Husqvarna YTA18542 Support and Manuals
Get Help and Manuals for this Husqvarna item
View All Support Options Below
Free Husqvarna YTA18542 manuals!
Problems with Husqvarna YTA18542?
Ask a Question
Free Husqvarna YTA18542 manuals!
Problems with Husqvarna YTA18542?
Ask a Question
Most Recent Husqvarna YTA18542 Questions
Start And Stop
my motor start and stop right away it was running well and stop while I was cutting grass.I change t...
my motor start and stop right away it was running well and stop while I was cutting grass.I change t...
(Posted by Danmeilleur 1 year ago)
Husqvarna YTA18542 Videos
Husqvarna YTA18542 Ride On Mower
Duration: 1:25
Total Views: 1,267
Duration: 1:25
Total Views: 1,267
Husqvarna YTA18542 Mower Deck Rebuild pt2
Duration: 17:48
Total Views: 1,360
Duration: 17:48
Total Views: 1,360
Husqvarna mower- PLASTIC transmission .YTA18542 model
Duration: 2:58
Total Views: 42,585
Duration: 2:58
Total Views: 42,585
Husqvarna YTA18542
Duration: 8:51
Total Views: 2,491
Duration: 8:51
Total Views: 2,491
Popular Husqvarna YTA18542 Manual Pages
Operation Manual - Page 4
... to assemble and maintain your purchase of a new tractor. CCA: Case Size:
28 230 U1R
45-55 FT. Always observe the "SAFETY RULES".
The instructions will enable you the best possible dependability and performance. PRODUCT SPECIFICATIONS
Gasoline Capacity and type: Oil Type: (API: SG-SL) Oil Capacity:
Spark Plug:
Charging System:
Battery:
Blade Bolt Torque:
3.0 Gallons (11,35 L) Unleaded...
Operation Manual - Page 5
...; Lower seat pan or hood. BEFORE REMOVING TRACTOR FROM SKID
CONNECT BATTERY (See Fig. 1)
WARNING: Do not short battery terminals by allowing a wrench or any additional loose parts or cartons and remove.
NOTE: For battery installation see "REPLACING BATTERY" in the Service and Adjustments section in this manual, it means when you to press clutch/brake...
Operation Manual - Page 6
... holding the deflector shield up against tractor. Ensure tractor is operating properly.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly inflated for replacing motion and mower blade drive belts in the Operation section of this manual.)
6
Ensure they are shown for leveling.)
✓ Check mower and drive belts. ASSEMBLY
NOTE: You may now roll...
Operation Manual - Page 12
... and try again. To avoid engine problems, the fuel system should change oil for additional information.
Use fresh, clean, regular gasoline with the throttle control in the choke position until "FULL" mark on stabilizer container. OPERATION
BEFORE STARTING THE ENGINE
CHECK ENGINE OIL LEVEL
The engine in your tractor has been shipped from the factory...
Operation Manual - Page 14
... and ROS systems for proper operation.
• Check for Loose Fasteners A Check/Replace Mower Blades C Lubrication Chart T Check Battery Level O Clean Battery and Terminals R Clean Debris off Steering Plate
Check Mower Levelness
Check V-Belts
Check Engine Oil Level
Change Engine Oil (models with maintenance-free battery.
1, 2 2
2 5 - Some adjustments will need to be made periodically...
Operation Manual - Page 15
... speed in highest gear on mandrel assembly.
• Install and tighten blade bolt securely (45-55 Ft.
Using a blade not approved by the manufacturer of electrolyte is running with grease or petroleum jelly. NOTE: Protect your tractor does not function as described, repair the problem immediately. BRAKE OPERATION
If tractor requires more than five (5) feet (1,5 m) to slow...
Operation Manual - Page 16
... tube securely when finished.
16 MAINTENANCE
V-BELTS
Check V-belts for checking level. All oil must meet API service classification SG-SL. • Be sure tractor is not required for 50 hours in increased oil consumption when used for the life of operation and replace if necessary. Check the crankcase oil level before oil change.
OIL DRAIN VALVE
CLOSED AND LOCKED POSITION
YELLOW...
Operation Manual - Page 17
...Place new fuel filter in position in "PRODUCT SPECIFICATIONS" section of dirt and chaff to clean the outside tractor and mower. NOTE: Operating the engine with arrow
pointing ...oil change if the tractor is used more often under dusty conditions.
Service air cleaner more than 100 hours in engine or transmission will not run properly using a dirty air filter.
of this manual...
Operation Manual - Page 18
.... 21)
Your tractor's deck is equipped with a washout port as part of your house, garage, parked cars, etc.
Ensure no children are in the Fast " " position. Remain in the "DISENGAGED" position, set the parking brake, and stop the engine.
3. Place the attachment clutch control in mower with the cutting deck engaged until the deck is clear.
WARNING...
Operation Manual - Page 21
... your lawn and lead you to highest position. • Position any blade so the tip is in Visual Adjustment instructions above. A
A
Fig. 29
TIGHTEN ADJUST NUT "B" TO RAISE MOWER
LOOSEN ADJUST NUT "B" TO
LOWER MOWER
LOOSEN JAM NUT "A" FIRST
Fig. 31
NOTE: Each full turn of mower is not adjusted properly. SERVICE AND ADJUSTMENTS
TO LEVEL MOWER
Ensure...
Operation Manual - Page 22
... belt from tractor. Install mower. (See "TO INSTALL MOWER" section in this manual.)
E
F
A B D
G C
Fig. 33
22
Remove mower. (See "TO REMOVE MOWER" section
in this manual.)
NOTE: Observe entire motion drive belt and position of manual). Remove belt from centerspan idler (C).
4. Make sure belt is a belt installation guide decal on level surface. Contact a qualified service...
Operation Manual - Page 23
... RED cable to the POSITIVE
(+) terminal of each battery(A-B), taking care not to short against tractor chassis. • Connect one end of the BLACK cable to negative (-) battery
terminal with terminals in or camber, contact a qualified service center. REPLACING BATTERY (See Fig. 36)
WARNING: Do not short battery terminals by allowing a wrench or...
Operation Manual - Page 25
...stabilizer container. Store in a clean, dry area.
• Clean entire tractor. (See "CLEANING" in the Maintenance section of this manual.)
• Inspect and replace belts, if necessary. (See belt replacement instructions in the Service and Adjustments section of this manual.
• Be sure that does not retain moisture. Replace if necessary.
• Touch up all rusted or chipped paint...
Operation Manual - Page 26
...of mower housing.
4. Contact an authorized service center/department. TROUBLESHOOTING
PROBLEM Will not start
1. Dirty air filter. 6. Depress brake pedal. 2. Contact an authorized service center/department. Check all wiring. 7. Clean underside of adjustment.
14. Dirty air filter.
4. Loose or damaged wiring.
13. Excessive vibration
1. Replace damaged parts.
26...
Operation Manual - Page 27
...Reverse operation system (ROS) is engaged. Turn ignition key to slower speed.
3. TROUBLESHOOTING
PROBLEM
CAUSE
Engine continues to run when operator leaves seat with blades listed in parts manual.
11. Replace blade. Worn/damaged mower drive belt. 3. Operation section.
27 Improper blades used.
10. Clogged mower deck vent holes from
buildup of grass, leaves, trash under...
Husqvarna YTA18542 Reviews
We have not received any reviews for Husqvarna yet.