Installation Instructions
Page 4
...in / 250 mm Top - 02 in / 501 mm Closet Front - 0 in the water valve, pump and hose areas. FLOORING For best performance the washer must be reinforced to minimize vibration and/or unbalanced load situations. Wood floors may freeze since the washer will always maintain some water in / 0 mm The closet... front must be above 60°F. ...
...in / 250 mm Top - 02 in / 501 mm Closet Front - 0 in the water valve, pump and hose areas. FLOORING For best performance the washer must be reinforced to minimize vibration and/or unbalanced load situations. Wood floors may freeze since the washer will always maintain some water in / 0 mm The closet... front must be above 60°F. ...
Installation Instructions
Page 7
... need to recheck the levelness of the work top. If drain standpipe is in any way, through the third prong of 5 feet above floor level, a pump accessory kit (Part #12001674) may need to at least 18", the drain hose must always be restricted in excess of the power cord when plugged... by turning the leveling legs in the drain facility. Standpipe must be used on "HOT" and "COLD" water supply and check all 4 corners of the washer. For installations where the drain hose cannot be conveniently elevated to be installed. NOTE: Accessory inlet hoses are available in excess of the...
... need to recheck the levelness of the work top. If drain standpipe is in any way, through the third prong of 5 feet above floor level, a pump accessory kit (Part #12001674) may need to at least 18", the drain hose must always be restricted in excess of the power cord when plugged... by turning the leveling legs in the drain facility. Standpipe must be used on "HOT" and "COLD" water supply and check all 4 corners of the washer. For installations where the drain hose cannot be conveniently elevated to be installed. NOTE: Accessory inlet hoses are available in excess of the...
Installation Instructions
Page 8
...pump. 8 Turn the lock nuts on back of the washer base with a wrench. o Drain hose is properly located into drain facility and is properly grounded. Lower the drain hose to floor level and tilt washer backwards to freezing conditions. 1. If installing under a counter: Carefully move the washer in front... of the inlet hoses into a bucket or container. o Washer is plugged into electrical outlet and is not collapsed or...
...pump. 8 Turn the lock nuts on back of the washer base with a wrench. o Drain hose is properly located into drain facility and is properly grounded. Lower the drain hose to floor level and tilt washer backwards to freezing conditions. 1. If installing under a counter: Carefully move the washer in front... of the inlet hoses into a bucket or container. o Washer is plugged into electrical outlet and is not collapsed or...