Maytag MAH2400AWW Support Question
Maytag MAH2400AWW Support Question
Find answers below for this question about Maytag MAH2400AWW - 2.4 cu. Ft. Compact Front Load Washer.Need a Maytag MAH2400AWW manual? We have 3 online manuals for this item!
Question posted by mrfrench0401 on June 16th, 2021
Witch Hose Go's Where On The Water Pump
water pump what hose gos where to drain the water
Requests for more information
Request from JohnB433 on June 16th, 2021 7:17 PM
more information please
more information please
Current Answers
Answer #1: Posted by SonuKumar on June 16th, 2021 6:54 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,609,800
Member since:
May 9th, 2021 Points: 16,609,800
https://www.searspartsdirect.com/manual/39cibsgpsn-003048/maytag-mah2400aww-washer-parts
Does it matter which hose goes where on a washer?
When connecting the inlet hoses to your shut-off valves and the washer, make sure you connect the hot and cold water hoses properly. Traditionally, the home hot water shut-off if on the left and is marked red, while the cold water shut-off is typically on the right and is marked blue.
How do you keep a washing machine drain hose in place?
Loop the bent end of the hose over the lip of the sink, which should not be more than 45 inches away from the washing machine. Secure the hose to the leg of the laundry sink using a plastic cable strap. Make sure that the hose end is not touching the bottom of the sink, which could restrict the flow of water.
Do Maytag washers come with hoses?
Can't believe Maytag skimped on this! Yes it does but not water hoses. No, the hoses are not included. Yes, it does
How much does it cost to tighten washer hoses?
When connecting the hoses to the supply valves and to the washer DO NOT over tighten. You are only trying to compress the little rubber washer in the end of the hose to make a good seal. Snug is good (if one of the hoses leak you can tighten them a bit to stop the leak).
Can a washing machine drain hose run along the floor?
Yes, the drain hose needs to be elevated and it's always best to do so at a level that's higher than the washing machine itself. This will prevent possible siphoning. There are also other steps you can take to ensure that you get the best drainage.
https://www.youtube.com/watch?v=qeO0_dfJBDk
https://www.youtube.com/watch?v=G8ixA5lJfZw
https://www.youtube.com/watch?v=G8ixA5lJfZw&t=33s
https://www.youtube.com/watch?v=G8ixA5lJfZw&t=91s
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Maytag MAH2400AWW Manual Pages
Owners Manual - Page 1
... Safety Instructions 1-2
Operating Instructions 3
Load the Clothes Washer Start the Washer Water Use
Using the Controls 4-6
Turn the Washer On Select the Cycle Select Wash/Rinse...Compartment
Care & Cleaning 9-10
Cleaning the Interior Cleaning the Automatic Dispenser Storing the Washer
Troubleshooting 11-13
Information Codes
Operating Sounds 14
Service & Warranty 15
Guide d'utilisation...
Owners Manual - Page 2
... To avoid the possibility of these substances.
HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been used a cleaning solvent, or which you do not understand.
Recognize...information, see page 15. These substances give off vapors that may occur.
Always contact your washer, follow basic safety precautions, including the following:
1. Hazards or unsafe practices which is ...
Owners Manual - Page 3
... combination washer-dryer, turn on all hot water faucets and let the water flow from service or discarded, remove the door to carry out.
12. Do not reach into the appliance if the tumbler is used near children.
10. Close supervision of the clothes washer.
18. Store laundry aids and other material in following loads and...
Owners Manual - Page 4
... is off. Fill time will vary with dry, unfolded clothes. Load the washer loosely - Load the Clothes Washer
• The tub can be added for improved tumbling and spin performance.
• When...the cycle and stops
the washer. • The Wash, Rinse and Spin indicator lights will go out, add the item, close the door and press Start/Pause. Press any water remaining in the cycle. ...
Owners Manual - Page 5
...sturdy, colorfast fabrics and heavily soiled garments.
• Normal -
To drain water from tub without starting the washer, the power automatically turns off . For lightly soiled or wrinkled garments ...loads, select the Wrinkle Control cycle.
4 Press the Power Off pad to turn the washer off .
Using the Controls Controlst aa glance
STEP 1 Dryer Exhaust tips
Turn the Washer...
Owners Manual - Page 6
...This setting will be warm. The other rinses will be appropriate for the load. Brightly colored, very lightly soiled items; Medium - Drains the washer without spinning. Whites and heavily soiled color-fast items. ATC Warm/Warm ...the temperature will illuminate. REMEMBER: In wash water temperatures below 60˚ F, detergents do not dissolve well or clean well. Use for...
Owners Manual - Page 8
... attentiondtioshtwhaeshseorilusleevel of the load, load size, and water hardness**. Slide the dispenser drawer carefully and completely back into the detergent compartment before starting the washer.
2. Pour the...When adding color-safe bleach with laundry additives, being careful not to overfill or spill additives.
3. Features Special Fteuares
Your Maytag washer is designed to use a high...
Owners Manual - Page 9
...the tub at the proper time during the rinse cycle. It is not recommended with warm water until it reaches the MAX FILL line on the compartment. 3. Notes • Use ... should be diluted with
this washer. Avoid splWahsahtincagn o&r coavnenero-tfiblling the compartmwaeshnetd.
3. For smaller loads, use color-safe non-chlorine bleach, add it reaches the wash load. operatnig tips
4. It will...
Owners Manual - Page 10
... the use abrasive powders or cleaning pads.
clean with bleach solution and a soft cloth. Wipe the door seal with soap and water. Run the washer through your washer interior. clean with chlorine bleach.
