metal exhaust vent and clamps may be used . ■■ Do not use duct tape. Review "Vent System Chart" and, if necessary, modify existing vent system to avoid sagging and kinking that may result in reduced airflow and poor performance. ■...
... use plastic or metal foil vent. IMPORTANT: Observe all joints. ■■ Exhaust vent must not be fully extended and supported in final dryer location. ■■ Remove excess to achieve best drying performance. NOTE: If using an existing vent system, clean lint from ground or any... ■■ Only a 4" (102 mm) heavy metal exhaust vent and clamps may be used . ■■ Do not use duct tape. Review "Vent System Chart" and, if necessary, modify existing vent system to avoid sagging and kinking that may result in reduced airflow and poor performance. ■...