4. Do not spray cleaners directly on factors such as
Clean the following steps
Use a soft cloth to wipe up all...
Owners Manual - Page 11
... release lever on long-term storage or storage of the parts under running water. 4. Run a Rinse & Spin cycle without a load.
• Turn the water faucets off and disconnect the inlet hoses.
• Disconnect the clothes washer from the electrical supply and leave the washer door open to let air circulate inside the tumbler.
• If the...
Owners Manual - Page 12
... unlock. Call for service, see below . Make sure the door is not draining. OR Unplug the washer for kinked hoses. Make sure the water faucets are open when washeNorteiss running properly. Call for service, see below .
Press Power Off pad then restart the cycle.
The washer is firmly closed.
Call for service, see below . er...
Owners Manual - Page 13
.... er
No water or insufficient
• Turn both faucets on .
• Make sure to press the Start/Pause pad. Washer vibrates or is too noisy • Make sure the washer is turned on fully. See Installation Instructions.
• Make sure the washer is not touching any other object.
• Make sure the laundry load is not...
Owners Manual - Page 14
.../Pause pad.
The washer does not drain and/or spin
Load is a drain restriction,
call for the door lock mechanism to disengage. Eliminate kinked hoses. For further assistance,...water temperature.
It should be plugged.
• As the washer is correct.
• Make sure hoses are selected.
Very small loads (one or two items) may notice just hot and/or just cold water going...
Owners Manual - Page 15
... to remove moisture from the dispenser area.
• Detergent is needed.
• Water flows through the drain holes in and out of the tub to redistribute the load more water during the third rinse while the washer is hitting the outer tub before draining out of the cycle.
Fabric softener is dispensed during the wash cycle...
Owners Manual - Page 16
... electric current, voltage, electrical and/or gas supply. Instruct the user on owner's responsibilities for product service in loading normal home use will be readily determined. manufacturer or an authorized servicer. Light
bulbs,
water
filters
and
air
filters. WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS, WHICH...
Installation Instructions - Page 2
... of 34 1\8".
2
Depth - WATER
Washer needs two standard 3/4 inch water supply faucets with a pressure between 20-120 pounds per square inch. Overall* B. Tools needed for installation:
• Multi wrench • Utility knife • Channel lock • Level
PARTS supplied for installation: Cable tie to secure drain hose to standpipe, inlet hose or laundry tub
ELECTRICAL
Refer to...
Installation Instructions - Page 3
... responsibility and obligation of the appliance owner to a grounded COLD metal water pipe.
Or may not allow and result in the washer turning off completely. The water valve Hot and Cold water faucets must be within 4 feet of the back of the washer for inlet hoses provided with a qualified electrician or serviceman if you are available...
Installation Instructions - Page 4
... a solidly constructed floor. To Avoid The Possibility Of Water Damage:
• Have Water Faucets Easily Accessible • Turn Off Faucets When Washer Is Not In Use. Operating temperature should be large enough to belts, pump, hoses and other components. DRAIN FACILITY
Recommended height of the drain hose. This can cause damage to accept the outside diameter of the...
Installation Instructions - Page 7
...drain hose should be at least 18" high. NOTE: Accessory inlet hoses are available in the drain facility. NOTE: The washer must always be leveled on all 4 sides. Place the drain hose in various lengths up against the base of 5 feet above floor level, a pump... drain hose must be used on "HOT" and "COLD" water supply and check all 4 corners of 10 feet above floor level, a drain hose ...
Installation Instructions - Page 8
... with a wrench. Turn off the water supply, then remove the inlet hoses from electrical supply. 4. The farther out the legs are connected to empty the inlet hoses. 3. o Washer has been properly leveled. COLD WEATHER STORAGE
The following precautions should exist). o Shipping bolts and spacers have been removed from the drain hose and
pump.
8
Adjust the rear leveling...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Not draining, not spinning out water, wet loads - Neptune® front-load washer
... electrical source or call an electrician. Front-load washer What happens if I find them by the cycle that is selected. Your washer is designed so that in the load at a reduced spin speed, which will not be able to adequately pump the water out of the drain hose more items to protect the delicate... -
Washer continues to fill or continues to drain - Top-load washer
...) and the water will start to gravity. Top-load washer Washer continues to fill or continues to drain. The drain hose may be a gap between the drain hose and the drainpipe to allow air to drain out of the drainpipe covered in Corners Do not seal the drain hose into the drainpipe or laundry tub. Make sure that the drain hose does not extend... -
Sounds during drain - Top-load HE washer with Dispenser Drawer - sound clips
... the rear of the washer cabinet. Secure the hoses using the beaded strap supplied with a periodic gurgling or surging sound. The drain portion of the water and then pump air. This is normal. During drain, the washer pump will continuously run to remove the water released from the load. Due to this...
Similar Questions
Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer
Is there any recall info for Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer?
Is there any recall info for Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer?
(Posted by hhppjj 10 years ago)
Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer.
The washer makes extremely loud noise during spinning. Do you know what's going on?
The washer makes extremely loud noise during spinning. Do you know what's going on?
(Posted by hhppjj 10 years ago)
I Changed My Water Pump The Wash Cycle Wont Come On
i changed the water pump on my maytag washer a mah2400aww it dont leak no more but the wash cycle wo...
i changed the water pump on my maytag washer a mah2400aww it dont leak no more but the wash cycle wo...
(Posted by kendebbie1984 12 years ago)